Battery

Built-in lithium battery is provided, for ten years of data retention for CMOS memory

BIOS (Flash)

AMIBIOS w/built-in advanced CMOS setup, peripheral management for configuring on-board peripherals, PCI-to-PCI bridge support and PCI interrupt steering

Bus Interfaces

ISA and PCI Local Bus compatible;

BUS SPEED - ISA

8.33MHz;

BUS SPEED - PCI

33MHz or 66MHz

BUS SPEED - SYSTEM & MEMORY

133MHz Front Side Bus

Cache Memory

Pentium III processors include integrated on-die, 256K or 512K 8-way set L2 cache architecture w/256-bit wide bus and include a 16K L1 instruction cache and 16K L1 data cache

Data Path

DRAM/Memory - 64-bit; ISA Bus - 16-bit; PCI Bus - 32-bit or 64-bit; Video - 32-bit;

DMA channels

Fully PC compatible with seven DMA channels, each supporting type F transfers.

DRAM Memory

Consists of two DIMM sockets and supports auto detection of memory up to 2GB of SDRAM

Enhanced Parallel Interface

Provides a PC/AT compatible bidirectional parallel port and supports EPP mode and ECP mode, which is IEEE 1284 compliant

ERROR CHECKING AND CORRECTION

Supports ECC modes via BIOS setting

Floppy Drive Interface

Supports two floppy disk drives, can be 360K to 2.88MB, in any combination

Humidity

5% to 90% non-condensing

Interrupts

Fully PC compatible with interrupt steering for PCI plug and play compatibility.

Keyboard Interface

Compatible with an AT-type keyboard

Operating Temperature

0º C. to 50º C. for 1.26GHz and above; 0º C. to 45º C. for 1.0GHz; 0º C. to 50º C. for 933MHz; 0º C. to 60º C. for 866MHz and below

PCI 10/100BASE-T ETHERNET INTERFACES(DUAL)

Intel 82559 Ethernet controllers operating in 10Base-T and 100Base-TX Fast Ethernet modes compliant with IEEE 802.3 and PCI Local Bus 2.1 Specifications

PCI ENHANCED IDE INTERFACES(DUAL)

Capable of supporting two IDE disk drives each in a master/slave configuration supporting Ultra DMA/33 SDMA mode transfers up to 33MB per second

PCI SCSI INTERFACE

Supports Ultra3 SCSI data transfer using QLogic's ISP10160A SCSI controller,supports SCSI data transfer up to 160MB per second, and the interface is Ultra3 LVD

Power Fail Detection

A hardware reset is issued when on-board +5V voltage drops below 4.75 volts and if the 3.3V Monitor jumper (JU15) is enabled, a reset is issued if 3.3V is below tolerance

Power Requirements

+5V Typical - 1.26GHz-14.95 Amps, 1.0GHz-14.02 Amps, 1.0GHz-13.6 Amps, 866MHz-11.4 Amps, 733MHz-10.5 Amps,667MHz-7.8 Amps; +12V@500mAmps; +12V@600 mAmps; -12V@

Processors

Two Intel? Pentium? III microprocessors - 1.4GHz, 1.26GHz or 1.13GHz with 512K cache; 1.0BGHz, 933MHz, 866MHz, 800EBMHz, 733MHz, 667MHz or 600EBMHz with 256K cache; Processors use the Socket 370 Flip Chip Pin Grid Array (FC-PGA) packaging

PS/2 Mouse Interface

Compatible with a PS/2-type mouse

Serial Interface

Supported by two high-speed FIFO (16C550) serial ports with independently programmable baud

SMP

Uses applications which are divided into threads which can run concurrently on any available processor improving performance of the application itself as well as the total throughput of the system

Storage Temperature

-40º C. to 70º C

Super VGA Interface

Intel 69030 HiQVideo video interface integrating 4MB of high-speed SDRAM frame buffer memory into the chip

System & Memory Buses

ServerWorks ServerSet III LE chipset supports the system and memory buses at 133MHz

System Hardware Monitor

Yes

USB

Supports two USB 1.0 ports for serial transfers at 12 or 1.5Mbit/sec

Watchdog Timer

2 Levels