PSIV-350-2 - MEAN WELL

Description

MeanWell PSIV-350-2 Power Supply. ATX12V | 250W | 100-132VAC / 200-264VAC

Part Number

PSIV-350-2

Price

Request Quote

Manufacturer

MEAN WELL

Lead Time

Request Quote

Category

POWER SUPPLY

Specifications

AC Current

6.0A / 115VAC; 3.0A / 230VAC

Connector

ATX main power connector * 1ea; +12V power connector * 1ea; Auxiliary power connector * 1ea; Peripheral power connector * 5 ea; Floppy drive power connector * 2 ea

Cooling

Forced air ventilation by 8cm DC fan

Dimensions

150*140*86mm (L*W*H)

EFFICIENCY(Typ.)

70%

EMI conduction & radiation

Compliance to EN55022 (CISPR22) class B, FCC part 15 class B

EMS Immunity

Compliance to EN61000-4-2,3,4, 5,6,8,11, Light industry level, criteria A

Frequency Range

47~63Hz

Harmonic current

Compliance to EN61000-3-2,-3

HOLD UP TIME (Typ.)

8ms min. at full load

Humidity

Operating:20~90% RH non-condensing; Storage:10~95% RH

Inrush Current (max.)

40A / 115VAC; 80A / 230VAC

Isolation resistance

I/P-O/P, I/P-FG: 50M Ohms / 500VDC

LEAKAGE CURRENT (max.)

3.5mA / 240VAC

MTBF

100K hrs min.; MIL-HDBK-217F (25°C)

Over Voltage Protection

+5V, +12V: 110%~130% of rated voltage; Protection type:Shut down o/p voltage, re-power on to recover

Overload Protection

105~150% rated output power; Protection type:Shut down o/p voltage, re-power on to recover

Power Fail Signal

The TTL compatible signal will go down at least 1ms before +5V below 4.75V

Power Good Signal

The TTL compatible signal out with 100ms to 500ms delay after power set up

PS-ON Input Signal

Power on: PS-ON is "Low" or "2V"

Safety standards

UL1950, CSA 22.2-950, TUV EN60950 Approved

Short circuit protection

All output equipped with short circuit; Protection type:Shut down o/p voltage, re-power on to recover

Temperature

Operating:-10 to 35°C; Storage:-20 to 85°C

Temperature Coefficient

±0.05% /°C (0~50°C)

Vibration

10~200Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes

Voltage Range

100 ~ 132VAC / 200 ~ 264VAC selected by switch

Withstand voltage

I/P-O/P, I/P-FG:1.5KVAC

Features

100% full load burn-in test
AC input range selected by switch
Approvals: TUV / CSA / UL / CB / CE / FCC
Forced air cooling by built-in DC fan
High efficiency
Power fail signal output
Power good signal output
Power ON-OFF switch
With +5VSB:0 ~ 2.0A max.

