AT8020  ® ® Dual Intel Dual-Core Xeon ® ® The new Kontron AT8020 AdvancedTCA processor board features Dual Intel Dual-Core Xeon  two Intel® Dual-Core Xeon® processors and support for two Support for up to 16GB SDRAM AdvancedMC modules. The result is an open modular process-  ing platform that will increase the number of deployments of 2 X Mid-size AdvancedMC bays  AdvancedTCA solutions at the heart of every compute intensive mobile-IMS network element — from the transcoding of live Dual Dual-Gigabit on Fabric  multimedia mobile content on a Multimedia Resource Function SAS interface available Processor (MRFP) to concurrent processing of subscriber data on  Home Subscriber Locator (HLR) systems. If it’s Embedded, it’s Kontron AT8020 Technical Information  Processors BIOS - Two Dual-Core Intel Xeon LV Processors 2.0GHz - AMI BIOS - Passive heatsinks - Save CMOS in NVRAM option - Boot from gigabit Ethernet (Base and Fabric interfaces and management Lan) Cache Memory - Boot from SAS - 32KB L1 instruction and 32KB L1 data cache dedicated for each core. - Boot from USB 2.0 (Floppy, CD-ROM, Hard Disk) - 2MB L2 cache on each processor chip shared by both cores. - Auto configuration and extended setup Chipset - Diskless, Keyboard less, and battery less operation extensions - System, video and LAN BIOS shadowing - North Bridge: Intel E7520 MCH - HDD S.M.A.R.T. support - South Bridge: Intel 6300ESB - Advanced Configuration and Power Interface (ACPI 1.0, 2.0 & 3.0) (advanced Bus interface thermal management such as overheat alarm and auto slow down) - CPUs Front Side bus at 667 MHz, 64-bit data, 36-bit address - Console redirection to serial port (VT100)with CMOS setup access - Field updateable BIOS - Memory bus at 400 MHz, 144-bit data (2 channel) - Event (SERR, PERR, correctable/uncorrectable ECC, POST errors, PCI-Express) - Six onboard PCI-Express x4 log support to IPMC - One onboard 32-bit / 33 MHz for Management Port OS Compatibility - Red Hat Enterprise Linux V.4 and V.5, Wind River Linux Expansion slots - 2 Mid-size advancedMC bays AMC.1 Type 4 compliant – x4 PCI Express, IPMI Features - Management Controller compliant to PICMG 3.0, AMC.0 and IPMI v1.5 rev 1.1. AMC.2 Type E2 compliant – 2 X1000BaseBX Ports, AMC.3 compliant – dual - Management Controller is run time field reprogrammable without payload port SAS/SATA impact. System Memory - Robust fail safe reprogramming implementation (which includes two firmware - Up to 16 GB on 4x240-pin latching DDR-2 400MHz SDRAM (PC2-3200) images) that could perform automatic or manual rollback if a problem occurs during critical reprogramming phase. - ECC support, support S4EC/D4ED when using x4 SDRAM devices - Remote upgrade capability from all IPMI interfaces (CPU Host Interface/IPMB- - 2 DDR-2 channels 0/LAN). Flash Memory - Management Controller self test which can detect failure under its code integ- - Two redundant 2MB BIOS (Field software upgradeable) rity and trigger an automatic rollback. - Can initiate a Host CPU reboot on a redundant BIOS image base on a BIOS- - Roll back functionality controlled by IPMC IPMC handshake result. Storage - Fast interrupt driven SMS host interface compliant to IPMI-KCS v1.5 rev 1.1 - 4 ports SAS available through each AdvancedMC card or through Rear I/O - Serial Over LAN (SOL) redirection of the Host CPU serial controller traffic to - Onboard PATA Flash drive (2GB) enable asynchronous serial-based OS and pre-OS communication via standard RMCP LAN application through the Management Controller. Connectors - Standard Management Controller message bridging to AMC via IPMB-L Front Panel: Serial (RJ-45), Management Lan (RJ-45), USB - Management Controller support standard PCI Hot Plug for PCI-Express AMC. Reliability - Management Controller can initiate standard graceful OS shutdown via ACPI - MTBF: >120 000 hours @40 C / 104 F (Telcordia SR-332, Issue 1) support. - Hardware config that allows activation of the blade or AMC without Shelf - Whole board protected by active breaker Manager intervention. - USB voltage protected by an active breaker Supervisory Safety / EMC - Supports a system management interface via an IPMI V1.5 compliant Designed to meet or exceed: controller - Watchdog for BIOS execution and OS loading (through IPMI watchdog) - Safety: UL 60950-1; CSA C22.2 No 60950-00; EN 60950-1:2001; - Hardware system monitor (voltages, temperature), CPU temperature IEC60950-1 monitor / alarm; board temperature sensor, power failure through IPMC - EMI/EMC: FCC 47 CFR Part 15, Clacc B; CE Mark to EN55022/EN55024 Power Requirements Board Specifications 140 W* -38V @ -72V (Not including RTM and AMC modules) - PICMG 3.0 * The power consumption will vary depending on your product configuration Environmental - PICMG AMC.0 Operating Storage and Transit - PICMG AMC.1 Temperature*: 0 to 55 °C / 32 to 131°F -40 to 70°C / -10 to 158°F - PICMG AMC.2 Humidity*: 5% to 90% @40°C / 104°F 5% to 95% @40°C / 104°F - PICMG AMC.3 non-condensing non-condensing Altitude*: 4 000m / 13,123 ft 15 000m / 49,212 ft Warranty Shock*: 5G each axis Belcore GR-63-CORE Two years limited warranty Section 4.3 Vibration*: 5-500Hz. 1G, each axis 5-50Hz, 2G; 50-500Hz, 3G each axis Airflow: TBD * Designed to meet or exceed. Corporate Offices  Europe, Middle East & Africa North America Asia Pacific Kontron AG Kontron America Asia Pacific Oskar-von-Miller-Straße 1 Corporate Office 4F, No. 415, Ti-Ding Blvd., 85386 Eching/Munich - Germany 14118 Stowe Dr Sec.2, NeiHu District Poway, CA 92064-7147 Taipei, Taiwan 114 Tel.: +49 (0)8165 77 0 Tel. +886-2-2799-2789 Fax: +49 (0)8165 77 279 Tel.: (858) 677-0877 Fax +886-2-2799-7399 Fax: (858) 677-0898 sales@kontron.com sales@us.kontron.com sales@kontron.com.tw www.kontron.com AT8020 V 1.1 02/2008 All data is for information purposes only and not guaranteed for legal purposes. Subject to change without notice. Information in this datasheet has been carefully checked and is believed to be accurate; however, no responsibilty is assumed for inaccurancies. Kontron and the Kontron logo are registered trademarks of Kontron AG. All brand or product names are trademarks or registered trademarks of their respective owners. RoHS compliant logo means that product will be lead-free/RoHS compliant latest by June 30th, 2006. ISO 9001:2000 Quality System Registered.