GSM7 Medical 7 Watt Single Output Global Performance Switchers FEATURES: • World’s smallest medically approved 7 W supply 2.00" x 2.28" x 0.56" Wide-range ac input (85-264 Vac) Medical Approval to UL2601-1 and EN60601-1 EMI conducted to CISPR11 Class B Ideal for ultra-compact applications marked to LVD SPECIFICATIONS: Ac Input Environmental 85-264 Vac, 47-63 Hz single phase. Designed for 0 to 50°C operation at full rated output power; derate output current and total output power by Holdup Time 2.5% per °C above 50°C. See Environmental specifica- 16 ms minimum from loss of ac. tion on next page. Output Power Medical EMI/EMC Compliance Normal continuous output power is 7 W, 9 W peak for 60 s All models include built-in EMI filtering to meet the maximum duration, 10% duty cycle. Factory set to begin following emissions requirements: power limiting at approximately 9 W. EMI SPECIFICATIONS COMPLIANCE LEVEL Conducted Emissions EN55011 Class B; FCC Class B Output Regulation Static Discharge EN61000-4-2, 6 kV contact, 8 kV air Regulation from initial setpoint measured by changing RF Field Susceptibility EN61000-4-3, 3 V/meter load from no-load to 50% load or 50% load to full load in Fast Transients/Bursts EN61000-4-4, 2 kV, 5 kHz either direction. Initial sepoint tolerance is measured at Surge Susceptibility EN61000-4-5, 1 kV diff., 2 kV com. 50% load. No minimum load is required to maintain proper regulation. Medical Safety Condor D.C. Power Supplies, Inc. declares under our sole Overload Protection responsibility that all GSM7 models are in conformity with Fully protected against short circuit and output overload. the applicable requirements of EN60601-1 following the Short circuit protection is cycling type power limit. provisions of the Low Voltage Directive 73/23/EEC. No Load Turn-on/Standby All GSM7 models are certified to be in compliance with Full regulation at no load. the applicable requirements of UL2601-1 (Patient Care Equipment), CSA 22.2 No. 234 (with additional tests to Output Noise C22.2 No 601.1 per T.I.L. CA-08), EN 60601-1. Classification 0.5% rms, 1% pk-pk, 20 MHz bandwidth, differential (in accordance with sub-clause 5 of EN60601-1): mode. Measured with scope probe directly across output (5.1) Protection against electric shock = class II terminals of the power supply with load terminated with (5.2) Degree of protection against electric shock = signal 0.1 uF capacitor. output or intermediate (5.3) Protection against harmful ingress of water = Voltage Adjustment ordinary (no protection) Factory set with fixed resistors to maximize reliability. (5.5) Not suitable for use in the presence of flammable anesthetic mixture Efficiency (5.6) Mode of operation = continuous 72% minimum for the 5.0 V model at full rated load, nominal input voltage. Efficiency increases as output Earth Leakage Current voltage increases. Leakage current measured in ground wire connection to output common. Input Protection Internal ac fuse provided on all units. Designed to open only if catastrophic failure occurs in the unit; fuse does not blow on overload or short circuit. Internal 320 Vac MOV Leakage Current* Leakage Current** Test Method included. Units will not be damaged when tested for input Model Test Voltage transients in accordance with the following standards: GSM7µ3Aµ2 A5z 011 32 Vac/60 H UL2601- ESD—IEC1000-4-2 Level III GSM7µ5Aµ5 A8z 521 64 Vac/50 H IEC601- Fast Transient—IEC1000-4-4 Level III * Normal condition **Single fault condition Condor D.C. Power Supplies, Inc., 2311 Statham Parkway, Oxnard, CA 93033 800-235-5929 • 805-486-4565  FAX 805-487-8911  www.condorpower.com 14 GSM7 Medical 7 Watt Single Output Initial Setpoint Model Output Current Load Regulation Tolerance OVP Setpoint Ripple and Noise GSM7-5 5A .1 V 1% .4 0% .75 2V .5 6% .2 ± 0.6 1 GSM7-12 1A 2 V 0% .6 0% .75 2V .5 1% 4 ± 1.1 1 GSM7-15 1A 5 V 0% .5 0% .75 2V .5 1% 8.5 ± 1.5 1 GSM7-24 2A 4 V 0% .3 0% .75 2V .5 2% 8 ± 2.5 1 GSM7-28 2A 8 V 0% .3 0% .75 2V .5 3% 4 ± 2.8 1 GSM7 MECHANICAL SPECIFICATIONS AC NEUTRAL Environmental Operating Non-operating Specification TC emperature (A)0C to 50º -40 to +85º HH umidity (A) 0H to 95% R 0 to 95% R A. Units should be allowed to warm up/operate under non-condensing conditions Sg hock (B) 20 40 g pk pk before application of power. B. Random vibration—10 to 2000Hz, 6dB/octave roll-off from 350 to 2000Hz, 3 At ltitude -t 500 to 10,000 f -500 to 40,000 f orthogonal axes. Tested for 10 min./axis operating and 1 hr./axis non-operating. 2 2 C. Shock testing—half-sinusoidal, 10 ± 3 ms duration, ± direction, 3 orthogonal Vg ibration (C) 1.5 , 0.003 g/g Hz 5 , 0.026 g /Hz rms rms axes, total 6 shocks. Condor D.C. Power Supplies, Inc., 2311 Statham Parkway, Oxnard, CA 93033 800-235-5929  805-486-4565  FAX 805-487-8911  www.condorpower.com 15