esd electronics, inc. H A R D W A R E • S O F T W A R E • E N G I N E E R I N G PMC-CPU/440 PowerPCTM PrPMC Module w/Gigabit Ethernet, USB & CAN • PowerPCTM AMCC PPC440EPx • 2x 1000BaseT Ethernet • 2...4x CAN interface, TTL-level signals • 1x RS-232 access via PMC-I/O connector • 1x serial console via USB • 1x USB 2.0 High Speed Interface, host or device • 1x IRIG-B time code interface PMC-CPU/440 TM PMC PowerPC Board The PMC-CPU/440 is a PCI Mezzanine Card that automati- cally switches to monarch (PrPMC) or non-monarch mode ac- TM cording to the system’s requirements. The PowerPC AMCC PPC440EPx with 533 MHz or 667 MHz enables a performance of 1334 DMIPS peak, is equipped with at least 256 Mbyte DDR2 For further information please visit RAM and 256 Mbyte NAND Flash, and offers system time sup- http://www.esd-electronics-usa.com/PMC.html port by RTC (with double layer capacitor) or IRIG-B. For CAN bus synchronization tasks, a high-resolution CAN hardware timestamp is supported. Software Support Connectivity The flash memory carries the open source firmware ‘U-Boot’ The PMC-CPU/440 comes with two Gigabit Ethernet interfaces that enables the PMC-CPU/440 to boot various operating sys- that are accessible as 1000BaseT via RJ45 connectors at the tems from network or on-board Flash, directly and fully sup- front panel. The PMC-CPU/440 provides 2...4 CAN interfaces porting Linux, VxWorks (5.5 and 6.3), OS/9 and QNX on-board controlled by an FPGA IP-Module. The CAN signals are avail- drivers, as well as supporting higher layer protocols like CANo- able as TTL only via PMC connector. External converters from pen and DeviceNet. CAN-TTL to CANISO11898 are available. All CAN interfaces al- low data transfer rates of 1 Mbit/s. An RS-232 serial port is available via the PMC-I/O connector, too. One USB 2.0 interface (host or device) is available at the front panel. growing with the challenge Phone: 800-732-8006 • Fax: 800-732-8093 • Web: http://www.esd-electronics.us • Email: us-sales@esd-electronics.com esd electronics, inc. H A R D W A R E • S O F T W A R E • E N G I N E E R I N G PMC-CPU/440 PowerPCTM PrPMC Module w/Gigabit Ethernet, USB & CAN • PowerPCTM AMCC PPC440EPx • 2x 1000BaseT Ethernet • 2...4x CAN interface, TTL-level signals • 1x RS-232 access via PMC-I/O connector • 1x serial console via USB • 1x USB 2.0 High Speed Interface, host or device PMC-CPU/440 • 1x IRIG-B time code interface For further information please visit http://www.esd-electronics-usa.com/PMC.html Technical Specifications PMC interface and microprocessor General Microprocessor AMCC PPC440EPx, 533/667 MHz, o Ambient temperature 0 ... 50 C (without forced convec- 32 bit tion) Memory >256 Mbyte DDR2 RAM, >256 Mbyte NAND flash, >4 Mbyte NOR Humidity Max. 90%, non-condensing flash Power supply 5 V, 3.3 V RTC EPSON RX8025, backup by double layer capacitor Connectors PMC-connector Pn4: CAN, serial, PCI PCI 2.2, 32 bit 33/66 MHz, signal IRIG-B, I²C; voltage 3.3 V only, Front panel PrPMC acc. to Vita 32, monarch/ 2x Mini-USB (console, host/device), non-monarch 2x 1000BaseT Interfaces Ethernet 2x 1000BaseT, IEEE802.3, RJ45- connector Order information USB USB 2.0 host or device interface at front panel Designation order no. Serial 1x serial console via local USB/ PMC-CPU/440 PrPMC processor V.2027.02 serial converter, AMCC PPC440EPx 533 MHz, 256 MB RAM, 1x RS-232 at PMC-I/O connector 256 MBNAND Flash, 4 Pn4 (4-pin) MB NOR Flash CAN 2...4x CAN, controller FPGA IP PIM-CPU/405 PIM I/O module (acc. V.2025.02 module, ISO11898-1 (CAN 2.0), to Vita 36) with 2x TTL-level signals, CAN ISO11898-2 1 Mbit/s, high resolution CAN- PMC-CPU/440-VxW VxWorks BSP V.2027.30 hardware timestamp (FPGA), PMC-connector PMC-CPU/440-Linux Linux BSP V.2027.32 IRIG-B Digital differential physical layer, PMC-CPU/440-QNX QNX BSP V.2027.33 IRIG B100 time code format, de- coding and time code generation PMC-CPU/440-OS9 OS/9 BSP V.2027.34 esd electronics, Inc. Phone: 800-732-8006 Fax: 800-732-8093 Web: http://www.esd-electronics.us Email: us-sales@esd-electronics.com