THEMIS USPIIe-USB
Specifications
Error Detection/Correction
8-bit ECC to main memory
Ethernet Interface
One (1) 10/100MB with front panel RJ45
Flash Memory
2-MB system, 8-MB user
Memory
128-MB to 4-GB SDRAMOn-chip L1 Cache – 16-KB Instr / 16KB Data On-chip L2 Cache – 256-KB 4-way associative (500-MHz processor)/512-KB (650-MHz)
Parallel Port
Three level 22-bit watchdog timers
Performance
25/28 SPECint95/fp (650 MHz)
PMC Slot
One (1) 64-bit 33-MHz PMC slot
Processors (64-bit)
500-MHz UltraSPARC IIe or 650-MHz UltraSPARC IIi
SCSI Interface
Two (2) 80-MB/sec Ultra2 LVD SCSI ports
Serial I/O
Four (4) serial RS232 ports (one port RS232/RS422)64-bit Solaris 8 and Solaris 9 Support
Timers
Three level 22-bit watchdog timers
VME Form Factor
6U one (1) slot, expandable tothree (3) slots with optional features
VME Interface
VME 64X via Tundra Universe II A24/D16, A32/D32 modes
Features
- 128-Mbytes to 4-Gbytes SDRAM Memory
- 512-KB L2 cache memory
- 64-bit Solaris 8, 9 and 10 Operating Environment support
- 6U VME64 engine with 64-bit 550-MHz UltraSPARC IIe or 64-bit 650-MHz UltraSPARC IIi processor technology
- Audio port on optional USPIIe-USB/2P2 - sample rate 48-KHz, 16-bits
- Front-panel software user selectable, 16-position rotary switch on I/O expansion on optional USPIIe-USB/2P2
- High performance Tundra 64x Tundra VME64 interface
- Injectors - both VME64 and traditional VME injectors are available
- Three (3) USB 1.0 ports (2 on front panel, 1 at rear of board)
- Two (2) 80-MB/sec Ultra2 LVD SCSI ports
- Up to four PMC (3.3/5V) expansion slots: one (1) on baseboard, up to three (3) additional PMC slots on optional I/O expansion boards
- Up to six (6) serial ports: four RS232 Serial ports on baseboard, two (2) additional serial ports on optional I/O USPIIe-USB/2P2 expansion board
- Up to two (2) 10/100Base-T Ethernet ports, one (1) on baseboard, one (1) on optional USPIIe-USB/2P2
- USB, IBM PS/2 keyboard and mouse ports
Datasheet
Extracted Text
Themis USPIIe-USB Single-Board Computer Highest Performance UltraSPARC Single- Board Computers from Themis Computer Themis Computer’s new USPIIe-USB™ is a family of high performance 6U VMEbus computer boards based on the Sun® Microsystems 500-MHz and 650-MHz 64-bit UltraSPARC® processors. The USPIIe-USB provides users with 500-MHz and 650-MHz UltraSPARC® RISC processor options. Themis offers a down-clocked variant of the 650-MHz UltraSPARC processor, to 600-MHz, for users who can accept a reduction in peak processing capacity in exchange for increases in thermal management and design margins. Themis’ USPIIe-USB supports 64-bit Solaris ™ 8 and Solaris 9 operating environments, enabling embedded computing users to access thousands of off-the shelf Solaris ™ software solutions. Designed for the highest level of configuration flexibility and performance, the USPIIe-USB integrates the Sun 64-bit 650-MHz UltraSPARC® IIi processors with a local PCI bus (PMC) peripheral controller slot, and a high performance bridge. This high speed VME64 board is available in one-slot, two-slot and three-slot configurations that offer a wide range of I/O and performance options. The cost-effective USPIIe-USB/1 is a single-slot configuration that has low power dissipation, and high flexibility for embedded computing applications. It features dual 80MB/sec Ultra2 LVD SCSI ports, one 10/100Base-T Ethernet port, and four RS-232 serial ports. Memory is expandable up to 4-Gbytes using memory mezzanine cards. This baseboard configuration provides a 64- bit PMC slot for local I/O or graphics expansion. Further I/O expansion is available via a 64-bit PCI riser to the second and third VME slots. The USPIIe-USB/2P2 two-slot configuration offers significant I/O expansion options, including two additional PMC slots. This expanded I/O configuration provides AC97 audio, a second 10/100Base-T Ethernet port, two multiprotocol serial ports and a software readable front panel rotary switch. These features make it ideal for data and telecommunications applications. The USPIIe-USB/2P3 is a doublewide configuration providing users three additional PMC slots without the expansion features of the USPIIe-USB/2P2 configuration. All versions may be configured with Themis’ high performance TGA3D graphics co- processor. The TGA3D uses one additional VMEbus slot and provides one additional PMC slot. Features & Specifications USPIIe-USB/1 USPIIe-USB/1 Three (3) USB 1.0 ports (2 on front panel, 1 at rear of board) Injectors – both VME64 and traditional VME injectors available Processors (64-bit) – 500-MHz UltraSPARC IIe or Power Requirements - 650-MHz UltraSPARC IIi Performance – 25/28 SPECint95/fp (650 MHz) +5V @ 6A, 12V @ 0.1A, -12V @ .04A (500MHz) +5V @ 7A, 12V @ 0.1A, -12V @ .04A (650MHz) VME Interface – VME 64X via Tundra Universe II A24/D16, A32/D32 modes Operating Temp Range: -5 to + 55°C Cooling – 300 LFM minimum VME Form Factor – 6U one (1) slot, expandable to Dimensions (HxD): 6U 6.299” (160mm) x 9.173” (233mm) three (3) slots with optional features Weight: approx. 