INTERPHASE iSPAN 3639
Datasheet
Extracted Text
® iSPAN 3639 AdvancedMC™ T1/E1/J1 Communications Controller Quad/Octal Port Multiprotocol Controller for Signaling and Media Applications on AdvancedTCA and µTCA Platforms FEATURES APPLICATIONS Four or Eight T1/E1/J1 interfaces Softswitches and MSC Servers Media Gateways Optimized for Signaling and Media applications Serving / Gateway GPRS Support Nodes (xGSNs) Media Servers Signaling Gateways Call Servers Designed for ATCA and µTCA platforms Wireless BSCs/RNCs HLRs Rich and field-proven Software Development Suite (iWARE) On-board support for multiple network protocols: • SS7 (MTP1 & MTP2) LSL/HSL Designed for Signaling and Media Applications • SAAL/GR-2878 The iSPAN 3639 AdvancedMC™ T1/E1/J1 communications controller from Interphase • ATM (incl. IMA) delivers a comprehensive high-capacity connectivity solution for use with AdvancedTCA • Frame Relay and MicroTCA platforms to deliver a wide range of Voice-Over-IP, Wireless and IP Multi- • HDLC & Media Interface Media Subsystem (IMS) infrastructure application elements. • I-TDM Pre-integrated with various 3rd High Performance and Capacity party upper layer protocol stacks With up to 8 T1/E1/J1 interfaces, the iSPAN 3639 provides a high-capacity solution for signaling and media applications and enables optimization of slot usage. With support Single width, Mid-size or Full-size for a high-performance PCI-Express interface to a host processor, or gigabit Ethernet PICMG AMC.0 R2.0 compliant connectivity to the AdvancedMC connector, the iSPAN 3639 enables rapid exchange of Front or Rear access payload information and is hence ideal for a broad spectrum of applications requiring T1/E1/J1 connectivity. Optional acceleration of media termination and circuit switching* Powerful Solution Architecture TM Freescale™ MPC8560 The iSPAN 3639 incorporates the Freescale PowerQUICC III communications (PowerQUICC III™) on-board controller to deliver high-performance and high-capacity processing of signaling traffic. processor @ 833 MHz With the addition of an optional FPGA-based support for TDM switching* and I-TDM PCI-Express (AMC.1) and Gigabit protocol conversion, the 3639 can be used for full capacity media termination and media Ethernet (AMC.2) connectivity switching applications. Support of telecom clocks TCLKA, TCLKB, TCLKC and TCLKD. 2/1/10 www.iphase.com iSPAN 3639 AdvancedMC T1/E1/J1 Communications Controller 3639 Solution Components ® AdvancedMC Connectivity iWARE Software Development Suite (SDS) PCI-Express x1 link on AMC port 4 (AMC.1 Type 1) The iWARE SDS is an integrated set of embedded firmware, host drivers and utilities that accelerates application development and eases integration 2 Gigabit Ethernet links on AMC port 0 (AMC.2 Type E1) and 8 (AMC.2 T1) of the iSPAN 3639 to deliver end applications. Protocols provided: Optional I-TDM Gigabit Ethernet link on AMC port 1 or 9 SS7 MTP1 and 2 (up to 128 LSLs) Telecom clocks on TCLKA and TCLKB, optionally TCLKC/D ATM AAL0, AAL2, and AAL5, with IMA capability PCI-Express 100 MHz clock input on AMC FCLKA SSCF and SSCOP (SAAL) rd T1/E1/J1 line signals on AMC port 20-12 towards 3 -party Rear Transition Frame Relay Module HDLC and Enhanced Media transfers (HMP applications)* Processor/Memory I-TDM for media transport over Ethernet backplane PowerQUICC III (MPC8560) RISC processor, allowing full support of various iWARE SDS provides the same API in PCI-Express and Ethernet modes. communication protocols, and reducing host CPU processing Optional FPGA-based media termination and switching Application Example: The iSPAN 3639 provides the PSTN interface to a 128 MB of DDR SDRAM on SODIMM (up to 1GB) µTCA VoIP Access Gateway (1K media channels with embedded Signaling Gateway): Optional SDRAM for CPM tables (best CPM performances) Signaling (iWare / IP) 16 MB downloadable 8-bit Flash Memory Control (API / Ethernet) Media (I-TDM / Ethernet) Option for up to 256 MB of NAND Flash Network Interfaces The 3639 can interface with PSTN/ISDN networks via: Four or eight individually software selectable T1/E1/J1 lines o Front access, on 4 RJ45 connectors, each supporting 2 lines, or o Rear access, on AMC ports 20 to 12 o QuadFALC™ framers supporting long or short haul interfaces, AMI, HDB3, or B8ZS line coding and various superframe SS7 TDM Voice RTP H.248 SIGTRAN formats PSTN I-TDM over a Gigabit Ethernet link on AMC connector (line interfaces are IP X located on another card in the system) Class 5 Media Media Softswitch Server Gateway Telecom Clock Management Controller Line interfaces configurable in LT (clock slave) or NT (clock master) mode (lines can have independent clock rhythms) Three synchronization modes supported: Technical Specifications o Free running internal clock Architecture Processor MPC8560 @ 833 MHz o Recovered clock (loop back timing) from any T1/E1/J1 line RAM Memory 128 MB DDR SDRAM or SODIMM o System telecom clock reference (via AMC TCLKA or TCLKC) ROM Memory 16 MB NOR Flash, 128 MB NAND Flash Clock can be forwarded to AMC TCLKB or TCLKD Connectivity AMC.1 (PCI Express), AMC.2 (Ethernet) Board Development Kit Mechanical The 3639 BDK is specific to the 3639 hardware and not tied to a particular Form Factor AdvancedMC single-width Full/Mid-size operating system environment. The kit contains the following main components: Length 180.6 mm (7.11 in.) Width 73.5 mm (2.89 in.) (single-width) Boot Firmware with power-on self-test, power-on boot sequence, built-in self- test and configuration via a command line interface Operating Environment Setup and Built-in Self-test utilities, Documentation Power Consumption 20 W typ. / 24 W max. Temperature 0 to 55 ˚C (32 to 131 ˚F) Board Support Package Storage Range –40 to 80 ˚C (–40 to 176 ˚F) The 3639 Linux BSP provides kernel, development environment and basic Relative Humidity 5% to 95% non-condensing drivers for use with Linux to develop embedded software on the 3639. Altitude 0 to 15,000 ft About Interphase Corporation Corporate Headquarters European Headquarters Asia/Pacific Headquarters 2901 N. Dallas Parkway 855, avenue Roger Salengro 27 Brallas Avenue Interphase Corporation (NASDAQ: INPH) delivers solutions for Plano, Texas 75093 92370 Chaville St. Ives NSW 2075 network connectivity, interworking, and packet processing for 1-800-FASTNET France Australia key applications for the communications, Mil/Aero, and Phone: + 1.214.654.5000 Tel.: + 33 (0) 1 41 15 44 00 Tel.: + 612 9440 2140 enterprise markets. Founded in 1974, Interphase provides Fax: + 1.214.654.5500 Fax: + 33 (0) 1 41 15 12 13 Fax: + 612 9440 2141 expert customization services and contract manufacturing, in addition to its COTS portfolio, and plays a leadership role in next © 2009 Interphase, “Designed to Perform. Designed to Last.”, and the Interphase logo are registered generation AdvancedTCA® (ATCA), AdvancedMC™ (AMC), trademarks. All other trademarks are the property of their respective manufacturers. Specifications and PCI-X, and PCIe standards and solutions. Interphase is features subject to change without notice. headquartered in Plano, Texas, with sales offices across the (*) Future evolution globe. www.iphase.com iSPAN 3639 AdvancedMC T1/E1/J1 Communications Controller MCH iSPAN 3639 iSPAN 3639 iSPAN 3639 iSPAN 3639 DSP DSP Pkt Proc. Pkt Proc. Sig. GW & Syst. Ctlr Sig. GW & Syst. Ctlr MCH
Frequently asked questions
What makes Elite.Parts unique?

