PFU PFU Systems NetCARD

Description
PFU Systems NetCARD Carrier Board for the Plug-N-Run System On Module
Part Number
PFU Systems NetCARD
Price
Request Quote
Manufacturer
PFU
Lead Time
Request Quote
Category
PRODUCTS - P
Specifications
CardBUS Slots
2 Type II (1 slot, 0 slot options)
CMOS Back up Battery
Rechargeable. Duration: 30 days (typ.)
COM1 Serial port
9-pin D-Sub connector
COM2 Serial Port
10-pin header
CompactFlash/Microdrive
Type II
CRT
15-pin D-Sub connector
Dimensions (with dual PCMCIA Card slots) (l x w x h)
137.16mm x 101.6mm x 33.02mm (5.4” x 4” x 1.3”)
Dual USB Ports
8-pin Dual Type A connector
Ethernet
RJ45 connector
FDD
26-pin flex connector
IDE
50-pin header
Keyboard/Mouse
6-pin Mini-DIN connector
LCD
41-pin connector
Parallel Port
26-pin header
Plug-N-Run
320-pin connector
Power
6-12 Volt (2.49 mm. DC jack)
Reset Switch
Momentary push button
Suspend/Resume
Momentary push button
Weight
226.8 grams (8 oz.)
Features
- ATA CompactFlash™ Type II socket
- Carrier board compatible with the Plug-N-Run System-On-Module family
- CRT and LCD panel connectors
- Dual USB ports connector
- Floppy Disk Drive interface
- IDE header for Hard Disk Drive
- One parallel port connector
- PS/2 Mouse/Keyboard connector
- RJ45 connector for 10/100 Ethernet
- Single 6V ~ 12V DC input
- Two serial ports
- Two Type II CardBUS slots
Datasheet
Extracted Text
™ ™ PFU Systems NetCARD Carrier Board TM NetCARD Carrier Board TM for the Plug-N-Run System-On-Module NetCARD Features: • Carrier board compatible with the Plug-N-Run System-On-Module family • Two Type II CardBUS slots ™ • ATA CompactFlash Type II socket • RJ45 connector for 10/100 Ethernet • Two serial ports • One parallel port connector • PS/2 Mouse/Keyboard connector • Dual USB ports connector • CRT and LCD panel connectors • Floppy Disk Drive interface • IDE header for Hard Disk Drive • Single 6V ~ 12V DC input ® NetCARD shown with 500MHz Pentium III Plug-N-Run module DESCRIPTION The NetCARD is an off the shelf I/O carrier board for PFU Systems’ Plug-N-Run System-On-Module product family. ® The NetCARD may be configured with PFU Systems’ Plug-N-Run modules to implement powerful Pentium w/MMX, ™ Pentium III, and Celeron system solutions ranging from 166MHz to 700MHz. The Plug-N-Run mounts directly to the NetCARD via a 320-pin stacking connector. This configuration allows for scalability across a plug-compatible architecture. PFU Systems’ NetCARD-based micro PCs achieve an extremely small footprint for a wide variety of embedded applications requiring high performance and large memory capacity. The NetCARD with Plug-N-Run allows price/performance scalability and quick time to market as an off the shelf solution. Alternatively the NetCARD reference design is available for rapid development of a custom system board for industrial control, test & measurement, mil/aero, medical, kiosk, transportation and inventory management devices. The NetCARD may be configured with any of the following PFU Systems’ Plug-N-Run products and memory modules. Plug-N-Run Model Part No. Memory 166MHz Pentium® w/MMX C2i-PR5-166 32, 64, or 128MB SDRAM SO DIMM 166MHz Pentium w/MMX Server Edition C2i-PR5-166S* 32, 64, or 128MB SDRAM SO DIMM 266MHz Pentium w/MMX C2i-PR5-266 32, 64, or 128MB SDRAM SO DIMM 266MHz Pentium w/MMX Server Edition C2i-PR5-166S* 32, 64, or 128MB SDRAM SO DIMM 400MHz Celeron C2i-PR7C-400 32, 64, 128 or 256MB SDRAM SO DIMM 500MHz Pentium III C2i-PR7-500 32, 64, 128 or 256MB SDRAM SO DIMM 700MHz Pentium III C2i-PR7-700 32, 64, 128 or 256 MB SDRAM SO DIMM *without graphics processor ™ ™ PFU Systems NetCARD Carrier Board NETCARD CARRIER BOARD SPECIFICATIONS Front view of the NetCARD Carrier Board Back view of the NetCARD Carrier Board ITEM SPECIFICATION Dimensions (with dual PCMCIA Card slots) (l x w x h) 137.16mm x 101.6mm x 33.02mm (5.4” x 4” x 1.3”) Weight 226.8 grams (8 oz.) CardBUS Slots 2 Type II (1 slot, 0 slot options) CompactFlash™/Microdrive Type II COM1 Serial port 9-pin D-Sub connector COM2 Serial Port 10-pin header Parallel Port 26-pin header Ethernet RJ45 connector IDE 50-pin header Dual USB Ports 8-pin Dual Type A connector FDD 26-pin flex connector CRT 15-pin D-Sub connector LCD 41-pin connector Keyboard/Mouse 6-pin Mini-DIN connector Plug-N-Run 320-pin connector Suspend/Resume Momentary push button Reset Switch Momentary push button Power 6-12 Volt (2.49 mm. DC jack) CMOS Back up Battery Rechargeable. Duration: 30 days (typ.) NetCard Starter Kit ORDERING INFORMATION ITEM PART NO. DESCRIPTION NetCARD C2i-PRNET-NX* Carrier board without CardBUS slots NetCARD C2i-PRNET-1S* Carrier board with one CardBUS slots NetCARD C2i-PRNET-BD* Carrier board with two CardBUS slots *For single SO DIMM Plug-N-Run modules only NetCARD Starter Kit C2i-PRNET-KIT Cable set power supply and floppy disk drives Mounting Hardware C2i-PRM4-MM Mounting screws, spacers and lock washers SALES OFFICES Headquarters Midwest Sales Office Eastern Sales Office For more information or for a list of dealers and representatives near you PFU Systems, Inc. PFU Systems, Inc. PFU Systems, Inc. visit: www.PFUsystems.com 3350 Scott Blvd., Bldg. 34-B 5929 Baker Road, Suite 440 206 New Edition Court or call your nearest PFU Systems office Santa Clara, CA 95054-3105 Minnetonka, MN 55345-5956 Cary, NC 27511-4451 listed at the left. Phone: 408.327.1750 Phone: 952.345.0085 Phone: 919.319.0900 Fax: 408.327.1751 Fax: 952.345.0090 Fax: 919.319.3552 PFU Systems, Inc. does not warrant its products for use in applications that may involve endangerment of human health or safety, including but not limited to medical life support, surgery, aircraft flight control, mass transportation control, missile control, or environmental control. PFU Systems, Inc. reserves the right to make changes to its products at any time without notice. PFU Systems, Plug-N-Run and Fail-Safe-Boot are trademarks of PFU Systems, Inc ProDeS is a service mark of PFU Systems, Inc. All other trademarks and registered trademarks are property of their respective holders. ©2000, 2002 PFU Systems, Inc. All rights reserved. PS-PRNET-FS-010
Frequently asked questions
What makes Elite.Parts unique?

