XMAT200 Medical Power Supply FEATURES: 204-watt, medically approved switching power supply FCC Class B and CISPR11 Class B Power good signal 115/230 switch-selectable ac input Fully enclosed with fan Industry-standard size UL2601 and IEC601 approved Ac inlet; flying lead ac on/off switch marked to LVD SPECIFICATIONS: Ac Input Overvoltage Protection 90-132 or 180-264 Vac, 47-63 Hz (internal switch Output #1: output level exceeding 6.2 V ± 0.4 V causes selectable). Order "—110" for 115 Vac input or "—220" for shutdown, automatic recovery. 230 Vac. Hold-up Time Dc Outputs 20ms after loss of nominal ac input for specified load Nominal; see ratings table. Range: output #1 adjustable regulation. 5%; output #2 tracks output #1. Power Good Maximum Output Power TTL compatible output. Output delay 100 to 500 ms at 204.5 W power up. Upon loss of ac input, signal drops to TTL low > 5 ms before loss of output regulation. Efficiency Storage 75% nominal. -40 to +85°C. Ripple EMI Measured at end of connectors with 20 MHz bandwidth, Meets both FCC Class B and CISPR11 conducted EMI. 1:1 probe, with 0.1 and 10 µF across output. Medical Safety Leakage Temperature Coefficient Less than 75 µA @ 132 Vac. 0.02%/°C, all outputs Power On/Off Temperature Range Power on/off is accomplished by an on-standby circuit in Operation: 0 to 50°C at rated output power; derates the power supply. The switch has no ac flowing through it, linearly to 50% power at 70°C. Storage: -55°C to 85°C. and one side of the switch is at chassis ground potential. There is no ac power flowing inside the computer case, Switching Frequency only inside the power supply. 100 kHz Monitor Output Fusing The XMAT200 supply does not have a monitor output like 6 A/250 V for 115/230 Vac both lines. typical PC/AT supplies since it would constitute a poten- tial safety hazard. The leakage current of the monitor Inrush Surge would add to the leakage current of the supply and 20 A pk/115 Vac, 40 A pk/230 Vac. potentially exceed the 100 µA UL544 specification limit. The monitor should be UL544 approved and plugged into Weight a separate outlet. 4.5 lbs. Ac Cord Overload Protection The ac cord is user-supplied; must be UL544 approved All outputs protected through short circuit conditions; for medical use. automatic recovery. Condor D.C. Power Supplies, Inc., 2311 Statham Parkway, Oxnard, CA 93033 800-235-5929 • 805-486-4565  FAX 805-487-8911  www.condorpower.com 108 XMAT200 Medical Power Supply Medical Output Minimum Load Range Maximum Surge Total Regulation Ripple PK-PK Maximum Output +A 5 V 3A .5 20 – +V 3.5% 50 m +A 12 V 1A .0 8A9%+V 5 100 m -A 12 V 0A 0.5 – +V 5% 100 m -A 5 V 0A 0.5 – +V 5% 50 m XMAT200 MECHANICAL SPECIFICATIONS: Condor D.C. Power Supplies, Inc., 2311 Statham Parkway, Oxnard, CA 93033 800-235-5929  805-486-4565  FAX 805-487-8911  www.condorpower.com 109