Datasheet

MeanWell=PSIV-350-2=datasheet-6329821111.pdf

123 KiB

Download

Extracted Text

250W ATX 12V PC Power Supply PSIV-350-2 s e ri e s Features : AC input range selected by switch With +5VSB:0 ~ 2.0A max. Power good signal output Power fail signal output Power ON-OFF switch High efficiency Approvals: TUV / CSA / UL / CB / CE / FCC Forced air cooling by built-in DC fan 100% full load burn-in test 1 year warranty SPECIFICATION MODEL CH1 CH2 CH3 CH4 CH5 STANDBY DC VOLTAGE 3.3V 5V 12V -5V -12V 5VSB MINIMUM CURRENT 4.0A 5.0A 2.6A 0.1A 0.1A 0A NORMAL CURRENT 13A 20A 8A 0.3A 0.8A 2.0A MAXIMUM CURRENT 20A 25A 13A 0.3A 0.8A 2.0A +5V, +3.3V 145W max. COMBINE LOAD OUTPUT +5V, +3.3V, +12V 230W max. RATED POWER (max.) 250W continue RIPPLE & NOISE (max.) Note.2 50mVp-p 100mVp-p 120mVp-p 50mVp-p 150mVp-p 100mVp-p LINE REGULATION 1% 1% 1% 2% 2% 1% LOAD REGULATION Note.3 5% 5% 5% 10% 10% 5% HOLD UP TIME 8ms min. at full load VOLTAGE RANGE 100 ~ 132VAC / 200 ~ 264VAC selected by switch FREQUENCY RANGE 47~63Hz EFFICIENCY (Typ.) 70% INPUT AC CURRENT 6.0A / 115VAC 3.0A / 230VAC INRUSH CURRENT (max.) 40A / 115VAC 80A / 230VAC 3.5mA / 240VAC LEAKAGE CURRENT(max.) 105~150% rated output power OVER LOAD Protection type : Shut down o/p voltage, re-power on to recover +5V, +12V: 110%~130% of rated voltage PROTECTION OVER VOLTAGE Protection type : Shut down o/p voltage, re-power on to recover All output equipped with short circuit SHORT CIRCUIT Protection type : Shut down o/p voltage, re-power on to recover POWER GOOD SIGNAL The TTL compatible signal out with 100ms to 500ms delay after power set up FUNCTION POWER FAIL SIGNAL The TTL compatible signal will go down at least 1ms before +5V below 4.75V Power on: PS-ON = "Low" or "<0.8V" ; Power off: PS-ON = "Hi" or ">2V" PS-ON INPUT SIGNAL -10~+35 WORKING TEMP. WORKING HUMIDITY 20~90% RH non-condensing ENVIRONMENT STORAGE TEMP., HUMIDITY -20~+85 10~95% RH TEMP. COEFFICIENT 0.05% / (0~50 ) VIBRATION 10~200Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes SAFETY STANDARDS UL1950, CSA 22.2-950, TUV EN60950 Approved WITHSTAND VOLTAGE I/P-O/P, I/P-FG:1.5KVAC ISOLATION RESISTANCE SAFETY & I/P-O/P, I/P-FG: 50M Ohms / 500VDC EMC EMI CONDUCTION & RADIATION Compliance to EN55022 (CISPR22) class B, FCC part 15 class B (Note 4) HARMONIC CURRENT Compliance to EN61000-3-2,-3 EMS IMMUNITY Compliance to EN61000-4-2,3,4, 5,6,8,11, Light industry level, criteria A MTBF 100K hrs min. MIL-HDBK-217F (25 ) ATX main power connector * 1ea; +12V power connector * 1ea; Auxiliary power connector * 1ea CONNECTOR Peripheral power connector * 5 ea; Floppy drive power connector * 2 ea OTHERS Forced air ventilation by 8cm DC fan COOLING DIMENSION 150*140*86mm (L*W*H) PACKING 1.1kg ; 12pcs / 16kg / CARTON NOTE 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Load regulation is measured from 20% to 100% max. Load. 4. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. File Name: PSIV-350-2-SPEC 2004-06-21 250W ATX 12V PC Power Supply PSIV-350-2 s e ri e s Mechanical Specification Unit: mm 52.4 6#-32UND(4X) 138 6.0MM MAX DEEP 230 114 AC 118.5 INPUT CONNECTOR ( D ) ( D ) ( D ) ( E ) ( D ) ( D ) ( E ) ( B ) ( C ) (A)ATX main power connector (B)+12V power connector Type: MOLEX 39-01-2200 or equivalent Type: MOLEX 39-01-2040 or equivalent (C)Auxiliary power connector (D)Peripheral connector Type: MOLEX 90331-0010 or equivalent Type: MOLEX 8981-04P or equivalent (E)Floppy drive connector Type: AMP 171822-4 or equivalent ( A ) File Name: PSIV-350-2-SPEC 2004-06-21 WIRE OUTPUT OF CASE +5VDC +12VDC +5VDC +5V SB -5VDC PWR-OK GND GND GND +5VDC GND GND PS-ON +5VDC GND GND -12VDC +3.3VDC +3.3VDC +3.3VDC PIN11 PIN1 64 L=300mm 20mm 16 43.45 4 +5VDC 3 COM COM 2 +12VDC 1 L=150mm L=300mm 20mm +5VDC 4 COM 3 COM 2 +12VDC 1 L=150mm +5VDC 4 COM 3 COM 2 +12VDC 1 L=150mm +5VDC 1 2 COM COM 3 4 +12VDC 25.9 43.55 62.05 +5VDC 4 74 COM 3 2 COM +12VDC 1 L=150mm L=300mm 20mm +5VDC 4 COM 3 COM 2 +12VDC 1 L=150mm +5VDC 1 COM 2 COM 3 4 +12VDC +12VDC COM 2 4 1 3 +12VDC COM L=300mm 20mm WIRE OUTPUT HOLE 6 +5VDC +3.3VDC 5 4 +3.3VDC 3 COM 2 COM 1 COM L=300mm 20mm

