NKK SWITCHES Series SS
Datasheet
Extracted Text
Series SS Ultra-Miniature Slides General Specifications Electrical Capacity (Resistive Load) Power Level (silver): 0.1A @ 30V DC Logic Level (gold): 0.4VA maximum @ 28V AC/DC maximum (Applicable Range 0.1mA ~ 0.1A @ 20mV ~ 28V) Note: Find additional explanation of operating range in Supplement section. Other Ratings Contact Resistance: 20 milliohms maximum for power level; 40 milliohms maximum for logic level Insulation Resistance: 100 megohms minimum @ 500V DC Dielectric Strength: 500V AC minimum 1 minute minimum Mechanical Life: 10,000 operations minimum Electrical Life: 10,000 operations minimum Contact Timing: SS12S & SS22S – Shorting (make-before-break); SS14M – Nonshorting (break-before-make) Total Travel: .079” (2.0mm) Materials & Finishes Actuator: Polyamide Upper Case: Polyester for 3-On models; polyacetal for all other models Lower Case: Glass fiber reinforced polyester for 3-On models; glass fiber reinforced polybutylene terephthalate (thermoplastic) for other models Movable Contactor: Phosphor bronze with silver plating (code 2) or phosphor bronze with gold plating (code 4) Interior Base: Phenolic resin (thermoset) H Terminals: Brass with silver plating over copper plating or brass with gold plating Environmental Data Operating Temp Range: –15°C through +60°C (+5°F through +140°F) Humidity: 90 ~ 95% humidity for 96 hours @ 40°C (104°F) Vibration: 10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range & returning in 1 minute; 3 right angled directions for 2 hours 2 Shock: 50G (490m/s ) acceleration (tested in 6 right angled directions, with 5 shocks in each direction) PCB Processing Soldering: Wave Soldering: For non-supported through-hole, see Profile B in Supplement section. For supported through-hole, 5 seconds maximum @ 250°C maximum. Manual Solder: See Profile B in Supplement section. Cleaning: These devices are not process sealed. Hand clean locally using alcohol based solution. Standards & Certifications The SS series devices have not been tested for UL recognition and CSA certification. These switches are designed for use in a low-voltage, low-current circuit. When used as intended in a low-voltage, low-current circuit, the results do not produce hazardous energy. H44 www.nkk.com Supplement Accessories Indicators Touch Tilt Tactiles Slides Rotaries Keylocks Programmable Illuminated PB Pushbuttons Rockers Toggles Ultra-Miniature Slides Series SS Distinctive Characteristics Top or side actuation permits flexible board design. Compact dimensions and low profile allow high density mounting and close stacking of PC boards. Crisp actuation positively indicates circuit status. Double molded thermoset base and thermo- plastic housing prevent loosening of terminals due to high soldering temperatures. Award-winning STC mechanism with benefits unavailable in conventional mechanisms: smoother, positive detend actuation, increased contact stability, and unparalleled logic-level reliability. (Additional STC details in Terms and Acronyms in the Supplement section.) Insert molded terminals lock out flux, solvents, and other contaminants. H Inch or metric terminal spacing for standard PC board grid (.100” x .100” or 2.0mm x 2.0mm). Actual Size www.nkk.com H45 Supplement Accessories Indicators Touch Tilt Tactiles Slides Rotaries Keylocks Programmable Illuminated PB Pushbuttons Rockers Toggles Series SS Ultra-Miniature Slides TYPICAL SWITCH ORDERING EXAMPLE SS 12S D P 2 Poles & Circuits Terminal Spacing Contact Material & Ratings 12S SPDT ON NONE ON B Metric 2.0mm x 2.0mm 2 Silver Rated 0.1A @ 30V DC SS12S model has shorting contacts. D Inch .100” x .100” Gold Rated 0.4VA maximum * 14M SP3T ON ON ON * 4 @ 28V AC/DC maximum SS14M model has nonshorting contacts. * Gold not available