Datasheet CPV5375 CompactPCI Host Slot Processor Board ■Intel Pentium III BGA2 processor Performance and flexibility in a CompactPCI host slot processor board ® The CPV5375 provides a powerful and flexible CompactPCI host slot processor board ® with a Pentium III processor. This board is specifically designed for cost-sensitive, embedded applications where performance and a rich feature set are required. The CPV5375 is designed for telecommunications, industrial automation, medical, COTS and applications where leading edge technology is mandatory. The board has a demonstrated high MTBF and is coupled with software support for operating systems ® ®. such as Linux and VxWorks The CPV5375 provides an ideal time-to-market solution for CompactPCI host slot controller applications that are based on Pentium processors. ■Intel Pentium III BGA2 processor Soldered-on memory: to 512MB PCI Bridge ■Up to 1GB PC100 SDRAM and Memory mezzaine: to 512MB Processor Memory Controller (North Bridge Intel 440GX) ■Two 32/64-bit PMC expansion slots AGP AGP Bus Video ■Optional on-board 2.5" EIDE hard drive PMC 2 PMC 2 (replaces one PMC site) 33 MHz, 64 bit PCI Local Bus ■Accelerated 2D graphics with 4MB video memory ISA Bridge (South Bridge) PCI to PCI■Dual 10/100Mbit Ethernet Ethernet 1 Intel PIIX4E Bridge Intel 82559 Intel 21154 ■Embedded features: two USB interfaces, two serial Ethernet 2 FPGA Intel 82559 ports, bi-directional IEEE-1284 parallel I/O System Flash Monitor BIOS ■Supported by industry-standard operating systems Ultra I/O On-Card such as Linux and VxWorks Hard Drive (Optional) User VO J3, J5 & J4 (Optional) CPCI J1/J2 D035 050 COM Ethernet PMC I/O PMC I/O Ethernet 1 J5 Ethernet 2 J5 COM 1 J3 COM 2 J3 KBD J5 Mouse J5 Printer J4 Floppy J4 100 MHz Processor SM Bus USB 0 J3 USB 1 J3 ISA Primary IDE J4 Secondary IDE PMC 2 I/O J5 PMC 1 I/O J3 Video J4 33 MHz, 64 bit CPCI Bus CP V5 370 De tails CPV5375 DETAILS Intel Pentium III Processor For embedded host applications, the CPV5375 fully supports the Pentium III BGA2 processor. The processor is combined with the Intel 440GX PCI chipset resulting in exceptional processing capability. The processor contains 32KB of internal Level 1 cache memory as well as 256KB of Level 2 cache, delivering rapid data access to complex applications. Dynamic execution and dual independent buses are additional performance advantages. Memory The CPV5375 is configured with up to 512MB of on-board PC100 compliant synchronous DRAM. Memory size is detected by the system BIOS. The board can support up to 1GB of DRAM by installing the CPMEZZ-256 memory expansion module. Refer to the Ordering Information section for additional information. 2D Accelerated Graphics A 69030 HiQVideo accelerator with 4MB integrated memory provides eye-opening 2D accelerated graphics performance for human-machine interfaces and imaging applications. Resolutions up to 1600 x 1200 are supported. Dual Ethernet Two Intel 82559 Ethernet controllers provide redundant Ethernet ports for control and telecom applications. One or both of these controllers can be used as a diagnostic interface, allowing remote monitoring of system status (for example, voltage and temperature). One Ethernet RJ-45 connector is located on the front panel. Both Ethernet ports are routed to the rear I/O and available via the CPTM-01 transition module. Hot Swap Compatible The board hardware monitors the ENUM# signal and can be configured to generate an NMI or SMI in response to hot swap events. Event detection via I/O register polling is also possible. Live Insertion and Removal The CPV5375 can be inserted into or removed from a powered chassis without sustaining damage. In addition, a live insertion will cause a valid reset on the CompactPCI bus, thus ensuring an orderly bootup with correct device enumeration. On-Board Peripherals The CPV5375 has an extensive array of on-board I/O available from both the front and/or rear panel via the CPTM-01 transition board. Front panel I/O includes a knockout for two PMC sites, one RJ-45 connector for Ethernet and one RJ-45 connector for COM1. User I/O available at the rear of the board includes both Ethernet ports, secondary IDE, both PMC I/O, video, parallel, floppy, mouse/keyboard, COM1 and COM2, and USB0 and USB1. CompactPCI Bus Designed to the CompactPCI interface standard, the CPV5375 supports a 64-bit PCI interface on the J1 and J2 physical CompactPCI connectors. On-board devices connect directly to the local bus. Off-board CompactPCI bus accesses are supported through the Intel 21154 PCI-to PCI transparent bridge. 