Preliminary datasheet TQMa53 The Multimedia module � Graphic The Minimodule TQMa53, based on the processor i.MX537 � Extended temperature range from Freescale, combines Industry and Multimedia. The � eMMC Flash integrated graphic controller supports displays with a � Low power consumption (typ. 3 W) resolution up to UXGA. Therefore the module is best suited � Long-term availability for HMI and animated display screen- and accordingly � IEEE 1588 Support multitouch applications. � Security functions With an ARM Cortex™ A8 core and a clock rate up to 1,2 GHz the TQMa53 provides a balanced ratio between performance and power dissipation. CortexA8 (i.MX53) CortexA8 (i.MX53) DDR3‐SDRAM DDR3‐SDRAM Core@800MHz (1‐1,2GHz Consumer) Core@800MHz (1‐1,2GHz Consumer) 32KB i /d cache, 512kB L2‐Cache  32KB i /d cache, 512kB L2‐Cache  eMMCFlash eMMCFlash 512 kBL2‐Cache 512 kBL2‐Cache SecureBoot (HAB), cryptographicaccelerators EEPROM SecureBoot (HAB), cryptographicaccelerators EEPROM Ethernet  Ethernet  Graphic Graphic SATA SDIO/MMC CAN SATA SDIO/MMC CAN RTC RTC 1600x1200 IEEE1588 1600x1200 IEEE1588 Local‐ Local‐ UART Camera IF USB 2.0 I²S, I²C, SPI UART Camera IF USB 2.0 I²S, I²C, SPI Power Power bus bus 3.3 V Module connector240 Pins Module connector240 Pins Technical specification Ordering information (preliminary, tbd) Estimated availability of prototypes: Q1/12 Microprocessor MCIMX537 / MCIMX535 TQMa53-AA TQMa53, i.MX537 / 800MHz, 2GB eMMC Flash, 256MB DDR3, System interfaces 64kB EEPROM, -25°C …+85°C 1x Ethernet 10/100 Mbit (IEEE 1588) 2x FlexCAN TQMa53-AB Up to 5x UART TQMa53, i.MX537 / 800MHz, 2GB eMMC Flash, 512MB DDR3, 2x USB 2.0 high speed Host interface 64kB EEPROM, -25°C…+85°C Periphery interfaces STKa53-AA 1 WEIM Bus* STKa53 (Eval Kit) with TQMa53-AA, i.MX537 / 800MHz, Up to 3x SDIO/MMC 256MB DDR3, 2GB eMMC Flash, 64kB EEPROM, Up to 2x I2C 1x RS232, 1x RS485 ,GPIO 4xIN / 8xOUT, 2 x CAN 2.0B Up to 3x CSPI separated, 2x USB 2.0 HOST, 2x ETH 10/100, CRT, 2x LVDS, Up to 3x SSI/I2S Stereo OUT, Mono Mic In, RTC, Temperature sensor, Reset- ESAI Button, SD-Interface, Power Supply, 2GB SD-Card, Tools CD, 1x 16 bit Camera I/F Z-Modem Cable SATA SPDIF STKDT070-AA 7" Touch-Display, WVGA 800x480, 300cd, Touchpen, Cable Graphic set Analog VGA 1 Parallel 1x 24 bit (RGB) UXGA* Starterkit STKa53 Set Dual LVDS UXGA The core of the STKa53 Set is the TQMa53 with the i.MX53 Memory CPU from Freescale. The components contained in the starter DDR3-SDRAM: up to 512 MB kit constitute a modular system enabling you to develop eMMC: up to 32 GB your own product ideas. Development of graphic interfaces EEPROM: 0 / 64 kbit can be started immediately using the prepared combination of closed display unit and starter kit that are matched to each Other other. To develop your own hardware you can use the Real Time Clock (RTC) certified and qualified circuit components of the starter kit in Temperature sensor your own designs. CPU JTAG Interface Power supply 5 V Ambient conditions Standard temperature range: 0°C…+70°C Extended temperature range: -25°C…+85°C Dimensions 60 x 44 mm2 (TBD) Plug-in system Board-to-board plug-in system 240 Pins (TBD) Operating system s WEC 7, Linux, Android TQ-Systems GmbH | Gut Delling | Mühlstraße 2 82229 Seefeld | Germany | Phone: +49 8153 9308-0 Fax: +49 8153 9308-134 | info@tq-group.com www.tq-group.com 1 Optional WEIM bus or parallel 24 bit graphic interface usable * Technology in Quality ©TQ-Systems GmbH 2010 l Subject to alterations l Data sheet: TQMa53 Product characteristics Rev.004.doc l Preliminary datasheet