with SS14M. 22S DPDT ON NONE ON SS22S model has shorting contacts. Actuation See Poles & Circuits chart below. P Top Actuated * 14M Circuit with silver contacts only. H Side Actuated DESCRIPTION FOR TYPICAL ORDERING EXAMPLE SS12SDP2 H Top Actuated SPDT ON-NONE-ON Circuit Silver Contacts Rated 0.1A @ 30V DC Terminals with .100” Spacing POLES & CIRCUITS Slide Position Connected Terminals Throw & Schematics Right Center Left Right Center Left Note: Terminal numbers are not actually on switch. Pole Model SP SS12S ON NONE ON 2-1 NONE 2-3 SPDT 3 2 (COM) 1 Make-Before-Break ON-OFF-ON circuit SP SS14M ON ON ON 3-4 3-2 3-1 SP3T 4 3 (COM) 2 1 can be created by not connecting terminal 2. DP SS22S ON NONE ON 2-1 5-4 NONE 2-3 5-6 DPDT 1 2 (COM) 3 4 5 (COM) 6 H46 www.nkk.com Supplement Accessories Indicators Touch Tilt Tactiles Slides Rotaries Keylocks Programmable Illuminated PB Pushbuttons Rockers Toggles Ultra-Miniature Slides Series SS TERMINAL SPACING B Metric 2.0mm x 2.0mm with Black Base (0.4) Typ .016 (2.0) (0.4) Typ (0.4) Typ .079 .016 (4.0) .016 .157 (2.0) Typ (2.0) Typ (2.0) Typ (3.4) .079 .079 .079 .134 (3.4) (3.4) (0.6) Typ (0.6) Typ (0.6) Typ .134 .134 .024 .024 .024 (4.0) (4.0) .157 (10.2) (10.0) .157 (6.0) .402 .394 .236 4 (2.0) Typ (4.0) .079 4 1 .157 3 2 5 (2.0) Typ 2 .079 6 3 1 1 2 (0.8) Dia Typ (2.0) Typ .031 3 .079 (0.8) Dia Typ (2.0) (0.8) Dia Typ .031 .079 .031 On-None-On Single Pole Models On-None-On Double Pole Models 3-On Models D Inch .100” x .100” with Gray Base (0.4) Typ .016 (2.54) (0.4) Typ (0.4) Typ (3.4) .100 .016 .016 (5.08) .134 (2.54) Typ .200 (2.54) Typ .100 (3.4) .100 (2.54) Typ (3.4) .100 .134 (0.6) Typ (0.6) Typ .134 (0.6) Typ .024 .024 .024 (4.0) (4.0) (10.2) .157 (10.2) (6.54) .157 .402 .402 .257 4 (2.54) Typ (5.08) .100 .200 4 1 3 (2.54) Typ 5 2 2 .100 1 1 H 6 3 2 (2.54) Typ (0.8) Dia Typ .100 3 .031 (0.8) Dia Typ (0.8) Dia Typ (2.54) .031 .031 .100 On-None-On Single Pole Models On-None-On Double Pole Models 3-On Models ACTUATION (1.2) (2.0) (2.5) .047 .079 .098 P H (1.2) Top Actuated (1.5) Side Actuated .047 .059 (1.5) .059 CONTACT MATERIALS & RATINGS 2 Silver over Phosphor Bronze Power Level 0.1A @ 30V DC 4 Gold over Silver/Phosphor Bronze Logic Level 0.4VA max @ 28V AC/DC max Complete explanation of operating range in Supplement section. www.nkk.com H47 Supplement Accessories Indicators Touch Tilt Tactiles Slides Rotaries Keylocks Programmable Illuminated PB Pushbuttons Rockers Toggles Series SS Ultra-Miniature Slides TYPICAL SWITCH DIMENSIONS Top Actuated Single & Double Pole (2.0) Travel (3.3) (3.0) .079 .130 .118 1 1 4 (10.2) (0.6) Typ (10.2) 2 2 5 .402 .024 .402 3 3 6 (1.5) (2.54) Typ .059 .100 (1.2) (1.2) (2.0) (0.4) (0.4) Typ .047 .047 .079 .016 .016 (4.0) (0.4) (4.5) (6.54) (2.54) .157 .016 .177 .257 .100 SS12SDP2 Side Actuated Single & Double Pole (1.2) .047 (3.3) (2.0) Travel (3.3) (2.0) Travel (3.5) .130 .079 .130 .079 .138 (0.6) Typ .024 1 1 4 (10.2) (10.2) 2 2 5 .402 .402 3 3 6 (1.5) (1.5) (2.54) Typ .059 .059 .100 (2.5) (0.4) (2.5) (0.4) Typ .098 .016 .098 .016 (4.0) (6.54) (5.0) (3.0) (2.54) (0.4) .157 .257 .197 .118 .100 .016 SS12SDH2 3-On Circuit • Top Actuated Single Pole H (0.4) (0.6) Typ (2.0) Travel Typ .016 .024 .079 4 (5.08) .200 (15.8) 3 .622 2 1 (2.54) Typ (1.5) .100 .059 (3.0) (1.2) (2.0) .118 .047 .079 (4.5) (0.4) (4.0) .177 .016 .157 SS14MDP2 3-On Circuit • Side Actuated Single Pole (3.5) .138 (0.4) .016 (0.6) Typ .024 (2.0) Travel Typ .079 4 (5.08) .200 (15.8) 3 .622 2 1 (1.5) (2.54) Typ .059 .100 (2.5) (1.2) (3.0) .098 .047 .118 (4.0) (5.0) (0.4) .157 .197 .016 SS14MDH2 H48 www.nkk.com Supplement Accessories Indicators Touch Tilt Tactiles Slides Rotaries Keylocks Programmable Illuminated PB Pushbuttons Rockers Toggles
Frequently asked questions
What makes Elite.Parts unique?