Frequently asked questions

At GID Industrial (Elite.Parts' parent company), we specialize in procuring industrial parts. We know where to find the rare and obsolete equipment that our customers need in order to get back to business. There are other companies who claim to do what we do, but we're confident that our commitment to quality and value is unparalleled in our field.

Warranties differ by part and by which suppliers we use to procure it for you. Sometimes, a part will be sold as-is and without a warranty. Our specialty, single board computers, tend to receive a one-year warranty.

Elite.Parts can ship via FedEx, UPS, DHL, and USPS. We have accounts with each of them and generally ship using one of those, but we can also ship using your account if you would prefer. However, we can use other carriers if it will be more convenient for you.

Absolutely! We are happy to serve customers regardless of location. We work with international clients all the time, and we are familiar with shipping to destinations all across the globe.

All major credit cards are accepted: Visa, MasterCard, Discover, and American Express. We will also accept payment made with wire transfer or PayPal. Checks will only be accepted from customers in the USA. Terms may available for larger orders, upon approval.

What they say about us

FANTASTIC RESOURCE

One of our top priorities is maintaining our business with precision, and we are constantly looking for affiliates that can help us achieve our goal. With the aid of GID Industrial, our obsolete product management has never been more efficient. They have been a great resource to our company, and have quickly become a go-to supplier on our list!

Bucher Emhart Glass

EXCELLENT SERVICE

With our strict fundamentals and high expectations, we were surprised when we came across GID Industrial and their competitive pricing. When we approached them with our issue, they were incredibly confident in being able to provide us with a seamless solution at the best price for us. GID Industrial quickly understood our needs and provided us with excellent service, as well as fully tested product to ensure what we received would be the right fit for our company.

Fuji

HARD TO FIND A BETTER PROVIDER

Our company provides services to aid in the manufacture of technological products, such as semiconductors and flat panel displays, and often searching for distributors of obsolete product we require can waste time and money. Finding GID Industrial proved to be a great asset to our company, with cost effective solutions and superior knowledge on all of their materials, it’d be hard to find a better provider of obsolete or hard to find products.

Applied Materials

CONSISTENTLY DELIVERS QUALITY SOLUTIONS

Over the years, the equipment used in our company becomes discontinued, but they’re still of great use to us and our customers. Once these products are no longer available through the manufacturer, finding a reliable, quick supplier is a necessity, and luckily for us, GID Industrial has provided the most trustworthy, quality solutions to our obsolete component needs.

Nidec Vamco

TERRIFIC RESOURCE

This company has been a terrific help to us (I work for Trican Well Service) in sourcing the Micron Ram Memory we needed for our Siemens computers. Great service! And great pricing! I know when the product is shipping and when it will arrive, all the way through the ordering process.

Trican Well Service

GO TO SOURCE

When I can't find an obsolete part, I first call GID and they'll come up with my parts every time. Great customer service and follow up as well. Scott emails me from time to time to touch base and see if we're having trouble finding something.....which is often with our 25 yr old equipment.

ConAgra Foods

Why buy from GID?

What they say about us

Related Products