Rugged TVME6100-R Single Board Computer The TVME6100-R is the first board to utilize the Tundra Tsi148 interface chip for 2eSST VMEbus performance. The 2eSST protocol enables up to 320MB/s VMEbus bandwidth for most applications. It is enhanced to withstand shock and vibration extremes in excess of the original Motorola SBC specification. Conformally coated, this rugged solution is designed for use in critical embedded systems deployed in the most demanding military and industrial environments. Key Environmental Features: „ Qualified to environmental standards of MIL STDs 810F, 901D and 167, and 461 „ Shock: MIL STD 810F, 45g’s at half- sine 20 ms „ Vibration: MIL STD 167, 5g’s at 50 to 500Hz sine and .05g²/Hz at 15Hz to 2KHz random „ Conformal Coating per MIL STD I-46508, urethane „ Operating temperature: 0°C to +55°C „ Altitude: -1,500 ft to 11,000 ft „ Humidity: 5% to 95% non-condensing with resistance to salt fog „ Ask about our extensions to any environmental standards TVME6100-R Features: ‹ ‹ 2eSST VMEbus protocol with 320MB/s transfer rate across the VMEbus ® ‹ MPC7457 PowerPC processor at 1.267 GHz ‹ 256KB of on-chip L2 cache and 2MB of L3 cache ‹ 128-bit AltiVec™ coprocessor for parallel processing, ideal for data-intensive applications ‹ Up to 2GB of on-board DDR ECC memory and 128MB of Flash memory for demanding applications ‹ Two 33/66/100 MHz PMC-X sites allow the addition of industry-standard, application specific modules ‹ Dual Gigabit Ethernet interfaces for high performance networking ‹ I/O compatibility with MVME51xx family ‹ Single VME slot even when fully configured with two PMC modules or one PMC module and an add-on memory mezzanine ‹ Support for processor PMCs (PrPMCs) COTS Systems By Design Single Board Computer I/O Storage Chassis Design, Software & Documentation (800) 445-6194 • www.acttechnico.com ACT/Technico • One Ivybrook Blvd., Suite 180 Ivyland, PA 18974 • Tel (215) 957-9071 • Fax (215) 957-9074 SBCs built with surface mount technology can often meet the demands of rugged environments. The Motorola SBCs can be modified to meet environmental conditions as specified by MIL- STD-810. The boards are physically modified to pass 810 Shock and Vibration testing and electrically modified to meet front panel isolation requirements. ACT/Technico’s PMC Modules can also be modified to meet the same specifications. ACT/Technico can help you extend the application of ® Motorola COTS hardware by making mechanical enhancements and providing test services and qualification data. Board Description ACT/Technico Temperature Cycle Chamber The TVME6100-R delivers high levels of computing power with Testing Motorola’s PowerPC architecture. This rugged solution offers superior ACT/Technico’s ruggedized SBC products are tested according to shock and vibration protection and is conformal coated. The TVME6100- MIL-STDs 810F, 883, 467, 901D and 167; NEBS, and others as R can provide excellent performance in a wide array of military applica- applicable. Complete documentation packages address product tions including fixed ground installations such as radar, communications, qualification, validation and manufacturing processes. ACT/ and artillery support equipment in facilities with limited protection from Technico warrants all ruggedized products and specification the elements. Mobile ground applications include vehicle mounted extensions for use in the target application environment. equipment supporting mission critical communications, tactical artillery support, radar, ground penetrating radar and data collection. In ground Sample random vibration test profile ACT/Technico Test Fixture applications, suitably applied conformal coatings resist the effects of dust, sand and other containments. Ship borne applications for the TVME6100-R expose equipment to the combined effects of shock, Baseline Motorola MVME6100 Specifications vibration, and atmospheric contaminants — including salt mist. In MVME6100 Processor Module addition to the day-to-day pounding a ship propulsion control system Processors endures, ship borne applications must survive shock levels resulting from Microprocessor: MPC7457 the effects of conventional or nuclear weaponry. Rotary winged aircraft Clock Frequency: 1.267 GHz can rely on the TVME6100-R to perform mission critical tasks in On-chip L!