What kind of warranty will the Series SS have?

Which carriers does Elite.Parts work with?

Will Elite.Parts sell to me even though I live outside the USA?

I have a preferred payment method. Will Elite.Parts accept it?

What they say about us
FANTASTIC RESOURCE
One of our top priorities is maintaining our business with precision, and we are constantly looking for affiliates that can help us achieve our goal. With the aid of GID Industrial, our obsolete product management has never been more efficient. They have been a great resource to our company, and have quickly become a go-to supplier on our list!
Bucher Emhart Glass
EXCELLENT SERVICE
With our strict fundamentals and high expectations, we were surprised when we came across GID Industrial and their competitive pricing. When we approached them with our issue, they were incredibly confident in being able to provide us with a seamless solution at the best price for us. GID Industrial quickly understood our needs and provided us with excellent service, as well as fully tested product to ensure what we received would be the right fit for our company.
Fuji
HARD TO FIND A BETTER PROVIDER
Our company provides services to aid in the manufacture of technological products, such as semiconductors and flat panel displays, and often searching for distributors of obsolete product we require can waste time and money. Finding GID Industrial proved to be a great asset to our company, with cost effective solutions and superior knowledge on all of their materials, it’d be hard to find a better provider of obsolete or hard to find products.
Applied Materials
CONSISTENTLY DELIVERS QUALITY SOLUTIONS
Over the years, the equipment used in our company becomes discontinued, but they’re still of great use to us and our customers. Once these products are no longer available through the manufacturer, finding a reliable, quick supplier is a necessity, and luckily for us, GID Industrial has provided the most trustworthy, quality solutions to our obsolete component needs.
Nidec Vamco
TERRIFIC RESOURCE
This company has been a terrific help to us (I work for Trican Well Service) in sourcing the Micron Ram Memory we needed for our Siemens computers. Great service! And great pricing! I know when the product is shipping and when it will arrive, all the way through the ordering process.
Trican Well Service
GO TO SOURCE
When I can't find an obsolete part, I first call GID and they'll come up with my parts every time. Great customer service and follow up as well. Scott emails me from time to time to touch base and see if we're having trouble finding something.....which is often with our 25 yr old equipment.
ConAgra Foods