JASPER ELECTRONICS 1580 North Kellogg Drive Anaheim, Calif. 92807 Phone: (714) 917-0749 Fax: (714) 917-0786 Email: r.nishimoto@jasperelectronics.com Web: www.jasperelectronics.com TL MODEL SERIES 200 – 400 WATT SINGLE AND MUTLIPLE OUTPUT Features: • 1U High • >0.99 Line Power Factor Corrected • Single Wire Current Sharing • International Safety Approved • AC/Power Good LED Display • Fan Cooled – Optional • UL, CE, cULus Approved MODEL SELECTION GUIDE JASPER ELECRONICS TL SERIES A number of typical standard models are shown on the following charts. Many other configurations are available with various output modules and options. Please consult your sales representative or the factory for more information. TYPICAL STANDARD MODELS 200 WATTS # of Outputs Model Main, V1 Volts/Amps V2 Volts/Amps V3 Volts/Amps V4 Volts/Amps 1 TL201-0 3.3 @ TBD TL201-1 5 @ TBD TL201-2 12 @ 16.7 TL201-5 24 @ 8.3 TL201-8 48 @ 4.2 2 TL202-10 5 @ 25 3.3 @ 25 TL202-12 5 @ 25 12 @ 10 TL202-13 5 @ 25 15 @ 6 TL202-02 3.3 @ 25 12 @ 10 3 TL203-122 5 @ 25 12 @ 8 12 @ 3 TL203-102 5 @ 25 3.3 @ 20 12 @ 3 TL203-121 5 @ 25 12 @ 8 5 @4 TL203-133 5 @ 25 15 @ 6 15 @ 3 TL203-022 3.3 @ 30 12 @ 8 12 @ 3 4 TL204-1222 5 @ 25 12 @ 8 12 @ 3 12 @ 3 TL204-1221 5 @ 25 12 @ 8 12 @ 3 5 @ 3 TL204-1022 5 @ 25 3.3 @ 15 12 @ 3 12 @ 3 TL204-1021 5 @ 25 3.3 @ 15 12 @ 3 5 @ 3 TYPICAL STANDARD MODELS 300 WATTS # of Outputs Model Main, V1 Volts/Amps V2 Volts/Amps V3 Volts/Amps V4 Volts/Amps 1 TL301-0 3.3 @ TBD TL301-1 5 @ TBD TL301-2 12 @ 12.5 TL301-5 24 @ 12 .5 TL301-8 48 @ 4.2 2 TL302-10 5 @ 40 3.3 @ 40 TL302-12 5 @ 40 12 @ 15 TL302-13 5 @ 40 15 @ 15 TL302-02 3.3 @ 40 12 @ 15 3 TL303-122 5 @ 30 12 @ 10 12 @ 3 TL303-102 5 @ 30 3.3 @ 30 12 @ 3 TL303-121 5 @ 30 12 @ 10 5 @ 3 TL303-133 5 @ 30 15 @ 8 15 @ 3 TL303-022 3.3 @ 30 12 @ 10 12 @ 3 4 TL304-1222 5 @ 30 12 @ 9 12 @ 3 -12 @ 1 TL304-1221 5 @ 43 12 @ 9 12 @ 3 -5 @ 1 TL304-1022 5 @ 30 3.3 @ 30 12 @ 3 -12 @ 1 TL304-1021 5 @ 30 3.3 @ 30 12 @ 3 - 5 @ 1 TYPICAL STANDARD MODELS 400 WATTS # of Outputs Model Main, V1 Volts/Amps 1 TL401-5 24 @ 17 TL401-6 28 @ 14 TL401-8 48 @ 8.3 TL PRODUCT SPECIFICATIONS JASPER ELECRONICS TL SERIES Ripple & Noise (PARD) Power Good AC INPUT 50mV or <1% peak-peak nominal, Loss of input AC causes a TTL whichever is greater, at output terminals compatible signal to go low > 4msec Power Factor with 20 Mhz bandwidth limit, may be prior to any output dropping out of > 0.99 power factor at full power measured with 0.1uF ceramic capacitor regulation. At AC turn-on, signal stays in parallel with 22uF tantalum capacitor low until all outputs are in regulation. Input Operating Range connected. PG signal also triggered by an under 90 – 264 VAC, single phase voltage condition on any output. 47-63 Hz. Internally fused for 6.3A Temperature Coefficient o < + 0.02%, per degree C, 0-50 C, after LED Indicator Inrush Limiting 20 minutes warm-up. Green indicates AC power on and Thermistor soft start outputs within regulation. Off indicates 15A peak at 115 VAC, 25 C. (Cold Start) Dynamic Response input and/or output power fault. 30 A peak at 230 VAC, 25 C. (Cold (with 25 % load change, at 1A/usec) Start) Less than 3% deviation. Output returns OPERATING ENVIRONMENT to within 1% in less than 300 usec. Input Transient Protection MOV Protection. Withstands transients Operating Temperature o Current Share/Parallel N+1 Operation as specified by EN61000-4.5. 0 to 50 C at full load Load sharing within 10%by single wire connection on V1 and aux. output with Turn-on Time Storage Temperature o lo>5A. < 2 sec from AC turn on. -40 to 85 C < 100 msec from remote on/off. Relative Humidity Minimum Load Minimum Load Efficiency Up to 90% RH non-condensing. 70% Typical 10% load on V1 is required for 21X and Altitude 31X models. None is required for 20X Operating – 10,000 FT. DC Outputs and 30X models. Storage – 30,000 FT. Remote Sense Overshoot Operating Vibration .5V of cable loss on V1 and V2 None for turn-on or turn-off. 0.75 G peak, 5-500Hz along three (lo >5A) orthogonal axis. Overload/Short Circuit Protection Load current hiccup for single output Line and Load Regulation Cooling models and V1 on 21X and 31X models. Over AC input range and 0 to 100% At least 10 cfm direct air flow required to Constant current limit on all other load: achieve full rating power and specified outputs. Automatic recovery when <+1% for V1 and V2 (lo>5A) MTBF. overloading is removed. <+5% for V3 and V4 or output with lo<3A Safety Overvoltage Protection Recognized to U.S. and Canadian Bi- Available on outputs with lo>5A(V2-V4). Stability National Standard CSA C22.2 No. Non-crowbar type, set at 125%. rd <0.2% after 20 minutes warm-up. 60950 / UL 60950, Third (3 ) Edition Remote on/off or AC recycle is required (cULus); TUV approval pending. to reset. Hold-up Time CE Marked. >20 msec at full load. Overtemperature Protection EMI Internal temperature sensing. Meets CISPR22B level B, and EN Automatic recovery. 55022 level B. Remote On/Off Immunity Disabled by closed circuit or TTL logic 0. Complies with EN 50082-1, IEC 802- Enabled by open switch or TTL logic 1. 2,3,4. MTBF Designed for 150,000 hour. JASPER ELECRONICS TL SERIES TL MECHANICAL SPECIFICATIONS TL SINGLE OUTPUT MODEL TL MECHANICAL SPECIFICATIONS JASPER ELECRONICS TL SERIES TL MULTIPLE OUTPUT MODEL