2 CPV5375 Sp ec ific atio ns SPECIFICATIONS Processor Clock/Calendar 700 MHz Pentium III BGA2 processor Real-time clock with replaceable battery backup Cache Interrupts Four CompactPCI level-sensitive interrupts, configurable to any Level 1: 16/16KB instruction/data interrupt vector for plug-and-play compatibility. Level 2: 256KB Note: All ISA on-board interrupts are plug-and-play compliant. Memory Ethernet Capacity: Up to 1GB Controllers: Two Intel 82559 DRAM: PC100 compliant synchronous, 60 ns, Interface: 10/100BaseT parity or ECC mode PCI Local Bus DMA: Yes, with PCI burst Addressing: Real and protected (32-bit) addressing supported Graphics Data Path: 32-bit CPU/PCI bus Controller: 69030 HiQVideo 2D accelerated video CompactPCI Interface Video Memory: 4MB on-chip SDRAM Resolution: 1600 x 1200 max.; Quarter VGA 320 x 240, Compliance: PCI Specification Rev. 2.1 320 x 200 Connectors: J1/J2 Address/Data Lines: 64 Front Panel I/O Interfaces PCI Bus Clock: 33 MHz PMC: Two openings to accommodate PMC I/O Controller: Intel 21154 PCI-to-PCI interface bridge chip Serial Port: One RJ-45 Signaling: 5V compliant Ethernet: One RJ-45 Note: Additional devices may be attached via transition module. IEEE 1386.1 PCI Mezzanine Interface Supervisory Address/Data Lines: 64 Watchdog Timer: Two-level, software programmable; drives PCI Bus Clock: 33 MHz interrupt, NMI/system reset, or soft reset Signaling: 5V Alarm Microcontroller CPU and board temperature, backplane Power: +3.3V, +5V, ±12V; 7.5 watts maximum per (NS LM81): and CPU voltages, with status PMC slot interrogated via NMI, SCI, selectable IRQ Module Types: Two single-wide or one double-wide front- or Alarm panel I/O or J3 and J5 I/O Reset Switch: Guarded, on front panel Note: Due to high component density, uninsulated traces and vias are Front panel LEDs: Power OK (green) and Hard Drive Activity located in the CPV5375 I/O keepout area. If installed, PMC modules (green) having conductive I/O connectors could contact these traces and vias. If full IEEE 1386.1 compliance is required, an insulating shield should On-board Headers: Primary EIDE and two PMC sites be installed. Rear Panel: Both Ethernet ports, secondary IDE, both PMC I/O, video, printer, floppy, mouse/keyboard, COM1 and COM2, and USB0 and USB1 CPV5375 3 s SPECIFICATIONS BIOS Features Power Requirements  BIOS in Flash EEPROM (including drive option; using 512MB SDRAM)  Auto-configuration or extended setup with serial/parallel ports 700 MHz remappable +5V: 2.0A typ.  Diskless, keyboardless and videoless operation extensions +3.3V: 2.5 A typ.  BIOS POST and Setup +12V: 50 mA typ.  System and video BIOS shadowing –12V: <25 mA typ.  Network boot using PXE (Preboot eXecution Environment)  CMOS backup to flash (allows operation without battery) Demonstrated MTBF Mechanical (based on a sample of eight boards in accelerated stress environment) Mean: 214,322 hours 6U, 4HP wide (233 mm x 160 mm x 20 mm), conforms to PICMG 2.0 CompactPCI (rev. 2.1) and PCI SIG 2.1 specifications 95% Confidence: 121,141 hours (excluding on-board hard drive option) Safety Environmental All printed wiring boards (PWBs) are manufactured with a flammability rating of 94V-0 by UL recognized manufacturers. (excluding on-board hard drive option) Operating Storage/Transit CPTM-01 Transition Module I/O Temperature: 0° C to +55° C –40° C to +70° C Humidity (NC): 5 to 90% 5 to 95% Transition