COMPULAB ARMBASE
Specifications
Active power consumption
5 - 7 W, depending on configuration and CPU speed
Audio
ALC662 codec, HD audio interface, stereo microphone and line inputs, 5.1 channel SPDIF output
BIOS Flash
1 MB, on-board reprogrammable
Connectors
2 x 140 pin, 0.6 mm. Insertion / removal up to 50 cycles
CPU
Intel Atom (Tunnel Creek) Processor: E620 @600MHz, E640 @1GHz, E660 @1.3GHz or E680 @1.6GHz. L2-512KB (dynamic sizing), L1- 32KB IC, 24KB DC. Intel Deep Power Down (C6) technology support
Dimensions
65 x 75 x 8 mm
Display Interface
LCD – 18 bpp parallel RGB for TFT panels
DRAM
512 - 2048 MB DDR2, 800 MHz, 32-bit
Ethernet
Two 1000 Mb/s ports, Activity LED's. Using Realtek RTL8111 controllers
GPIO
14 dedicated and 4 shared lines
Graphics Controller
Resolution up to 1920 x 1080 x 32 bpp frame buffer in system memory, 2D, 3D graphics accelerator and multimedia accelerator optimized for HD video.
Hard Disk Interface
Two SATA-II interfaces
LPC bus
Host, 33 MHz, Intel LPC v1.0 compatible
Minimal power off time
2 sec (minimum time to stay off before next power on)
MTBF
> 100,000 hours
Operation temperature (case)
Commercial:0° to 70°C
PCIexpress bus
PCI Express Base Specification, Revision 1.0a. One or two lanes.
Processor
Intel Atom
Relative humidity
10% to 90% (operation)
RTC
Real Time Clock, powered by external lithium battery
SDIO
One external 4-bit port with SDHC support
Serial Port
4 UART's, one with full modem controls and RS232 levels, and 3 RX/TX, TTL
Shock
50G / 20 ms
Solid State Disk
8-32 GB on-board storage based on bootable micro-SD with SDHC support N
Storage temperature
-40° to 85° C
Supply Voltage
5 volt
USB
6 Host USB 2.0 ports, 480 Mbps, EHCI / UHCI compliant
Vibration
20G / 0 - 600 Hz
Watchdog
Wide range programmable watchdog timer
Weight
35 gram
Features
- 1 – 512 MB Flash Disk
- 16 – 64 MB SDRAM
- COM1 – 4 with RS232 / RS485 / RS422 / TTL driver options
- Hard disk interface
- Host and slave USB ports
- Intel’s XScale PXA255 CPU, up to 400 MHz
- IrDA, LPT, GPIO, PS/2 keyboard and mouse interfaces
- PC/104+ Single Board Computer implemented by combination of the CM-X255 module and SB-X255 baseboard.
- PCI and Local Bus expansions in PC/104+ format
- RTC with Lithium battery (optional)
- Single or dual 10/100BaseT Ethernet ports (optional)
- Single or Dual PCMCIA slots (optional)
- Small size – 96 mm x 91 mm
- Sound I/O (optional)
- VGA graphics controller. Connectors for LCD panel and CRT monitor (optional)
Datasheet
Extracted Text
Página Web 1 de 4 The Home of the World's Best Computer-On-Module's Products Developer Prices News About CompuLab Home Sales & Support Products SBC-X255 Board Computer- On-Module's CM-X270 CM-X255 CM-iGLX CM-F82 CM-i686M CM-i686B CM-iVCF Top view Bottom view View with interface cable CM-i886 (NFND) SB-X255 Highlights CM-i586 (NFND) PC/104+ & The SBC-X255 is a standard PC/104+ z PC/104+ Single Board Computer ATX boards compliant, single board computer. It is implemented by combination of the implemented by CM-X255 module providi SBC-X270 CM-X255 module and SB-X255 most of the functions, and SB-X255 carrie baseboard. SBC-X255 board providing connectors and several z Intel's XScale PXA255 CPU, up to additional functions. The rich features set SBC-i686 400 MHz the SBC-X255 is customizable according SBC-iVCF the price / performance targets of the use z 16 - 64 MB SDRAM SBC-i886 application. (NFND) z 1 - 512 MB Flash Disk The SBC-X255 contains PC/104+ expans ATX z PCI and Local Bus expansions in connectors which open it to the wide rang PC/104+ format of standard peripheral cards. Furthermore Related the SBC-X255 contains a PCMCIA contro z COM1 - 4 with RS232 / RS485 / Topics: and slots. A PCMCIA card may be inserte RS422 / TTL driver options and secured in the slot, with no additional - CoM z mechanical means. Off-the-shelf PCMCIA IrDA, LPT, GPIO, PS/2 keyboard Comparison modules can extend the system with and mouse interfaces capabilities such as a larger solid state dis - PC/104 z Host and slave USB ports modem, and wireless LAN. Comparison