R A HIGHER LEVEL OF CONFIDENCE ® ON Series Wallmount Extended Runtime UPS: For some, conventional UPSs are “good enough.” But many find ordinary protection measures inadequate. Others face performance expectations with no tolerance for downtime. ON Series Power Conditioned UPSs are engineered to satisfy these demanding applications. Ultimate assurance of system reliability All UPS makers acknowledge the broad range of power disturbances that compromise system reliability. And all address them to some degree. But here’s the difference — ONEAC’s proprietary power conditioning technology eliminates power problems entirely. Providing a level of protection that even the highest quality surge suppressor and filter technology cannot match. Exceptionally dependable battery backup We start with premium quality batteries. Thermally isolate them for maximum life. And employ unique charging circuitry attuned to the specific battery characteristics of each model to speed recovery and minimize stress on batteries. Automatic monitoring of battery condition ensures readiness, gives plenty of warning when replacement is recommended. And our patented battery pack allows replacement in under a minute without tools or training, without downtime, and without risk. Proven durability, backed by a 5-year warranty ONEAC UPS’s robust design is impervious to the harshest electrical environments. Designed and • Extended runtime: provides up to 8 hours of battery backup time manufactured under ISO9001 quality procedures, ON Series UPSs are exceptionally reliable. With an • Wall mountable: for applications with space constraints average mean time between failures more than twice as long as leading competitors. No surprise, then, • Full-time, on-line isolating transformer: eliminates all power contaminants that we back our UPSs with greater confidence — 5 years on all power and control systems, 2 years on • Sinusoidal waveform: supports even the most sensitive loads the battery sub-system. ® • ONBoost : compensates for momentary voltage drops, conserves batteries • Intelligent serial communications: for advanced diagnostics & remote management • On-site, on-line replaceable battery: minimizes cost and downtime ONEAC’s low-impedance, isolation transformer • Automatic self test: ensures battery and system readiness provides a level of • Designed & manufactured under ISO 9001: assures consistent quality and performance protection superior to surge suppressor and • Global approvals: UL, GS Mark, CE Mark filter based systems — provides greater • 5-year warranty: the best assurance of product quality and performance in the industry assurance of system • Free 24-hour technical support reliability. A Chloride Power Protection Company R A HIGHER LEVEL OF CONFIDENCE ON Series Wallmount Extended Runtime UPS: Specifications Power Conditioning Performance Characteristics ONEAC’s unique power conditioning architecture provides superior protection Nominal input voltage: 120 VAC, 60 Hz & 230 VAC, 50/60 Hz against the full range of power line disturbances. Components include: Surge voltage withstand capability: ANSI/IEEE C62.41 Category A&B, 6 kV/ 200 & 500 Amp, 100 kHz ringwave Full output isolation: ONEAC’s proprietary transformer design integrates power Surge voltage let-through (max): Less than 10 V Normal mode (L-N), less conditioning magnetics and voltage conversion magnetics in a single compact than 0.5 V Common mode (N-G) when subjected to 6 kV ANSI/IEEE C62.41 Cat. A unit. Provides superior protection against lightning and other high energy surges. Normal & common mode clamping response time: Instantaneous ® Virtual Kelvin Ground : Eliminates the full spectrum of conducted power line Transfer time (typical/max): < 3.0 / 3.5 