917-113 D ON WALL:917-113 revC ON WALL 9/29/11 1:30 PM Page 1 RR ® ON Series Wallmount Extended Runtime UPS: For some, conventional UPSs are “good enough.” But many find ordinary protection measures inadequate. Others face performance expectations with no tolerance for downtime. ON Series Power Conditioned UPSs are engineered to satisfy these demanding applications. Ultimate assurance of system reliability All UPS makers acknowledge the broad range of power disturbances that compromise system reliability. And all address them to some degree. But here’s the difference — ONEAC’s proprietary power conditioning technology eliminates power problems entirely. Providing a level of protection that even the highest quality surge suppressor and filter technology cannot match. Exceptionally dependable battery backup We start with premium quality batteries. Thermally isolate them for maximum life. And employ unique charging circuitry attuned to the specific battery characteristics of each model to speed recovery and minimize stress on batteries. Automatic monitoring of battery condition ensures readiness, gives plenty of warning when replacement is recommended. And our patented battery pack allows replacement in under a minute without tools or training, without downtime, and without risk. Proven durability, backed by a 5-year warranty ONEAC UPS’s robust design is impervious to the • Extended runtime: provides up to 8 hours of battery backup time harshest electrical environments. Designed and manufactured under ISO9001 quality procedures, • Wall mountable: for applications with space constraints ON Series UPSs are exceptionally reliable. With an • Full-time, on-line isolating transformer: eliminates all power contaminants average mean time between failures more than twice as long as leading competitors. No surprise, • Sinusoidal waveform: supports even the most sensitive loads then, that we back our UPSs with greater confidence — 5 years on all power and control ® • ONBoost : compensates for momentary voltage drops, conserves batteries systems, 2 years on the battery sub-system. • Intelligent serial communications: for advanced diagnostics & remote management • On-site, on-line replaceable battery: minimizes cost and downtime ONEAC’s low- • Automatic self test: ensures battery and system readiness impedance, isolation • Designed & manufactured under ISO 9001: assures consistent quality and performance transformer provides a level of protection • Global approvals: UL, GS Mark, CE Mark superior to surge suppressor and filter • 5-year warranty: the best assurance of product quality and performance in the industry based systems — provides greater • Free 24-hour technical support assurance of system reliability. 917-113 D ON WALL:917-113 revC ON WALL 9/29/11 1:30 PM Page 2 RR ON Series Wallmount Extended Runtime UPS: Specifications Power Conditioning Performance Characteristics ONEAC’s unique power conditioning architecture provides superior protection Nominal input voltage: 120 VAC, 60 Hz & 230 VAC, 50/60 Hz against the full range of power line disturbances. Components include: Surge voltage withstand capability: ANSI/IEEE C62.41 Category A&B, 6 kV/ 200 & 500 Amp, 100 kHz ringwave Full output isolation: ONEAC’s proprietary transformer design integrates Surge voltage let-through (max): Less than 10 V Normal mode (L-N), less power conditioning magnetics and voltage conversion magnetics in a single than 0.5 V Common mode (N-G) when subjected to 6 kV ANSI/IEEE C62.41 Cat. A compact unit. Provides superior protection against lightning and other high Normal & common mode clamping response time: Instantaneous energy surges. Transfer time (typical/max): < 3.0 / 3.5 milliseconds ® Virtual Kelvin Ground : Eliminates the full spectrum of conducted power On-battery output voltage: Sine wave line noise (from 50 kHz to 10 MHz) in all modes, reduces the effect of electro- ONBoost: boosts output voltage 11% above input voltage if between -21% & static discharge (ESD) and provides an exceptionally clean signal reference -15% of nominal ground for electronic systems. Load power factor range (crest factor): UPS .65 to 1.0 (3)—will support loads rated 0.5 to 1.0 (<5) Communications Batteries: sealed, maintenance-free lead acid with a 3-6 year typical lifetime Basic mode provides standard protocols recognized by UPS monitoring Recharge time to 60% available capacity: 4 hours per battery cabinet software supplied with Windows NT, NetWare and Banyan operating systems. All units have temperature sensitive chargers and provide thermal isolation for battery pack. Advanced mode uses ONEAC’s content-rich ASCII packets to communicate ® with ONEAC’s MopUPS family of UPS monitoring software for NetWare, OS/2, a full catalog of UNIX operating systems and SNMP. Global Approvals Models for North America are FCC Class A certified and listed under UL 1778 and CSA22.2 safety standards. Models for Europe carry the GS and CE marks and are tested under the following standards: EN50091, EN60950, EN50081- 1, EN55022 (CISPR 22), EN50082-1, IEC801-2, IEC801-3 and IEC801-4. M o d e l O N 4 0 0 O N 6 0 0 E x t e r n a l Battery Cabinet Part number (60 Hz) ON400XA-WL-SNK ON600XA-WL-SNK ONXBC-WL-217 (50 Hz) ON400XI-WL-SNK ON600XI-WL-SNK NA Maximum capacity (volt-amps, watts) 400, 280 600, 400 NA External battery (1) included (1) included two 12V, 17AH Runtime — hr:min (half load/full load) 1:53/0:55 1:17/0:29 NA Power head maximum dimensions (HxWxD) inches 15 x 8.5 x 9 15 x 8.5 x 9 NA (HxWxD) cm 38 x 22 x 23 38 x 22 x 23 NA External battery maximum dimensions (HxWxD) inches 7.5 x 8.5 x 9 7.5 x 8.5 x 9 7.5 x 8.5 x 9 (HxWxD) cm 27 x 22 x 23 27 x 22 x 23 27 x 22 x 23 Net weight — lbs. (50 Hz in kg) 60 (27) 64 (29) 35 (16) Shipping weight — lbs. (50 Hz in kg) 70 (32) 74 (34) 40 (18) Input connector* (60 Hz) 5-15P (6 ft, detachable input cord) 5-15P (6 ft, detachable input cord) battery sensor cable (50 Hz) IEC320 (M/F detachable cord) IEC320 (M/F detachable cord) battery sensor cable Output connector* (60 Hz) (4) NEMA 5-15R (4) NEMA 5-15R NA (50 Hz) (4) IEC320 female (4) IEC320 female NA * Other input and output connectors available upon request. Runtime* O N 4 0 0 X A - W L - S N K O N 4 0 0 X A - W S N K 2 O N 4 0 0 X A - W S N K 3 O N 4 0 0 X A - W S N K 4 O N 4 0 0 X A - W S N K 5 O N 4 0 0 X A - W S N K 6 O N 4 0 0 X A - W S N K 7 O N 4 0 0 X A - W S N K 8 1 B a t t e r y 2 B a t t e r i e s 3 B a t t e r i e s 4 B a t t e r i e s 5 B a t t e r i e s 6 B a t t e r i e s 7 B a t t e r i e s 8 B a t t e r i e s O N 4 0 0 50% load 1:53 3:56 6:03 8:25 10:24 12:30 15:05 17:20 100% load 0:55 2:00 3:16 4:29 5:29 6:33 7:54 9:05 O N 6 0 0 X A - W L - S N K O N 6 0 0 X A - W S N K 2 O N 6 0 0 X A - W S N K 3 O N 6 0 0 X A - W S N K 4 O N 6 0 0 X A - W S N K 5 O N 6 0 0 X A - W S N K 6 O N 6 0 0 X A - W S N K 7 O N 6 0 0 X A - W S N K 8 1 B a t t e r y 2 B a t t e r i e s 3 B a t t e r i e s 4 B a t t e r i e s 5 B a t t e r i e s 6 B a t t e r i e s 7 B a t t e r i e s 8 B a t t e r i e s O N 6 0 0 50% load 1:17 2:43 4:18 5:57 7:18 8:53 10:41 — 100% load 0:29 1:11 2:03 2:47 3:22 3:50 4:42 5:26 * Runtimes are based upon fully charged, new batteries. Runtimes are affected by battery age, ambient temperature, site-specific UPS usage patterns, and actual operating load characteristics. Actual runtimes may vary. ONEAC, ON Series, ONBoost, Virtual Kelvin Ground and MopUPS are registered trademarks of ONEAC Corporation. All other trademarks, product and corporate names are the property of their respective owners. (800) 327 8801 OPT. 2 in USA AND CANADA 27944 N. Bradley Road, Libertyville, IL 60048 Phone 847 816-6000 FAX 847 680-5124 www.oneac.com All specifications subject to change without notice. © 2011 ONEAC Corporation Printed in U.S.A. Part # 917-113 Rev. D