GXM60 Medical Single Output 60 Watt-Range Input High Efficiency Desk-Top Supply FEATURES: Universal Input Small size, light weight Medically approved to UL2601-1, CSA 22.2 No. 601.1-M90, EN60601-1, and CB certified to IEC601-1. Ultra efficient - Up to 90% Spill proof external enclosure 2 year warranty • marked to LVD SPECIFICATIONS: AC INPUT EFFICIENCY 90-264 Vac, 47-63 Hz single phase. Input power is less than 75 77 to 90% at full rated load depending upon model and ac line. W when output power is less than 60 W, 230 Vac in. Meets Units are typically > 85 % @ 230 Vac. Efficiency is measured at EN61000-3-2 harmonics standard. the supply output, cabling losses are not considered and will OUTPUT POWER vary with different cables. Contact factory for assistance. Total continuous output power is 60 W (55 for any unit less than OVERSHOOT 8 V), 65 W peak for 60 s 10% duty cycle. Total power specified Less than 3% overshoot at turn-on under nominal conditions. from supply output, derate for cable losses. TURN-ON TIME OUTPUT REGULATION Less than 1.5 s at 115 Vac, 25 °C Supply regulation is +/- 1%. However, actual regulation limits are INPUT PROTECTION affected by cable losses on units without remote sense. Final Both lines protected with internal ac fuses, provided on all units. regulation limits must include cable losses. Contact factory for Designed to blow only if a catastrophic failure occurs in the unit assistance. — Fuse does not blow on short circuit or overload. INPUT CURRENT INRUSH CURRENT Maximum input current at minimum input voltage and output Inrush is limited by internal thermistor. The inrush at 240 Vac, overload will be less than 2.0 A. averaged over the first ac half-cycle under cold start conditions HOLD-UP TIME will not exceed 60 A. Output voltage stays within regulation for 20 ms from loss of ac EMI / EMC COMPLIANCE input at full load, from 120 Vac input. All models include built-in EMI filtering. MINIMUM LOAD Conducted Emissions EN55011, Class B; FCC Class B No minimum load required. Static Discharge EN61000-4-2, 6 kV contact 8 kV air OVERLOAD PROTECTION RF Field Susceptibility EN61000-4-3, 3V/meter Fully protected against short circuit and output overload. Short Fast Transients / Bursts EN61000-4-4, 2 kV, 5 kHz circuit protection is cycling type power limit and will automatically Surge Susceptibility EN61000-4-5, 1 kV diff., 2 kV com. recover after removal of fault. Conducted RF Susceptibility EN61000-4-6, 3V OUTPUT NOISE Voltage Sags & Surges EN61000-4-11 0.5% rms, 1% pk-pk, 20 MHz bandwidth, differential mode. MEDICAL SAFETY AGENCY Measured with a scope probe directly across the output All models are approved to UL2601, CSA 22.2 No. 601.1-M90, connector. Load terminated with a 0.1 µF capacitor in parallel IEC 601-1 (1988), EN 60601-1 with a low Z 10 mF capacitor. LEAKAGE CURRENT TRANSIENT RESPONSE 80 µA under normal conditions (132 Vac @ 60 Hz ). Maximum Response at supply is 1.5 ms typical for return to regulation for under single fault conditions (264 Vac @ 50 Hz) is 170 µA . a 50% load step, Δi/Δt< 0.2 A/µs. Maximum voltage deviation is 3.5%. Cable resistance will effect maximum voltage deviation. Environmental Operating Non-operating OVER VOLTAGE PROTECTION Specification Prevents output from producing excessive voltage in the event TC emperature (A)0C to 40º -40 to +85º of a single fault failure. Voltage limited typically to 130% depend- HH umidity (A)0H to 95% R 0 to 95% R ing upon model. OVP firing reduces output to less than 50% of Sg hock (B) 20 40 g nominal voltage in less than 50 ms. pk pk OVERLOAD PROTECTION At ltitude-t 500 to 10,000 f -500 to 40,000 f Factory set to begin power limiting at approximately 75 W. 2 2 Vg ibration (C) 1.5 , 0.003 g/g Hz 5 , 0.026 g /Hz rms rms A. Units should be allowed to warm up/operate under non-condensing conditions before application of power. B. Random vibration—10 to 2000 Hz, 6 dB/octave roll-off from 350 to 2000 Hz, 3 orthogonal axes. Tested for 10 min./axis operating and 1 hr./axis non-operating. C. Shock testing—half-sinusoidal, 10 ± 3 ms duration, ± direction, 3 orthogonal axes, total 6 shocks. Condor D.C. Power Supplies, Inc., 2311 Statham Parkway, Oxnard, CA 93033 800-235-5929 • 805-486-4565  FAX 805-487-8911  www.condorpower.com 106 GXM60 Medical Single Output Typical Standard Model Configurations: Medical Output Current Initial (1) Total Output Remote Ripple/ Model (V) (I) Set Point Regulation Harness Sense Noise GXM60-5A11 5A V 1% 1 2%1xMs ole Y% e 1.5 GMX1 60-12A0 1A 2 V 5% .0 2%1m2o .1 m N% 1 GXM60-15A01 1A 5 V 4% .0 2%1m2o .1 m N% 1 GXM60-24A01 2A 4 V 22 .5 % 1% 2o .1 mm N% 1 GXM60-28A01 2A 8 V 22 .2 % 1m % 2o .1 m N% 1 GMX1 60-36A0 37 6 V 1A . 2% % 112m .moN% 1 Notes: 1) Initial set point without load. Total regulation shown includes cable losses. When selecting cable options without remote sense, cable drop should be considered. MODEL NUMBER CONFIGURATION GXM60-XXXXX Output Cable/Plug Option Number Case Color: A = Beige B = Black Output V oltages: Units are available standard with any output voltage from 5 to 35 Vdc in 1.0 increments. Also available in 0.1 increments data custom order. Option Output Cord/Plug Cable/Plug No. Maximum Rating 0. 1 Circular 5.6 mm O.D. , 2.1 mm I.D., 18 ga 5 A, 80 V max. 0. 2 Circular 5.6 mm O.D., 2.5 mm I.D., 18 ga 5 A, 80 V max. 0. 3 Circular 5.6 mm O.D., 2.1 mm I.D., RT angle, 18 ga 5 A, 80 V max. 0. 4 Circular 5.6 mm O.D., 2.5 mm I.D., RT angle, 18 ga 5 A, 80 V max. 0d 5 Circular 5.6 mm O.D., 2.1 mm I.D., 18 ga., shielde 5 A, 80 V max. 0d 6 Circular 5.6 mm O.D., 2.5 mm, I.D.,18 ga., shielde 5 A, 80 V max. 0. 7 Mini DIN 20 ga 6 A, 36 V max. 0d 8 Mini DIN 20 ga. shielde 6 A, 36 V max. 0g 9 5 Pin 20 ga. DIN plu 6 A, 36 V max. 1d 0 5 Pin 20 Ga. DIN plug, shielde 6 A, 36 V max. 1. 1 Molex Mini-Fit, 18 ga 11 A, 480 V max. 1N 2 Power DI 11 A, 20 V max. 1d 3 Power DIN., shielde 11 A, 20 V max. MECHANICAL SPECIFICATIONS Condor D.C. Power Supplies, Inc., 2311 Statham Parkway, Oxnard, CA 93033 800-235-5929  805-486-4565  FAX 805-487-8911  www.condorpower.com 107