MEAN WELL HRP-300-15
Specifications
AC CURRENT (Typ.)
4.5A/115VAC 2.5A/230VAC
CURRENT RANGE
0 ~ 22A
DC VOLTAGE
15V
DIMENSION
199*105*41mm (L*W*H)
EFFICIENCY (Typ.)
88%
FREQUENCY RANGE
47 ~ 63Hz
HOLD UP TIME (Typ.)
16ms/230VAC 16ms/115VAC at full load
INRUSH CURRENT (Typ.)
35A/115VAC 70A/230VAC
LINE REGULATION
0.3%
LOAD REGULATION
0.5%
OVER LOAD
105 ~ 135% rated output power
Protection type : Constant current limiting, recovers automatically after fault condition is removed
OVER VOLTAGE
18.8 ~ 21.8V
Protection type : Shut down o/p voltage, re-power on to recover
POWER FACTOR (Typ.)
PF>0.95/230VAC PF>0.99/115VAC at full load
RATED CURRENT
22A
RATED POWER
330W
RIPPLE & NOISE (max.)
150mVp-p
SETUP, RISE TIME
1000ms, 50ms/230VAC 2500ms, 50ms/115VAC at full load
VOLTAGE ADJ. RANGE
13.5 ~ 18V
VOLTAGE RANGE
85 ~ 264VAC 120 ~ 370VDC
VOLTAGE TOLERANCE
1.0%
Features
- 1U low profile 41mm
- Built-in active PFC function, PF>0.95
- Built-in constant current limiting circuit
- Built-in cooling fan ON-OFF control
- Built-in DC OK signal
- Built-in remote sense function
- High efficiency up to 89%
- Protections: Short circuit / Overload / Over voltage / Over temperature
- Universal AC input / Full range
- Withstand 300VAC surge input for 5 seconds
Datasheet
MeanWell-HRP300series-d-1422099036s.pdf
260 KiB
Extracted Text
300W Single Output with PFC Function HRP-300 series Features : Universal AC input / Full range Built-in active PFC function, PF>0.95 High efficiency up to 89% Withstand 300VAC surge input for 5 seconds Protections: Short circuit / Overload / Over voltage / Over temperature Built-in constant current limiting circuit 1U low profile 41mm Built-in cooling fan ON-OFF control Built-in DC OK signal Built-in remote sense function 5 years warranty SPECIFICATION MODEL HRP-300-3.3 HRP-300-5 HRP-300-7.5 HRP-300-12 HRP-300-15 HRP-300-24 HRP-300-36 HRP-300-48 DC VOLTAGE 3.3V 5V 7.5V 12V 15V 24V 36V 48V RATED CURRENT 60A 60A 40A 27A 22A 14A 9A 7A CURRENT RANGE 0 ~ 60A 0 ~ 60A 0 ~ 40A 0 ~ 27A 0 ~ 22A 0 ~ 14A 0 ~ 9A 0 ~ 7A RATED POWER 198W 300W 300W 324W 330W 336W 324W 336W RIPPLE & NOISE (max.) Note.2 80mVp-p 90mVp-p 100mVp-p 120mVp-p 150mVp-p 150mVp-p 250mVp-p 250mVp-p OUTPUT VOLTAGE ADJ. RANGE 2.8 ~ 3.8V 4.3 ~ 5.8V 6.8 ~ 9V 10.2 ~ 13.8V 13.5 ~ 18V 21.6 ~ 28.8V 28.8 ~ 39.6V 40.8 ~ 55.2V VOLTAGE TOLERANCE Note.3 2.5% 2.0% 2.0% 1.0% 1.0% 1.0% 1.0% 1.0% LINE REGULATION 0.5% 0.5% 0.5% 0.3% 0.3% 0.2% 0.2% 0.2% LOAD REGULATION 1.0% 1.0% 1.0% 0.5% 0.5% 0.5% 0.5% 0.5% SETUP, RISE TIME 1000ms, 50ms/230VAC 2500ms, 50ms/115VAC at full load HOLD UP TIME (Typ.) 16ms/230VAC 16ms/115VAC at full load VOLTAGE RANGE Note.5 85 ~ 264VAC 120 ~ 370VDC FREQUENCY RANGE 47 ~ 63Hz POWER FACTOR (Typ.) PF>0.95/230VAC PF>0.99/115VAC at full load INPUT EFFICIENCY (Typ.) 80% 82% 86% 88% 88% 87% 88% 89% AC CURRENT (Typ.) 4.5A/115VAC 2.5A/230VAC INRUSH CURRENT (Typ.) 35A/115VAC 70A/230VAC LEAKAGE CURRENT <1.2mA / 240VAC 105 ~ 135% rated output power OVERLOAD Protection type : Constant current limiting, recovers automatically after fault condition is removed 3.96 ~ 4.62V 6 ~ 7V 9.4 ~ 10.9V 14.4 ~ 16.8V 18.8 ~ 21.8V 30 ~ 34.8V 41.4 ~ 48.6V 57.6 ~ 67.2V OVER VOLTAGE Protection type : Shut down o/p voltage, re-power on to recover PROTECTION 90 5 (TSW1: detect on heatsink of power transistor) 100 5 for 3.3V,5V,7.5V ; 95 5 for others (TSW2: detect on heatsink of power diode) OVER TEMPERATURE Protection type : Shut down o/p voltage, recovers automatically after temperature goes down PSU turns on : 3.3 ~ 5.6V ; PSU turns off : 0 ~ 1V DC OK SIGNAL FUNCTION Load 35 15% or RTH2 50 Fan on FAN CONTROL (Typ.) -40 ~ +70 (Refer to "Derating Curve") WORKING TEMP. 20 ~ 90% RH non-condensing WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY -40 ~ +85 , 10 ~ 95% RH TEMP. COEFFICIENT 0.03%/ (0 ~ 50 ) VIBRATION 10 ~ 500Hz, 5G 10min./1cycle, 60min. each along X, Y, Z axes SAFETY STANDARDS UL60950-1, TUV EN60950-1 approved WITHSTAND VOLTAGE I/P-O/P:3KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC SAFETY & ISOLATION RESISTANCE I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25 / 70% RH EMC (Note 4) Compliance to EN55022 (CISPR22) Class B, EN61000-3-2,-3 EMC EMISSION Compliance to EN61000-4-2,3,4,5,6,8,11, EN55024, EN61000-6-2, heavy industry level, criteria A EMC IMMUNITY MTBF 176K hrs min. MIL-HDBK-217F (25 ) OTHERS DIMENSION 199*105*41mm (L*W*H) PACKING 0.95Kg;15pcs/15.3Kg/0.69CUFT 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. NOTE 