CS Family n Operation Model CS-1 On or Off Delay On or off delay timing is se- lected by a switch. On delay mode: Turn on of the output is delayed by a set time interval from the time of detec- tion. The output is turned off instantaneously when detection ceases. Off delay mode: Turn on of the output is instantaneous upon detection. When detection ceases, turn-off of the output is delayed by the set time. Timing can be set between 0.12 and 12 seconds. Input Signal On Delay Output CS Family CS Family Off Delay Output T= Delay Time, On or Off Control Signal Cards nWide variety of timing functionsnStopped Motion Detector Model CS-2 On and Off Delay On and off delays are both nOn DelaynMounts in 205, 225, and 295 available (see CS-1 above) with Family Amplifiers, and independent adjustments for on nOff Delay PartScan™ power supply delay time and off delay time. If the input does not persist for the nOne-Shot duration of the on delay time, no output is produced. nDelayed One-Shot Timing for each delay can be set between 0.12 and 12 seconds. Input Signal Output T T on off T = On Delay Time T = Off Delay Time on off Scientific Technologies Inc. STI Scientific Technologies GmbH R Fremont, CA Freiburg, Germany Tel. 1/510/608-3400 1/888/510-4357 Tel. +49-761-455 26 0 B38 photoelectric sensors photoelectric sensors CS Family Model CS-3 One Shot Timer Model CS-6 One Shot withn Ordering Upon detection the output is Override turned on for a fixed time period The output is turned on imme- Except where noted, all CS regardless of the duration of the diately upon detection and stays cards can be used with any detection. Multiple detections on for a fixed duration of time. If sensors using separate amplifiers occurring before the end of the detection continues after the time AXRP205, AXRP225, AXRP295, time period are ignored. period, the output stays on until and AMB Families, and the self- Timing can be set between 0.12 detection ceases. If detection contained 10 Family Sensors. and 12 seconds. ceases before the end of the time period, the output is on for the Model Function Input Signal fixed time period, even if detec- CS-1 Timer - On or Off delay Output tion recurs during the time period. CS-2 Timer - On and Off delays The time period is adjustable CS-3 Timer - One shot T T from 0.12 to 12 seconds. CS-5 Timer - Delayed One Shot T = One Shot Time CS-6 Timer - One Shot with Override Input Signal CS-7 Stopped Motion Detector Output Model CS-5 Delayed One Shot Upon detection, a time interval TT Checklist T = One Shot Time elapses after which the output is To verify you have all the turned on for a second period of components need for your sensor time, regardless of the duration of control system, refer to the the detection. Model CS-7 Stopped Motion amplifier and sensor sections of Each time period is adjustable Detector this catalog. from 0.12 to 12 seconds. Upon detection, the output is turned off. If objects are continu- Wiring Input Signal ously detected at a regular rate, The CS Control Signal cards the output remains off. If detec- Output plug directly into connectors on tion rate falls below the set rate, T T T T 1 2 1 2 the amplifier and sensor circuit the output is turned on and boards. No additional wiring is T = Delay Time T = One Shot Time 1 2 remains on until the next detec- needed. tion occurs. The detector is adjustable for ! Caution! STI photoelectric sensors are not objects occurring between 0.12 designed for and should never be used for and 1.2 seconds (not a misprint). personnel protection (safety) applications. STI has Missing Detection a wide range of special safety products designed for use in these applications. Refer to the safety Input Signal products catalog or contact STI for information on our safety products. Output Time Period For the Latest Information Try Our Fax Back System at 1/916/431-6544 On the Internet: www.sti.com E-mail: sales@sti.com Scientific Technologies Inc. STI Scientific Technologies GmbH R Fremont, CA Freiburg, Germany Tel. 1/510/608-3400 1/888/510-4357 Tel. +49-761-455 26 0 B39 OS Family n Operation Model OS-2 Solid State AC Switch Description: Optically isolated, single-pole single-throw solid state AC device Maximum Load: 3 A maximum at 125 VAC. May be used with inductive loads. Response Time: 8 ms Operation: Can be set for normally open or normally closed operation. Estimated life is 10 million operations at 1 A induc- tive, or 500,000 operations at 3 A inductive. CS Output OS Family OS Family Note: Contact shown for convenience. Actual device is solid-state AC switch. Output Signal Cards Model OS-3 HTL Negative nMany output options switchnAnalog Output Logic Solid State DC Switch virtually any kind of electrical Description: NPN transistor loadnPlug-in design for easy installa- output with pull-up resistor. tion Output is +15 VDC through 1 k nElectromechanical relays resistor or 0 VDC. nMounts in AXRP205, 225, and Maximum Load: Sinks 100 mA nSolid-state AC and DC outputs 295 Family Amplifiers, and at 15 VDC maximum PartScan™ power supply Response Time: 10 μs nLatching relay +15 V 1k ohm Output CS Scientific Technologies