z Hard disk interface - Linux For more information, see Developer Support z (optional) Sound I/O Resources page. - Evaluation z VGA graphics controller. Kits Connectors for LCD panel and - Industrial (optional) CRT monitor Temperature z Single or dual 10/100BaseT - RoHS Ethernet ports (optional) Compliance z Single or Dual PCMCIA slots (optional) z RTC with Lithium battery (optional) z Small size - 96 mm x 91 mm http://www.compulab.co.il/x255/html/x255-sb-datasheet.htm 03-09-2006 Página Web 2 de 4 Block Diagram SBC-X255 Features The "SB Option" column specifies the P/N code of SB-X255 required to have the particular feat "CM Option" column specifies the P/N code of CM-X255 required to have the particular feature. X255 content is the combination of features provided by the attached CM-X255 and the feature implemented on the SB-X255. To have the particular feature, both the CM and SB options of th feature must be implemented. "+" means that the feature is always available, regardless of P/N code. SB Feature Specification Option O CPU SDRAM See Features List of CM-X255 module Flash Disk COM-A Rx/Tx or full modem, RS-232 levels, standard 10-pin header + http://www.compulab.co.il/x255/html/x255-sb-datasheet.htm 03-09-2006 Página Web 3 de 4 COM-B Rx/Tx only, TTL levels, on common 100-mil header + COM-C Full modem, RS-232 levels, standard 10-pin header + Full modem, RS-232 / RS-485 / RS-422 / TTL level options, COM-D X standard 10-pin header IrDA SIR and FIR modes. Standard header for IrDA module + LPT Standard 26-pin header for DB-25 cable/connector. Shared with (Parallel + FDC Port) PIO mode. Derived from local bus. Standard 40-pin header for IDE + HDD cable FDC Routed through LPT header + One or two 10/100BaseT Ethernet ports: 1. Module's port - DM9000, local bus interface + Ethernet 2. Baseboard port Realtek RTL8139 controller PCI interface E2 10-pin header per port. Optional interface module with transformer, RJ-45 connector and activity LED's. STN and TFT panels support. 51-pos FPC connector for direct LCD Panel L interface to certain TFT panels RGB signals are derived from TFT interface by using DAC's. 10-pin CRT Monitor header. Optional interface module with standard HD-15 VGA V connector. PS/2 Standard headers for PS/2 cable/connector + GPIO 9 to 14 lines, on common 100-mil header. + Support for 16-bit PCMCIA only. The 32-bit CardBus standard is not supported. PCMCIA Cx Single or dual PCMCIA slot with card guides, for card types I, II and III. Host USB Two Host ports, 12 Mbps. Header for Type-A cable/ connector. + Slave USB One Slave port, 12 Mbps. Header for Type-A cable/ connector. + Header for standard cable/connectors for Microphone (mono), Line Sound I/O + input and Speakers (stereo) Derived from CPU's local bus through buffers. 20 bit address. Few PC104 P interrupts. No DMA Support. Standard PC/104 connector PC104+ PCI bus through standard PC/104+ connector R RTC Battery The battery for Real Time Clock + LPC bus LPC bus on common 100-mil header + Electrical, Mechanical and Environmental Specifications 5.0V or 3.3V or both. Supply Voltage (The 3.3V option is only for cards without Audio and Super-I/O chips) Up to 3.0 W if powered from 3.3V source Power Consumption Up to 4.5 W if powered from 5.0V source 96 mm x 91 mm x [10-22 ] mm. Dimensions Height ranges from 10 mm to 22 mm, depending on the connectors assembled. Height specified includes the CM-X255 module. o o Commercial: 0 to 70 C o o Operation temp (case) Extended: -20 to 70 C o o Industrial: -40 to 85 C. Click for availability note http://www.compulab.co.il/x255/html/x255-sb-datasheet.htm 03-09-2006 Página Web 4 de 4 o o Storage temperature -40 to 85 C 10% to 90% (operation) Relative humidity 05% to 95% (storage) Shock 50G / 20 ms Vibration 20G / 0 - 600 Hz MTBF > 100,000 hours For more information see: - SB-X255 Reference Guide - Developer Resources Copyright (C) CompuLab 1999-2006 Contact http://www.compulab.co.il/x255/html/x255-sb-datasheet.htm 03-09-2006
Frequently asked questions
What makes Elite.Parts unique?