1.32 lbs. (weights vary by board configuration) Memory – 128-MB to 4-GB SDRAM On-chip L1 Cache – 16-KB Instr / 16KB Data USPIIe-USB/2P2 On-chip L2 Cache – 256-KB 4-way associative (500-MHz processor)/512-KB (650-MHz) Audio – AC97 audio In/Out, sample rate - 48 kHz, 16 bits Flash Memory – 2-MB system, 8-MB user Ethernet Interface– One (1) additional 10/100 MB with front Error Detection/Correction – 8-bit ECC to main memory panel RJ45 Timers – Three level 22-bit watchdog timers Serial I/O – Two (2) additional serial RS232/422 ports SCSI Interface – Two (2) 80-MB/sec Ultra2 LVD SCSI ports PMC Expansion – Two additional 64-bit PMC slots (3.3/5V) PMC Slot – One (1) 64-bit 33-MHz PMC slot Rotary Switch – User selectable 16-position Parallel Port – Three level 22-bit watchdog timers USPIIe-USB/2P3 Ethernet Interface – One (1) 10/100MB with front panel RJ45 PMC Expansion – Three (3) additional 64-bit 33-MHz PMC Serial I/O – Four (4) serial RS232 ports (one port RS232/RS422) slots (3.3/5V) 64-bit Solaris 8 and Solaris 9 Support USPIIe-USB Block Diagram Accessible on Themis custom VME64 5 -row P2 memory module Accessible on the Front Panel 128MB, 256MB, 512MB, 1GB, MB/s stands for MegaBytes/second 2GB, 4GB Mb/s stands for Megabits/second Temperature Power 72-bit data Monitoring Monitoring Clock 13-bit address sources Pok USPIIe-USB Reset Interrupt 500/600/650 Logic sources MHz CPGA370 66MHz/32-bit Primary PCI 264MB/s Bus #0 Id = 1 Id = 2 APB SME2411 Intel 21154 272PBGA PBGA304 A B rd To 3 VME slot (A) 80MB/s PMC-Carrier bridge (Id = 7) Dual-SCSI Sym53C896 2x SCSI-3 @ 80MB/s PBGA329 Id = 1 (B) 80MB/s PMC board If there is a bridge, then downstream 100Mbits/s bus #: BUS # TBD RIO-PCIO-2 TPE Id = 5 10MB/s SME2300 PBGA272 Universe II USB 70MB/s CA91C142-33CE PBGA313 Id = 1 1.5/12Mbits/s Id = 4 8KB-NVRAM RTC Boot Flash Themis 2MBytes ASIC PBGA256 User Flash 8MBytes ALI IEEE1284 M1535D PS/2 KB/M BGA352 TTY C TTY A/B Id = 2 Serial Port TTY D C&D AC-97 serial bus Siemens (*) Audio module on USPIIe/S2-paddle Audio (*) board rd 3 VME slot PMC Carrier Part Numbers USPIIe-USB/AAA-BBBB-CCC-D-EEE AAA = Board Configuration /1 = Baseboard with 1 PMC slot CCC = Frequency 500 = 500MHz /2P2 = Baseboard with 3 PMC slots 600 = 600MHz /2P3 = Baseboard with 4 PMC slots 650 = 650MHz BBBB = Memory 0128 = 128MB RAM D = Keyboard P = PS/2 0256 = 256MB R AM S = USB 0512 = 512MB R AM 1024 = 1024MB RAM EEE = Ejector Type No Entry = VME64 (Standard) 2048 = 2048MB RAM V32 = VME32 (Optional) I/O Transition Module with cables INT-KIT-USPIIe-USB Ejector Handles: Elma IEEE P1101.10 VME64 (Standard), APW “snap-lock” (Optional), Triple-E-type VME32 (Optional) Themis Computer Themis Computer European Sales Office 3185 Laurelview Court 5 rue Irène Joliot-Curie Fremont, CA 94538 38320 Eybens, France Tel: 510-252-0870 Tel: +33.476.14.77.86 Fax: 510-490-5529 Fax: +33.476.14.77.89 Email: info@themis.com Email: europe@themis.com www.themis.com Themis, the Themis logo, and USPIIe-USB are trademarks or registered trademarks of Themis Computer. Sun, Sun Microsystems, the Sun logo, and Solaris are trademarks or registered trademarks of Sun Microsystems, Inc . in the United States and other countries. UltraSPARC, the ULTRASPARC Driven logo, and SPARC trademarks are used under license and are trademarks or registered trademarks of SPARC International, Inc. in the United S tates and other countries. Products bearing SPARC trademarks are based upon an architecture developed by Sun Microsystems, Inc. 091103 ©Copyright 2003 Themis Computer. Specifications subject to change without notice. All rights reserved. Ichip2 Ebus SME2212 TQFP128 Bus #1 Secondary PCI Secondary PCI Bus #2 Secondary PCI Bus #90 I2C Bus I2C Bus Connector Id = 6 & 7 Vme slot geographical ID VME64 Bus Vme Sysreset 33MHz/32 bit 132MB/s 33MHz/32 bit 132MB/s 33MHz/64 bit 264MB/s - - -
Frequently asked questions
What makes Elite.Parts unique?