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. For guidance on how to perform these EMC tests, please refer to “EMI testing of component power supplies.” (as available on http://www.meanwell.com) 5. Derating may be needed under low input voltages. Please check the derating curve for more details. File Name:HRP-300-SPEC 2011-10-25 1 7 2 8 300W Single Output with PFC Function HRP-300 series Mechanical Specification Case No.980A Unit:mm 4-M4 L=6 168.5 12.25 199 12.25 168.5 120 42.5 1 4-M4 L=5 2 3 4 FAN Air flow 5 Terminal Pin No. Assignment direction Pin No. Assignment Pin No. Assignment 6 1 AC/L 4,5 DC OUTPUT -V 7 LED 2 AC/N 6,7 DC OUTPUT +V CN100 3 SVR FG Connector Pin No. Assignment (CN100) : 167.5 12.25 HRS DF11-08DP-2DS or equivalent Pin No. Assignment Mating Housing Terminal 12.25 167.5 1,2,4,6 NC 17max. 3 DC-OK HRS DF11-8DS HRS DF11-**SC 5 GND or equivalent or equivalent 7 +S 4-M4 L=6 8 -S fosc : 70KHz Block Diagram +S ACTIVE RECTIFIERS RECTIFIERS EMI +V INRUSH POWER & I/P & FILTER CURRENT SWITCHING -V PFC FILTER LIMITING -S O.T.P. O.L.P. DC OK DETECTION CIRCUIT FG PFC PWM O.V.P. CONTROL CONTROL Derating Curve Output Derating VS Input Voltage 100 100 90 80 80 70 60 50 60 40 50 20 40 -40 0 10 20 30 40 50 60 70 (HORIZONTAL) 85 100 125 135 155 264 AMBIENT TEMPERATURE ( ) INPUT VOLTAGE (V) 60Hz File Name:HRP-300-SPEC 2011-10-25 LOAD (%) 9.2 11 LOAD(%) 12.5 15 75 18 12.5 18 105 41 127.4
Frequently asked questions
What makes Elite.Parts unique?
What kind of warranty will the HRP-300-15 have?
Which carriers does Elite.Parts work with?
Will Elite.Parts sell to me even though I live outside the USA?
I have a preferred payment method. Will Elite.Parts accept it?
Why buy from GID?
Quality
We are industry veterans who take pride in our work
Protection
Avoid the dangers of risky trading in the gray market
Access
Our network of suppliers is ready and at your disposal
Savings
Maintain legacy systems to prevent costly downtime
Speed
Time is of the essence, and we are respectful of yours
What they say about us
FANTASTIC RESOURCE
One of our top priorities is maintaining our business with precision, and we are constantly looking for affiliates that can help us achieve our goal. With the aid of GID Industrial, our obsolete product management has never been more efficient. They have been a great resource to our company, and have quickly become a go-to supplier on our list!
Bucher Emhart Glass
EXCELLENT SERVICE
With our strict fundamentals and high expectations, we were surprised when we came across GID Industrial and their competitive pricing. When we approached them with our issue, they were incredibly confident in being able to provide us with a seamless solution at the best price for us. GID Industrial quickly understood our needs and provided us with excellent service, as well as fully tested product to ensure what we received would be the right fit for our company.
Fuji
HARD TO FIND A BETTER PROVIDER
Our company provides services to aid in the manufacture of technological products, such as semiconductors and flat panel displays, and often searching for distributors of obsolete product we require can waste time and money. Finding GID Industrial proved to be a great asset to our company, with cost effective solutions and superior knowledge on all of their materials, it’d be hard to find a better provider of obsolete or hard to find products.
Applied Materials
CONSISTENTLY DELIVERS QUALITY SOLUTIONS
Over the years, the equipment used in our company becomes discontinued, but they’re still of great use to us and our customers. Once these products are no longer available through the manufacturer, finding a reliable, quick supplier is a necessity, and luckily for us, GID Industrial has provided the most trustworthy, quality solutions to our obsolete component needs.
Nidec Vamco
TERRIFIC RESOURCE
This company has been a terrific help to us (I work for Trican Well Service) in sourcing the Micron Ram Memory we needed for our Siemens computers. Great service! And great pricing! I know when the product is shipping and when it will arrive, all the way through the ordering process.
Trican Well Service
GO TO SOURCE
When I can't find an obsolete part, I first call GID and they'll come up with my parts every time. Great customer service and follow up as well. Scott emails me from time to time to touch base and see if we're having trouble finding something.....which is often with our 25 yr old equipment.
ConAgra Foods