DEC 830H-P, TA#17870 HOT SWAP - 1000 WATTS With Or'ing Diodes Rear View showing Elcon Connector FEATURES: 5" x 6" x 13" in Size N+1 Redundant and Hot Swap (Elcon Double Drawer Connector) Fast and Easy Installation Meets EN55022 Level A / FCC Class A No Additional Cooling Required up to 50 °C Power Factor Corrected Input (90-264VAC) Active Current Share Capability on V1, V2 Outputs LED'S Included Indicates Power Supply Status (POK, +5Vaux) Greater than 150,000 Hrs MTBF (500,000 Hrs in Redundancy) Note: Minimum purchase is required. Consult factory for quantites above 500 pcs annually. OUTPUT OUTPUT OUTPUT VOLTAGE (VDC) AMPERS (MAX) POWER (WATTS) V1 5 105 525 V2 3.3 110 363 V3 12 12 (15Apk) 144 V4 -12 1 12 V5 +5VSB 2.5 12.5 DEC 830 Nominal Input Voltage 115-240 VAC. Input/Output Isolation 4242 VDC, SELV construction. Frequency 47-63 Hz , 400 Hz Remote Sense Up to 0.5 volts total in load. Operational Input 90-264 VAC (V1, V2 outputs) Voltage Range Inrush Current Less than 4 msec 75 amperes @ 115 VAC I-Share (+5V, 3.3V) Single wire for active share programming. or 150 amperes @ 230 VAC. DC_ENABLE_L Active Low signal that turns on all outputs except +5VAux. Fusing 20 Ampere, 250 VAC, Internal ceramic body fuse. 5VAux Standby voltage that may be used to power circuits that require power during the powered-down state of the Hold up time 20msec minimum after loss of AC Input at full load power rails. First-On, Last-Off. and nominal input Efficiency 65% typical with OR diodes POK_H Power Good signal asserted high when +5V and +3.3V Turn on time Less than 1 sec. outputs are 95% of nominal. Timing characteristics meet ATX spec. Load Regulation 1% for 10% to 100% load change on all outputs. 5% min load required on V1, V2 to maintain regulation 2 2 I C I C Bus, For power supply identification, monitoring and on V3-V4 outputs. EPROM Format for storing power supply data. Consult factory for additional information. Line Regulation 0.1% over operating line range Operating -20°C to 50°C full output Ripple & Noise 1% PARD or 100mv which ever is greater. Temperature 50°C to 75°C, derate 2% /°C 20MHz bandwidth. Transient Response All Outputs maximum excursion of ± 5% for 25% load Stability 0.5% for 8 hrs. after 1 hour warm-up. step. Recovery less than 500 µsec. Humidity Up to 95% non-condensing. Short Circuit and All Outputs protected from short circuit and Overload Protection overload. Shut down until AC recycled. EMI Meets FCC Class A and EN 55022 Level A Overshoot No turn-on or turn-off overshoot. Size 5"x6"x13" Weight: 17 lbs. Overvoltage All outputs excluding +5Vaux. Protection Unit shuts down. Overtemperature Unit shuts down if overheated except +5Vaux. Protection AC must be recycled to recover. REV:B