NEW Medical 350 Watts EAGLE SERIES Model SMD350 Max. Output Power 350 watts Output Channels Single Output Input Mains Voltage 85 to 264VAC STANDARD FEATURES ELECTRICAL SPECIFICATIONS Input • 4.6 watts/cu.in. power density Input range .................................85 to 264VAC Frequency ..................................47 to 63Hz • Compact size 5.0"W x 7.5"L x 2.38"H Leakage current ………………...Less than 135µA @132VAC and maximum 270µA @264VAC • Power factor corrected to IEC 1000-3-2 Inrush current ...........................37A maximum @ 240VAC • Self contained Fan cover under cold start @ 25°C Efficiency ..................................75% typical at full load • Medical Approved to UL2601, IEC601-1 and EMI filter ....................................CISPR 11 Class “B”, FCC Class “B”, EN55011 Class B CSA 22.2 No. 601.1 Power factor ...............................0.99 typical Output Maximum power.........................350 watts with top mounted ENVIRONMENTAL fan cover assembly. Hold-up time...............................16 ms @ 350 W load, nomi- Operating temperature: 0°C to 50°C derate output nal line (115VAC) power at 2.5% per degree from 50° to 70°C Overload protection ...................Fully protected against short circuit and output overload. Automatic recovery Storage temperature: -40°C to 85°C Overvoltage protection ..............10% to 25% above nominal output. Latches off. Recycling AC power will reset the latch Logic Control Temperature coefficient: ± 0.03% per °C Power failure ............................TTL active high, goes low 5 msec before loss of regulation EMI compliance to CISPR 11 Class B External/off ............................... A logic low shuts down the power converter Humidity: Operating; non-condensing 0% to 95% DC OK .......................................TTL active high @ 90%of output regulation MTBF calculated: 179,000 hours at full load 25°C Remote sense ...........................Compensates for 0.5 V lead drop minimum. Will operate without remote sense connected ambient conditions per MIL-HDBK-217F, Notice 2 15481 Electronic Lane  Huntington Beach, CA 92649  (714) 898-6551  Fax: (714) 894-9248 e-mail: sales@cdipower.com  www.cdipower.com Conversion Devices, Inc. Medical Power Supplies since 1981 EAGLE SERIES ORDERING INFORMATION Model Output Maximum Minimum Typical Ripple Voltage 1 2 Number Voltage Current Load Regulation P/P (PARD) Adjust SMD350-24-C 24VDC 14.5A 0A ± 1% 240 mV ± 5% SMD350-28-C 28VDC 12.5A 0A ± 1% 280 mV ± 5% SMD350-30-C 30VDC 11.7A 0A ± 1% 300 mV ± 5% SMD350-36-C 36VDC 9.7A 0A ± 1% 360 mV ± 5% SMD350-48-C 48VDC 7.3A 0A ± 1% 480 mV ± 5% Notes: 1) Other voltage and current combinations are available. Consult with factory representative for details 2) Measured with 20MHz bandwith at nominal line full load I/O CONNECTORS MECHANICAL AC POWER INPUT (TBI) 5.00" 1.75" TERMINAL # REFERENCE TB2 1 AC LINE 1 2 3 4 5 J1 J2 2 AC NEUTRAL Vout Vout RTN RTN 3 AC GROUND NOTE: 6-32, 3 Pin Terminal Block DC OUTPUT POWER (TB2) 8-32 MOUNTING HOLES IN 8 LOCATIONS TERMINAL # REFERENCE 7.00" 1 VOUT + 7.50" 2 VOUT + 3 RETURN TOP MOUNTED FAN COVER AIRFLOW 4 RETURN 3.320" NOTE: 6-32, 4 Pin Terminal Block L N G SIGNAL INTERFACE (J2) Connector type AMP 640456-5 TB1 .488" .850" Mating connector AMP 640440-5 3.530" 2.388" TERMINAL # REFERENCE 1 DC GOOD NOTES 2 POWER FAIL a. Other output voltages available upon request. Contact CDI Sales b. All specification detail is subject to change without notice 3 EXT OFF c. All dimensions in inches, tolerance is ±.02” 4 SENSE + d. Specifications are at factory settings e. Mounting maximum insertion depth is 0.12” 5 SENSE - f. Warranty: 1 year 15481 Electronic Lane  Huntington Beach, CA 92649  (714) 898-6551  Fax: (714) 894-9248 e-mail: sales@cdipower.com  www.cdipower.com Rev. X1 AIRFLOW AIRFLOW FAN COVER 8-32 MOUNTING HOLES IN 4 LOCATIONS