/L2 Cache (I/D): 32K/32K demanding environments. Users requiring a “technology refresh” for their On-chip L3 Cache: 2 MB application, while maintaining backwards compatibility with their existing System Controller: Marvell MV54360 (Discovery II) VMEbus infrastructure, can upgrade to the MVME6100 series and take advantage of its enhanced performance features. Main Memory Double data-rate (DDR) ECC SDRAM running at DDR266 (133 MHz) speed. Two banks of memory in configurations of 512MB, 1GB, 2GB. (512MB or 1GB configurations are available at initial release) Flash Memory 128MB of soldered Flash in two banks of 64MB each. Flash is write protectable via a jumper VMEbus Interface Tundra Tsi148 PCI-X bus to VMEbus bridge with support for VME64 and 2eSST protocols for support of data transfer speeds on the VMEbus of 320MB/sec Sample shock test profile Ethernet Interfaces Board Size Dual 10/100/1000Mb/s Ethernet interfaces. One routed to the front Height: 233.4 mm (9.2 in.) panel RJ-45 connector. One routed to a front panel RJ-45 connector Depth: 160.0 mm (6.3 in.) or optionally routed to the P2 connector (jumper selectable) Front Panel Height: 261.8 mm (10.3 in.) Width: 19.8 mm (0.8 in.) Asynchronous Serial Ports Max. Component Height: 14.8 mm (0.58 in.) Dual 16550 compatible serial ports. One routed to a front panel RJ-45 Operating Systems and Kernels connector. One routed to a planar 10-pin connector.\ MVME6100 supports booting a variety of operating systems: Dual IEEE P1386.1 PCI Mezzanine Card Slots (PMC) Wind River Systems: VxWorks Dual PMC slots supporting PCI bus speeds of 33 MHz, 66 MHz or 100 LynuxWorks: BlusCat Linux, LynxOS (Do-178) MHz. TimeSys: Linux PCI Expansion Electromagnetic Compatibility (EMC) 32/64-bit, 33/66 MHz PCI connection via a 114-pin connector to Intended for use in systems meeting the following regulations: support PCI expansion carriers such as the Motorola PMCspan U.S.: FCC Part 15, Subpart B, Class A (non-residential) Counters/Timers Canada: ICES-003, Class A (non-residential) TOD clock, four 32-bit programmable timers/counters and a watchdog timer This product was tested in a representative system to the following standards: CE Mark per European EMC Directive 89/336/EEC with Power Requirements +5V ± 5% Amendments; Emissions: EN55022 Class B; Immunity: EN55024 MVME6100-0163: TBD Safety MVME6100-0163 with IPMC712/761: TBD All printed wiring boards (PWBs) are manufactured with a flammability Note: In a 3-row chassis, PMC current should be limited to 19.8 watts rating of 94V-0 by UL recognized manufacturers. (total of both PMC slots). In a 5-row chassis, PMC current should be limited to 46.2 watts (total of both PMC slots). MVME6100 Block Diagram Transition Modules Complete Rugged System Solutions ACT/Technico offers single slot rear transition module solutions ACT/Technico offers a complete line of rugged supporting products in compatible with both 3-row and 5-row connectors.The following form factors ranging from mezzanines to rear I/O to 3U and 6U boards. features are standard: System level ruggedization and qualification services are available as pre-defined rugged systems. Specification extensions can be tailored • 6U x 80mm form factor integral SCSI connector for specific environments on all products. Visit www.acttechnico.com • Four serial ports via RJ45 connectors (DTE/DCE jumpers on- for additional information. board and modem support) • Parallel port header • Locking front panel-mount AUI connector • SCSI Centronics connector, with removable SCSI termination resistor networks • On-boardCentronics parallel port header • LED indicators for SCSI termination and Ethernet power MBIT GUI Web Based Diagnostics This Built-In self-Test (BIT) tool provides a Web based control of PMC Modules Motorola’s Built-in Test Diagnostic Software. It also provides a GUI We offer a wide selection of PMC Modules. Some models can be based point and click test selection, and color coded test status with modified to meet the above ruggedization specifications, such as the an automatic update. It is compatible with Netscape and Internet PMCStor and PMCDisk, Audio, SCSI, and various communications Explorer. controllers. Solid State PMCDisk Audio PMC Order Information Please use the part numbers below to order your rugged TVME6100. Standard part number includes conformal coating. Choose between Scanbe or IEEE handles. For additional configurations, Transition Modules, PMCs, and any additional products, please refer to their datasheets, or call us for assistance. Pn art Number Descriptio TVME6100-0161-R 1.267 GHz MPC7457 processor, 512MB DDR memory, 128MB Flash, Scanbe handles TVME6100-0163-R 1 GHz MPC7455 PowerPC processor, 512MB SDRAM, IEEE handles TVME6100-0171-R 1.267 GHz MPC7457 processor, 1GB DDR memory, 128MB Flash, Scanbe handles TVME6100-0173-R 1.267 GHz MPC7457 processor, 1GB DDR memory, 128MB Flash, IEEE handles Documentation Documentation is available for online viewing and ordering at http://www.motorola.com/computer/literature One Ivybrook Blvd., Suite 180 Ivyland, PA 18974 Tel (215) 957-9102 Fax (215) 957-9074 www.acttechnico.com Motorola is a registered trademark of Motorola, Inc. Printed in USA - TVME6100R-PDF-05/05