UCS1001_MDS_RevB (pdf) 10/4/01 9:20 AM Page 1 UCS 1001 Universal Chassis System The UCS 1001 is a general-purpose 1U, two slot chassis. Flexible and scalable, the UCS 1001 accommodates the entire Canoga Perkins’ Universal Chassis System product line, including Optical Transponders and Repeaters, WDM, 10/100/1000 Ethernet, T1/E1 and T3/E3 Modems. It is ideal for customer premises installation, enterprise networks and military installations. The UCS 1001 is an ideal solution when a combination of T1/E1 and T3/E3 modems, WDM, and/or Ethernet products are required. Other primary applications include Last Mile Service Providers, Secure Datacom requirements, and Dark Fiber Connectivity (leased/owned fiber). The UCS 1001 complements the UCS 1000 5U chassis for installations where only one or two modules are required, thus offering a lower cost and smaller footprint utilizing less rack space. Additionally, this chassis accommodates fully redundant T1/E1 modems and T3/E3 modems. Redundant power is also an option. Hot Swappability All modules inserted in the two slots are hot swappable for easy replacement and will not interrupt the operation of the other module. This provides immediate recovery time. Redundancy The UCS 1001 chassis backplane provides communication between the two modules. In cases of full redundancy, the troubled module is able to be replaced without the interruption of operation of the sister module. The backup or redundant link or module will be monitored for operational status by the active module. The enclosure is for tabletop or rack mounting. 19” rack mount brackets are included, and optional 23” mounting features brackets are available. Modular Carrier-Class Chassis System Fault Tolerant and Redundant Cost Effective - Low Entry Price Modularity for Flexibility and Reduced Cost of Ownership Redundant Power Supplies Input and Output Alarms transparent optical networking Hot Swappable Modules 6052600 Rev B UCS1001_MDS_RevB (pdf) 10/4/01 9:20 AM Page 2 UCS 1001 Universal Chassis System Five models are available depending on the desired POWER power supply configurations: Single Optional (AC only or DC only) Redundant 1001-2100 Single AC Power Supply Optional (AC/AC, DC/DC or AC/DC) 1001-7100 Redundant AC Power Supply AC Power Supply 1001-2400 Single DC Supply 24W, 85 to 270VAC, 0.6/0.2A, 50 to 60Hz input DC Power Entry Module 1001-7400 Redundant DC Power Supply 24W, -48VDC, 0.75A input 1001-7500 Redundant AC and DC Operation Chassis Total Power Consumption 48W maximum PHYSICAL Backplane Circuit Board Dimensions -36 to -58VDC input, 180mA maximum per slot 1.719”H x 17.5”W x 14”D (43.7 x 444.5 x 355.6 mm) CONNECTORS Weight AC Power Supplies Chassis Unpopulated IEC inlet 4.3 lb (1.95kg) DC Power Supplies -48VDC quick disconnect terminal block ALARMS Alarms Two sets of input and output alarm connectors are provided in the rear of the unit. Each set enables both Dry contact relay alarms major and minor alarms. ENVIRONMENTAL Status LEDs Operating Temperature Power Supply 1 (GREEN or OFF) 0 - 55˚C with fan cooling Green if output is within specification Humidity OFF if power supply not installed or bad 10 - 90% relative humidity non-condensing Power Supply 2 (GREEN or OFF) Green if output is within specification REGULATORY COMPLIANCE OFF if power supply not installed or bad UL 1950 / CSA C22.2 No.950 MAJ (RED or OFF) IEC 60950 Red if a major alarm (UCS Module) has IEC 60825-1 FCC Part 15 Class A occurred EN55022 MIN (AMBER or OFF) EN50082-1 Amber if a minor alarm (UCS Module) has AS/NZS 3548 occurred or a single power supply has failed FCC Part 68 CTR 12, CTR 13, NTR 4, TS 016 SWITCH NEBS Level 3 Pending A front panel push button switch to acknowledge and clear the output alarms World Headquarters 20600 Prairie Street Chatsworth, CA 91311-6008 Phone (818) 718-6300 • Fax (818) 718-6312 E-mail: fiber@canoga.com www.canoga.com ISO 9001 Registered Specifications are subject to change without notice. The trademarks, service marks, and logos (”Marks”) displayed herein are the property of Canoga Perkins Corporation or other third parties. These Marks may not be used without the prior written consent of Canoga Perkins Corporation or a third party, which may own the Mark. Copyright© Canoga Perkins Corporation 2001. All rights reserved.