Surge Protective Devices EXCLUSIVE I.T. 10 YEAR PROTECTOR HS-P-SP Models FREE GENERAL SPECIFICATIONS REPLACEMENT Peak Surge Current: 80 kA per phase; 40 kA per mode Description: Series wired, terminal strip connected, Multi-stage ® hybrid Active Tracking Network (ATN ) sine wave tracking surge protective device with remote alarm capability and 2 pair (RJ14) telecommunication circuit protection Warranty: Ten-Year Free Replacement Unit Listings: Recognized components under UL1449 Second Edition, UL1283, Telecommunications circuit UL497A, CSA Manufacturer Qualifications: ISO 9001:1994 Quality System Certification BSI FM 30833 MECHANICAL SPECIFICATIONS Enclosure: ABS Plastic UL94-5VA Connection: Wire clamping box terminals on 30 Amp models; Stud-lugs on 60 Amp models Weight: ≈ 2 lb (9 kg); 60 Amp models ≈ 3 lb (1.5 kg) Operating Temperature: -40° F (-40° C) to +140° F (+60° C) ELECTRICAL/PERFORMANCE SPECIFICATIONS Application: Dedicated 120 or 250 Vrms 1φ AC power circuits operating at ≤30 Amps or ≤60 Amps, feeding variable frequency drives, process controllers, PLCs, power supplies, micro-processor based loads, CNCs & a wide variety of other mission critical & general purpose loads Protection Modes: All mode: L-N (normal mode), L-G, N-G (common mode) Input Power Frequency: 47-64 Hz (AC) Response Time: AC – Active <1 nanosecond Maximum EMI/RFI Attenuation – Mil-Std-220 Maximum 1 kHz 10 kHz 100 kHz 1 MHz 10 MHz Attenuation Frequency 36 dB 3.0 dB 21 dB 38 dB 15 dB 47 dB @ 16 MHz Maximum Continuous Operating Current: 30 Amps or 0 Amps Diagnostics: AC only, Form C (N/O, N/C) Dry Relay (Volt Free) contacts rated at 1 Amp @ 30 VDC, .5 Amp @ 125 VAC Short Circuit Current Rating: 200 kAIC with 30 Amp or 60 Amp Class R Fuse TELECOM ELECTRICAL/PERFORMANCE SPECIFICATIONS Application: Modular jacks are: RJ11 (1 pair) or RJ14 (2pair). Compatible with standard voice grade lines including ISDN Protection Modes: All mode: Normal/Transverse – tip to ring, Common/Longitudinal – tip to ring & ring to ground Frequency Range: 0-16 MHz Series Resistance: ≈ 10 ohms Data Rate: ≤1.6 Mbps UL Listing: UL497A Continuous Current Maximum: 100 mA Pairs Protected: (1-4) (203) Response Time: ≤1 nanosecond EMI/RFI Attenuation: 3 dB point 17 MHz, max attenuation 39 dB @ 38 MHz Maximum Continuous Operating Voltage: 127 Vrms tip to ring, tip & ring to ground (HSPSP.tif; HSPSP-Spec.p65 07/03/03 ZM02-353) ©2003 Specifications subject to change 15470 Flight Path Drive, Brooksville, Florida 34604 USA INNOVATIVE TECHNOLOGY Page 1 of 2 www.itvss.com – 800-647-8877 – 352-799-0713 Surge Protective Devices PROTECTOR HS-P-SP Models ANSI/IEEE C62.41-1991 Measured Limiting Voltage* UL SVR A1 A1 B3/C1 UL 1449-2 C3 Maximum Ring Wave Ring Wave Impulse Wave Impulse Wave Suppressed Continuous 2 kV, 67 A 2 kV, 67 A 6 kV, 3 kA Voltage 20 kV, 10 kA Operating Available Models 180° Phs Angle 90° Phs Angle 90° Phs Angle Ratings 90° Phs Angle Voltage L-N L-N L-N L-N L-N (Vrms) L-G, N-G L-G, N-G L-G, N-G L-G, N-G L-G, N-G 150 30 200 500 430 400 HS-P-SP-120-30-RJ 150, 150 70, 50 240, 50 420, 430 550, 540 400, 400 860 275 60 350 760 800 HS-P-SP-250-30-RJ 275, 275 90, 50 400, 50 790, 770 880, 890 800, 800 150 30 190 420 520 400 HS-P-SP-120-60-RJ 150, 150 80, 40 240, 50 450, 430 660, 560 400, 400 275 20 370 770 890 800 HS-P-SP-250-60-RJ 275, 275 50, 40 400, 50 820, 780 1000, 950 800, 800 *Test environment: Positive polarity. Tested with AC power applied. All units tested at terminals, time base = 1 ms. All measurements referenced from zero volts per NEMA LS-1. IEC 801-5 10 x 700 µs Telecommunications Wave Form* 500 V 1000 V 2000 V 4000 V Maximum Continuous 25 ohm 25 ohm 25 ohm 25 ohm Operating Voltage Telecom L-G L-G L-G (Vrms) L-G L-L L-L L-L L-L 170 170 170 170 RJ-14 127 V 170 170 170 170 (HSPSP-Dim.wmf; HSPSP.p65 07/03/03 ZM02-353) ©2003 Specifications subject to change 15470 Flight Path Drive, Brooksville, Florida 34604 USA INNOVATIVE TECHNOLOGY www.itvss.com – 800-647-8877 – 352-799-0713 Page 2 of 2