milliseconds noise (from 50 kHz to 10 MHz) in all modes, reduces the effect of electrostatic On-battery output voltage: Sine wave discharge (ESD) and provides an exceptionally clean signal reference ground for ONBoost: boosts output voltage 11% above input voltage if between -21% & electronic systems. -15% of nominal Load power factor range (crest factor): UPS .65 to 1.0 (3)—will support Communications loads rated 0.5 to 1.0 (<5) Batteries: sealed, maintenance-free lead acid with a 3-6 year typical lifetime Basic mode provides standard protocols recognized by UPS monitoring software supplied with Windows NT, NetWare and Banyan operating systems. Recharge time to 60% available capacity: 4 hours per battery cabinet All units have temperature sensitive chargers and provide thermal Advanced mode uses ONEAC’s content-rich ASCII packets to communicate isolation for battery pack. ® with ONEAC’s MopUPS family of UPS monitoring software for NetWare, OS/2, a full catalog of UNIX operating systems and SNMP. Global Approvals Models for North America are FCC Class A certified and listed under UL 1778 and CSA22.2 safety standards. Models for Europe carry the GS and CE marks and are tested under the following standards: EN50091, EN60950, EN50081-1, EN55022 (CISPR 22), EN50082-1, IEC801-2, IEC801-3 and IEC801-4. Model ON400 ON600 External Battery Cabinet Part number (60 Hz) ON400XA-WL-SNK ON600XA-WL-SNK ONXBC-WL-217 (50 Hz) ON400XI-WL-SNK ON600XI-WL-SNK NA Maximum capacity (volt-amps, watts) 400, 280 600, 400 NA External battery (1) included (1) included two 12V, 17AH Runtime — hr:min (half load/full load) 1:53/0:55 1:17/0:29 NA Power head maximum dimensions (HxWxD) inches 15 x 8.5 x 9 15 x 8.5 x 9 NA (HxWxD) cm 38 x 22 x 23 38 x 22 x 23 NA External battery maximum dimensions (HxWxD) inches 7.5 x 8.5 x 9 7.5 x 8.5 x 9 7.5 x 8.5 x 9 (HxWxD) cm 27 x 22 x 23 27 x 22 x 23 27 x 22 x 23 Net weight — lbs. (50 Hz in kg) 60 (27) 64 (29) 35 (16) Shipping weight — lbs. (50 Hz in kg) 70 (32) 74 (34) 40 (18) Input connector* (60 Hz) 5-15P (6 ft, detachable input cord) 5-15P (6 ft, detachable input cord) battery sensor cable (50 Hz) IEC320 (M/F detachable cord) IEC320 (M/F detachable cord) battery sensor cable Output connector* (60 Hz) (4) NEMA 5-15R (4) NEMA 5-15R NA (50 Hz) (4) IEC320 female (4) IEC320 female NA * Other input and output connectors available upon request. Runtime* ON400XA-WL-SNK ON400XA-WSNK2 ON400XA-WSNK3 ON400XA-WSNK4 ON400XA-WSNK5 ON400XA-WSNK6 ON400XA-WSNK7 ON400XA-WSNK8 1 Battery 2 Batteries 3 Batteries 4 Batteries 5 Batteries 6 Batteries 7 Batteries 8 Batteries ON400 50% load 1:53 3:56 6:03 8:25 10:24 12:30 15:05 17:20 100% load 0:55 2:00 3:16 4:29 5:29 6:33 7:54 9:05 ON600XA-WL-SNK ON600XA-WSNK2 ON600XA-WSNK3 ON600XA-WSNK4 ON600XA-WSNK5 ON600XA-WSNK6 ON600XA-WSNK7 ON600XA-WSNK8 1 Battery 2 Batteries 3 Batteries 4 Batteries 5 Batteries 6 Batteries 7 Batteries 8 Batteries ON600 50% load 1:17 2:43 4:18 5:57 7:18 8:53 10:41 — 100% load 0:29 1:11 2:03 2:47 3:22 3:50 4:42 5:26 * Due to application specific conditions, actual runtime may vary. ONEAC, ON Series, ONBoost, Virtual Kelvin Ground and MopUPS are registered trademarks of ONEAC ONEAC is a UL/BSI Corporation. All other trademarks, product and corporate names are the property of their respective registered corporation — owners. A Chloride Power Protection Company Certification No. A2900 (800) 327 8801 OPT. 2 in USA AND CANADA +44 (0) 2380 610311 in UK AND EUROPE 27944 N. Bradley Road, Libertyville, IL 60048 Phone 847 816-6000 FAX 847 680-5124 George Curl Way,Southampton, Hampshire SO18 2RY UK FAX +44 (0) 2380 612039 www.oneac.com All specifications subject to change without notice. © 2004 ONEAC Corporation Printed in U.S.A. Part # 917-113 Rev. C