What kind of warranty will the PFU Systems NetCARD have?

Which carriers does Elite.Parts work with?

Will Elite.Parts sell to me even though I live outside the USA?

I have a preferred payment method. Will Elite.Parts accept it?

Why buy from GID?

Quality
We are industry veterans who take pride in our work

Protection
Avoid the dangers of risky trading in the gray market

Access
Our network of suppliers is ready and at your disposal

Savings
Maintain legacy systems to prevent costly downtime

Speed
Time is of the essence, and we are respectful of yours
What they say about us
FANTASTIC RESOURCE
One of our top priorities is maintaining our business with precision, and we are constantly looking for affiliates that can help us achieve our goal. With the aid of GID Industrial, our obsolete product management has never been more efficient. They have been a great resource to our company, and have quickly become a go-to supplier on our list!
Bucher Emhart Glass
EXCELLENT SERVICE
With our strict fundamentals and high expectations, we were surprised when we came across GID Industrial and their competitive pricing. When we approached them with our issue, they were incredibly confident in being able to provide us with a seamless solution at the best price for us. GID Industrial quickly understood our needs and provided us with excellent service, as well as fully tested product to ensure what we received would be the right fit for our company.
Fuji
HARD TO FIND A BETTER PROVIDER
Our company provides services to aid in the manufacture of technological products, such as semiconductors and flat panel displays, and often searching for distributors of obsolete product we require can waste time and money. Finding GID Industrial proved to be a great asset to our company, with cost effective solutions and superior knowledge on all of their materials, it’d be hard to find a better provider of obsolete or hard to find products.
Applied Materials
CONSISTENTLY DELIVERS QUALITY SOLUTIONS
Over the years, the equipment used in our company becomes discontinued, but they’re still of great use to us and our customers. Once these products are no longer available through the manufacturer, finding a reliable, quick supplier is a necessity, and luckily for us, GID Industrial has provided the most trustworthy, quality solutions to our obsolete component needs.
Nidec Vamco
TERRIFIC RESOURCE
This company has been a terrific help to us (I work for Trican Well Service) in sourcing the Micron Ram Memory we needed for our Siemens computers. Great service! And great pricing! I know when the product is shipping and when it will arrive, all the way through the ordering process.
Trican Well Service
GO TO SOURCE
When I can't find an obsolete part, I first call GID and they'll come up with my parts every time. Great customer service and follow up as well. Scott emails me from time to time to touch base and see if we're having trouble finding something.....which is often with our 25 yr old equipment.
ConAgra Foods