What kind of warranty will the ARMBASE have?

Which carriers does Elite.Parts work with?

Will Elite.Parts sell to me even though I live outside the USA?

I have a preferred payment method. Will Elite.Parts accept it?

Why buy from GID?

Quality
We are industry veterans who take pride in our work

Protection
Avoid the dangers of risky trading in the gray market

Access
Our network of suppliers is ready and at your disposal

Savings
Maintain legacy systems to prevent costly downtime

Speed
Time is of the essence, and we are respectful of yours
What they say about us
FANTASTIC RESOURCE
One of our top priorities is maintaining our business with precision, and we are constantly looking for affiliates that can help us achieve our goal. With the aid of GID Industrial, our obsolete product management has never been more efficient. They have been a great resource to our company, and have quickly become a go-to supplier on our list!
Bucher Emhart Glass
EXCELLENT SERVICE
With our strict fundamentals and high expectations, we were surprised when we came across GID Industrial and their competitive pricing. When we approached them with our issue, they were incredibly confident in being able to provide us with a seamless solution at the best price for us. GID Industrial quickly understood our needs and provided us with excellent service, as well as fully tested product to ensure what we received would be the right fit for our company.
Fuji
HARD TO FIND A BETTER PROVIDER
Our company provides services to aid in the manufacture of technological products, such as semiconductors and flat panel displays, and often searching for distributors of obsolete product we require can waste time and money. Finding GID Industrial proved to be a great asset to our company, with cost effective solutions and superior knowledge on all of their materials, it’d be hard to find a better provider of obsolete or hard to find products.
Applied Materials
CONSISTENTLY DELIVERS QUALITY SOLUTIONS
Over the years, the equipment used in our company becomes discontinued, but they’re still of great use to us and our customers. Once these products are no longer available through the manufacturer, finding a reliable, quick supplier is a necessity, and luckily for us, GID Industrial has provided the most trustworthy, quality solutions to our obsolete component needs.
Nidec Vamco
TERRIFIC RESOURCE
This company has been a terrific help to us (I work for Trican Well Service) in sourcing the Micron Ram Memory we needed for our Siemens computers. Great service! And great pricing! I know when the product is shipping and when it will arrive, all the way through the ordering process.
Trican Well Service
GO TO SOURCE
When I can't find an obsolete part, I first call GID and they'll come up with my parts every time. Great customer service and follow up as well. Scott emails me from time to time to touch base and see if we're having trouble finding something.....which is often with our 25 yr old equipment.
ConAgra Foods