Inc. STI Scientific Technologies GmbH R Fremont, CA Freiburg, Germany Tel. 1/510/608-3400 1/888/510-4357 Tel. +49-761-455 26 0 B40 photoelectric sensors photoelectric sensors OS Family Model OS-4 TTL, DTL Negative Model OS-7SB Electromechan- Model OS-B Light Duty Solid Logic Solid State DC Switch ical Relay with Snubbers State DC Switch Description: NPN transistor Description: Double-pole Description: Optically isolated output with pull-up resistor and double-throw relay; snubbers NPN transistor clamping Zener diode. Output is limit contact arcing Maximum Load: 20 mA at 50 +5 VDC or 0 VDC. Maximum Load: 5 A inductive VDC. Not for use with inductive Maximum Load: Sinks 100 mA at 125 VAC loads 5 VDC maximum Response Time: 9 ms Response Time: 500 μs Response Time: 10 μs S S +15 V CS CS Output S S 1k ohm Output Model OS-8 Heavy Duty CS Vz = 5.1 Solid State DC Switch Model OS-F Solid State Description: Open collector AC/DC Switch NPN transistor. Protected against Description: Optically isolated Model OS-7 DPDT shorted loads. field effect transistor (FET) Electromechanical Relay Maximum Load: Sinks 1 A Maximum Load: 100 mA at 120 Description: Double-pole maximum at 50 VDC VAC or VDC double-throw relay Response Time: 10 μs Response Time: 3 ms maximum Maximum Load: 5 A resistive at for loads greater than 5 mA; 5 ms 125 VAC for smaller loads. CS Output Response Time: 9 ms Off-State Leakage: Less than 1 μA at rated load voltage. Model OS-A SPDT Reed Relay CS CS Output Description: Single-pole single- throw reed relay for dry loads (low current, low voltage) Maximum Load: 20 VA resistive; snubbers limit contact arcing. Response Time: 5 ms S CS S For the Latest Information Try Our Fax Back System at 1/916/431-6544 On the Internet: www.sti.com E-mail: sales@sti.com Scientific Technologies Inc. STI Scientific Technologies GmbH R Fremont, CA Freiburg, Germany Tel. 1/510/608-3400 1/888/510-4357 Tel. +49-761-455 26 0 B41 OS Family Model OS-L SPDT Latching Model OS-T Heavy Duty DPDT Model OS-V Analog Voltage Relay with Snubbers Electromechanical Relay Output Description: Single-pole double- Description: Double-pole Description: Analog voltage throw relay with electronic double-throw relay ranges from -10 to +10 VDC and latching circuit Maximum Load: 10 A resistive is proportional to the light level Maximum Load: 5 A at 120 VAC at 125 VAC detected by the receiver. inductive; snubbers limit arcing Response Time: 10 ms. Approxi- Maximum Load: 10 mA Response Time: 9 ms mate life is 10 million operations +10 V Operation: Relay latches upon at 1 A or 500,000 operations at low input signal and remains 7 A. 0 latched until reset signal (low) is applied. -10 V Light Detected CS S CS S Reset Model OS-TSB Heavy Duty Reset Ground DPDT Electromechanical Relay with Snubbers Description: Double-pole double-throw relay Maximum Load: 10 A inductive at 125 VAC; snubbers limit contact arcing Response Time: 10 ms Operation: Approximate life is 10 million operations at 1 A or 500,000 operations at 7 A. S S CS S S Scientific Technologies Inc. STI Scientific Technologies GmbH R Fremont, CA Freiburg, Germany Tel. 1/510/608-3400 1/888/510-4357 Tel. +49-761-455 26 0 B42 photoelectric sensors photoelectric sensors OS Family n Ordering Solid State Output Devices Output Type Voltage Controlled Maximum Current Maximum Voltage Response Time Model Number Switch AC or DC 100 mA 120 VAC or VDC 3 ms OS-F Switch AC 3 A 125 VAC 8 ms OS-2 Switch DC 1 A 50 VDC 10 μs OS-8 Switch DC 100 mA 15 VDC 10 μsec OS-3 Switch DC 100 mA 5 VDC 10 μsec OS-4 Switch DC 20 mA 50 VDC 500 μs OS-B Analog DC 10 mA Voltage is proportional 8 ms OS-V to light level Electromechanical Relay Output Devices Contact Form Type Maximum Load Response Time Model Number DPDT Medium duty for resistive loads 5 A resistive at 125 VAC 9 ms OS-7 3 A inductive at 125 VAC DPDT Medium duty for inductive loads 5 A inductive at 125 VAC OS-7SB DPDT Heavy duty for resistive loads. 10 A resistive 10 ms OS-T DPDT Heavy duty for Inductive loads 10 A inductive 10 ms OS-TSB SPDT Reed relay for light loads. 20 VA 5 ms OS-A SPDT Latching relay. 5 A resistive at 125 VAC 9 ms OS-L ! Caution! STI photoelectric sensors are not Checklist designed for and should never be used for To verify you have all the components need for your sensor control personnel protection (safety) applications. STI has system, refer to the amplifier and sensor sections of this catalog. a wide range of special safety products designed for use in these applications. Refer to the safety Wiring products catalog or contact STI for information on The OS Output Signal cards plug directly into connectors on the our safety products. amplifier and sensor circuit boards. All wiring is made directly to the terminal blocks on the amplifier or sensor circuit board. Refer to the amplifier section for specific connection information. For the Latest Information Try Our Fax Back System at 1/916/431-6544 On the Internet: www.sti.com E-mail: sales@sti.com Scientific Technologies Inc. STI Scientific Technologies GmbH R Fremont, CA Freiburg, Germany Tel. 1/510/608-3400 1/888/510-4357 Tel. +49-761-455 26 0 B43