module Provides backplane I/O from J3, J4, and J5 on the CPV5375 Vibration: 0.5 G RMS 6 Gs RM 20–2000 Hz random 20–2000 Hz random Connectors on the Keyboard/mouse, dual Ethernet, video, panel include: COM2, and optional PIM module knockout Electromagnetic Compatibility (EMC) On-board Headers: COM1, USB0, USB1, secondary EIDE, floppy, PIM site, floppy, parallel, and Intended for use in systems meeting the following regulations: CompactFlash U.S.: FCC Part 15, Subpart B, Class A (non-residential) Canada: ICES-003, Class A (non-residential) This product was tested in a representative system to the following standards: CE Mark per European EMC Directive 89/336/EEC with Amendments; Emissions: EN55022 Class B; Immunity: EN55024 4 CPV5375 Orde ring Informa tion 5 ORDERING INFORMATION5 Part Number Description CPV5375-700-01 700 MHz, 256MB SDRAM, two PMC sites CPV5375-700-02 700 MHz, 256MB SDRAM, one PMC site, hard drive CPV5375-700-03 700 MHz, 512MB SDRAM, two PMC sites CPV5375-700-04 700 MHz, 512MB SDRAM, one PMC site, hard drive CPV5375-700-05 700 MHz, 1GB SDRAM, two PMC sites CPV5375-700-06 700 MHz, 1GB SDRAM, one PMC site, hard drive Transition Module The CPV5375 uses an optional transition module for peripheral and network connections that are required at the rear of the chassis. CPTM-01 Transition module with keyboard/mouse, dual Ethernet, video, COM2, and optional PIM module knockout Memory Modules CPMEZZ-256B 256MB memory mezzanine, bottom installation CPMEZZ-256B-F 256MB memory mezzanine, bottom installation by factory CPMEZZ-256T 256MB memory mezzanine, top installation CPMEZZ-256T-F 256MB memory mezzanine, top installation by factory Documentation CPV5370A/IH CompactPCI CPV5375 Single Board Computer and CPTM-01Transition Module Installation and Reference Guide Documentation is available for online viewing and downloading at http://www.motorola.com/computer/literature PMC Module Support Motorola offers PMC modules that complement and enhance the functionality of the CPV5375. Additional information is available at http://www.motorola.com/computer or by contacting a Motorola sales representative or authorized distributor. Motorola Computer Group NORTH AMERICA: Tempe, AZ 1 800 759 1107 or1 602 438 5720 ASIA: Shanghai, China +86 21 5292 5693 Regional Offices EUROPE: Loughborough, UK +44 1509 634300 PACIFIC RIM: Tokyo, Japan +81 3 5424 3101 EAST MEDITERRANEAN: Tel Aviv, Israel +972 3 568 4388 ASIA/PACIFIC: Hong Kong +852 2966 3210 www.motorola.com/computer MOTOROLA and the Stylized M Logo are registered in the U.S. Patent and Trademark Office. CompactPCI and PICMG are registered trademarks of the PCI Industrial Computer Manufacturers Group. All other product or service names are the property of their respective owners. This datasheet identifies products, their specifications, and their characteristics, which may be suitable for certain applications. It does not constitute an offer to sell or a commitment of present or future availability, and should not be relied upon to state the terms and conditions, including warranties and disclaimers thereof, on which Motorola may sell products. A prospective buyer should exercise its own independent judgement to confirm the suitability of the products for particular applications. Motorola reserves the right to make changes, without notice, to any products or information herein which will, in its sole discretion, improve reliability, function, or design. Motorola does not assume any liability arising out of the application or use of any product or circuit described herein; neither does it convey any license under its patent or other intellectual property rights or under others. This disclaimer extends to any prospective buyer, and it includes Motorola’s licensee, licensee’s transferees, and licensee’s customers and users. Availability of some of the products and services described herein may be restricted in some locations. C5375-D3 07/04 ©2004, 2001 Motorola, Inc. All rights reserved.