What kind of warranty will the iSPAN 3639 have?

Which carriers does Elite.Parts work with?

Will Elite.Parts sell to me even though I live outside the USA?

I have a preferred payment method. Will Elite.Parts accept it?

What they say about us
FANTASTIC RESOURCE
One of our top priorities is maintaining our business with precision, and we are constantly looking for affiliates that can help us achieve our goal. With the aid of GID Industrial, our obsolete product management has never been more efficient. They have been a great resource to our company, and have quickly become a go-to supplier on our list!
Bucher Emhart Glass
EXCELLENT SERVICE
With our strict fundamentals and high expectations, we were surprised when we came across GID Industrial and their competitive pricing. When we approached them with our issue, they were incredibly confident in being able to provide us with a seamless solution at the best price for us. GID Industrial quickly understood our needs and provided us with excellent service, as well as fully tested product to ensure what we received would be the right fit for our company.
Fuji
HARD TO FIND A BETTER PROVIDER
Our company provides services to aid in the manufacture of technological products, such as semiconductors and flat panel displays, and often searching for distributors of obsolete product we require can waste time and money. Finding GID Industrial proved to be a great asset to our company, with cost effective solutions and superior knowledge on all of their materials, it’d be hard to find a better provider of obsolete or hard to find products.
Applied Materials
CONSISTENTLY DELIVERS QUALITY SOLUTIONS
Over the years, the equipment used in our company becomes discontinued, but they’re still of great use to us and our customers. Once these products are no longer available through the manufacturer, finding a reliable, quick supplier is a necessity, and luckily for us, GID Industrial has provided the most trustworthy, quality solutions to our obsolete component needs.
Nidec Vamco
TERRIFIC RESOURCE
This company has been a terrific help to us (I work for Trican Well Service) in sourcing the Micron Ram Memory we needed for our Siemens computers. Great service! And great pricing! I know when the product is shipping and when it will arrive, all the way through the ordering process.
Trican Well Service
GO TO SOURCE
When I can't find an obsolete part, I first call GID and they'll come up with my parts every time. Great customer service and follow up as well. Scott emails me from time to time to touch base and see if we're having trouble finding something.....which is often with our 25 yr old equipment.
ConAgra Foods