What kind of warranty will the USPIIe-USB have?

Which carriers does Elite.Parts work with?

Will Elite.Parts sell to me even though I live outside the USA?

I have a preferred payment method. Will Elite.Parts accept it?

Why buy from GID?

Quality
We are industry veterans who take pride in our work

Protection
Avoid the dangers of risky trading in the gray market

Access
Our network of suppliers is ready and at your disposal

Savings
Maintain legacy systems to prevent costly downtime

Speed
Time is of the essence, and we are respectful of yours
What they say about us
FANTASTIC RESOURCE
One of our top priorities is maintaining our business with precision, and we are constantly looking for affiliates that can help us achieve our goal. With the aid of GID Industrial, our obsolete product management has never been more efficient. They have been a great resource to our company, and have quickly become a go-to supplier on our list!
Bucher Emhart Glass
EXCELLENT SERVICE
With our strict fundamentals and high expectations, we were surprised when we came across GID Industrial and their competitive pricing. When we approached them with our issue, they were incredibly confident in being able to provide us with a seamless solution at the best price for us. GID Industrial quickly understood our needs and provided us with excellent service, as well as fully tested product to ensure what we received would be the right fit for our company.
Fuji
HARD TO FIND A BETTER PROVIDER
Our company provides services to aid in the manufacture of technological products, such as semiconductors and flat panel displays, and often searching for distributors of obsolete product we require can waste time and money. Finding GID Industrial proved to be a great asset to our company, with cost effective solutions and superior knowledge on all of their materials, it’d be hard to find a better provider of obsolete or hard to find products.
Applied Materials
CONSISTENTLY DELIVERS QUALITY SOLUTIONS
Over the years, the equipment used in our company becomes discontinued, but they’re still of great use to us and our customers. Once these products are no longer available through the manufacturer, finding a reliable, quick supplier is a necessity, and luckily for us, GID Industrial has provided the most trustworthy, quality solutions to our obsolete component needs.
Nidec Vamco
TERRIFIC RESOURCE
This company has been a terrific help to us (I work for Trican Well Service) in sourcing the Micron Ram Memory we needed for our Siemens computers. Great service! And great pricing! I know when the product is shipping and when it will arrive, all the way through the ordering process.
Trican Well Service
GO TO SOURCE
When I can't find an obsolete part, I first call GID and they'll come up with my parts every time. Great customer service and follow up as well. Scott emails me from time to time to touch base and see if we're having trouble finding something.....which is often with our 25 yr old equipment.
ConAgra Foods