Catalog Number Notes Type FEATURES & SPECIFICATIONS INTENDED USE SpeciŢ cation grade emergency ballast to operate one or two lamps (4' or shorter) or one 8' lamp. Factory or Ţ eld installed inside or outside (Ţ eld only) ţ uorescent Ţ xture to operate lamp(s) at a reduced light output, providing optimum glare-free illumination for a minimum of 90 minutes upon interruption of normal power. CONSTRUCTION Fluorescent Battery Packs Black, 20-gauge steel, permanently-sealed housing. Housing provides extra room for wire routing in ballast channel. Dual-voltage input capability (120V or 277V). Polarized quick-connect pilot light/test switch assembly simpliŢ es installation. PS1400 DW Patent pending integrated test switch pilot light that requires only one-hole drilling. U.S. Patent No. 6,522,147. Operates one or two 2' – 4' ţ uorescent T8 – T12 lamps, one 2' – 4' ţ uorescent HO, VHO, long compact (biax) or one 6' – 8' ţ uorescent (T8 –T12) for 90 minutes. Compat- ible with electronic, rapid start, instant start, slimline, preheat or trigger start ballast in standard or energy-saving conŢ gurations. Unit wires two ways: on night light circuit (permanently energized) or on switch- able circuit (unswitched circuit to battery pack and switched circuit to Ţ xture ballast). Unit will strike normally off lamp. ELECTRICAL Constant-current series resistor-type charger. Capacitive input circuit provides high efŢ ciency and reliable operation. High-efŢ ciency push-pull inverter is the most effective method of converting DC power to AC power. It provides maximum light output, battery life and reliability. Battery: Sealed, maintenance-free, high-temperature nickel-cadmium battery. Ensures long life over a wide range of temperatures. 24-hour battery recharge after 90-minute discharge. Fully charged after 72 hours. External battery connectors allows battery pack to be disabled for maintenance and installation. Pilot light and test switch provide visual and manual means of monitoring system operation. LISTING INSTALLATION UL listed. Damp location listed. Meets UL 924, NFPA 101 (current Life Safety Mounts concealed within Ţ xture wireway for clean appearance and protection Code), NEC and OSHA illumination standards. against vandalism; or mounts on outside of Ţ xture housing if internal space is UL approved for installation in sealed and gasketed Ţ xtures. UL approved for limited. Two ½" holes in Ţ xture channel permit mounting of test switch/pilot light installation in wet and damp location listed Ţ xtures, 0-50°C (32-122°F). (Note: DW behind Ţ xture lens. option does not make the battery pack suitable for mounting outside the Ţ xture External mounting requires two accessory kits ELA PSMK or factory option MK. in a wet location application.) Kit adds 6" maximum to overall length. WARRANTY Unique size (13-5/16" L x 2-3/8" W x 1-5/8" H) Ţ ts a variety of ţ uorescent troffers, Five-year warranty. industrials, commercials and strips. Lead times will vary depending on options selected. Consult with your sales representative. ORDERING INFORMATION Example: PS1400 DW SD PS1400 DW Accessories* Series Application Options Order as separate item. MK External mounting kit PS1400 Battery pack DW Damp/wet loca- ELA TSPLP Remote or replacement test switch pilot light; tion 120V 50Hz 120V, 50Hz input mounts up to 25' away from Ţ xture 220V 50Hz 220 or 240V, 50Hz input ELA TSPLPSD Remote or replacement test switch pilot light 240V 60Hz 240V, 60Hz input for self-diagnostics; mounts up to 25' away from Ţ xture 1 SD Self-diagnostics ELA PSMK External mounting kit; two required ELA PSMKSD External mounting kit for self-diagnostics module ELA PSRME Remote mounting enclosure PSSD Field-installable self-diagnostics module ELA PSPRSB Field-installable interface for enhanced compat- 2 ibility with lamp EOL protection ballast NOTE: 1 Self-diagnostics (PSSD) module ships with ţ uorescent battery pack. See PSSD Inverter Accessories * See Accessories speciŢ cation sheets for details on other compatible devices speciŢ cation sheet for details on self-diagnostics module. ELA-RTS-TSPLP-PSTS-PSPRSB and ELA-PSMK-PSMKSD-PSDMT-PSRME. 2 ELA PSPRSB accessory not required with self-diagnostics option (SD). Emergency Sheet #: PS1400 DW PSBP-170 PS1400 Fluorescent Battery Packs SPECIFICATIONS MOUNTING All dimensions are inches (millimeters). BATTERY Sealed Nickel-Cadmium 3 6.0 3 years 7-9 years none 32–100°F Notes: 1 At 77°F. 2 Optimum ambient temperature range where unit will provide capacity for 90 minutes. 1-5/8 Higher and lower temperatures affect life and capacity. Consult factory for detailed o o (40) information. Damp location models are UL listed 0-50 C (32-122 F). 3 All life safety equipment, including emergency lighting for path of egress must be main- tained, serviced, and tested in accordance with all National Fire Protection Association (NFPA) and local codes. Failure to perform the required maintenance, service, or testing could jeopardize the safety of occupants and will void all warranties. 2-3/8 ELECTRICAL (60) Maximum AC input Volts Amps Watts Cross section end view 120 .27 3.3 Length: 13-5/16 (338mm) 277 .25 3.2 Shipping weight: 4 lbs. (2.3 kgs.) LAMP COMPATIBILITY Lamp Type Wattage Emergency Operation 24" - 48" T5 14 – 28 24" - 48" T5HO 24 – 54 U-Lamp T8 16 – 31 24" – 48" T8 17 – 32 60" – 96" T8 40 – 59 Circline T9 20 – 40 U-Lamp T12 34 – 40 24" – 48" T12 20 – 40 60" – 96" T12 50 – 75 24" – 48" HO T12 35 – 60 60" – 96" HO T12 70 – 110 24" – 48" VHO T12 74 – 115 60" – 96" VHO T12 135 – 215 Twin-Tube (4-pin) 9 – 13 Quad-Tube (4-pin) 13 – 26 Twin-Tube (4-pin) 18 – 55 Triple-Tube (4-pin) 18 – 32 Triple -Tube (4-pin) 42 2D 28-38 One-lamp emergency operation for 1 – 4 lamp ballasts. Two-lamp emergency operation for 2 – 4 lamp ballasts. KEY OPTIONS KEY FEATURES LUMEN OUTPUT PS1400DW Initial Lumen Output Lamp One lamp Two lamps F32T8 1453 1422 CF40 920 NC FBO31T8 1319 1294 F96T8HO 1595 NC F28T5 890 NC F54T5 940 NC External Ţ xture mounting Self-diagnostics module NC = Not compatible Polarized quick-connect ELA PSMK or factory option MK Initial lumen output measured at 25°C ambient temperature. integrated test switch/pilot (two required) light`assembly Lithonia Lighting Emergency Lighting Systems One Lithonia Way, Conyers , GA 30012 Phone: 800-334-8694 Fax: 770-981-8141 Sheet #: PS1400 DW © 1998-2010 Acuity Brands Lighting, Inc. All rights reserved. Rev. 7/1210 www.lithonia.com