ASTEC SA202-3530

SA202-3530 200 WATTS SA202-3530 Total Power 200 Watts Input Voltages 90 - 135 VAC 180 - 265 VAC # of Outputs Six Product may vary slightly from photo. SPECIAL FEATURES ELECTRICAL SPECIFICATIONS • Auto Range AC input Input • 85 VAC Input* Input range ........................... 90(85*)-135 / 180-265 VAC auto select • CE Mark Frequency ............................ 47-63 Hz • 3.3 V output Input current ......................... 5 A @ 115 VAC; 3 A @ 230 VAC o •0 C operating temperature o Peak inrush current .............. <40 A peak @ 135 V, cold start at 25 C • +5 VSB Standby supply (SELV) Efficiency .............................. >65% @ full load, nominal line • Remote On/Off (ROO) EMI/RFI ................................ FCC Part 15, Subpart B Class B and • Energy Star CISPR 22 • High efficiency • High MTBF Output • Built-in EMI filter (CISPR 22 Class B) Maximum power ................... 200 W • IEC801-2,-4,-5 Hold-up time ......................... 17 ms at full load @ 115 VAC • Power good signal 20 ms at full load @ 230 VAC † • AC convenience outlet Transient response ............... All outputs shall stay within regulation for 20% load change from 10 Hz - 1 KHz * Minimum AC input voltage can be 85 Vrms with derating to and 50% duty cycle condition 160 W output power. Overvoltage protection ......... +3.3 V - trip point <4.6 V † AC output voltage from AC convenience outlet is dependent +5 V - trip point <7.0 V on input voltage. +12 V - trip point <15.6 V Recycle AC or PS-On to reset Short circuit protection ......... Latch off on main outputs if one of the mains short circuit to common (R <0.03 ENVIRONMENTAL Ohm), but +5 VSB shall remain normal. Operating Temperature: Recycle AC or PS-On to reset o o 0 C to +50 C ambient Leakage current ................... <1 mA @ 250 VAC to GND Power good signal ................ TTL compatibility. Power good sign goes o o Storage Temperature: -40 C to +70 C high after turn-on 100-500 ms. Signal goes low at least 1 ms before loss of Cooling: Self-contained fan regulation o MTBF: >100,000 hours at 75% load and 25 C Remote On/Off ambient conditions PS-On .................................. Active low, to turn main outputs on. TTL compatibility. SAFETY UL 1950 E132002 CSA 22.2-234 LR53982C VDE 0805 11774-3336-0268 NEMKO P97101648 IEC 950 EN 60950/ with Nordic deviation CB 3899 CE LVD USA: 1-888-41-ASTEC Europe (UK): 01384-842211 Asia (HK): 852-2437-9662 68 PC SA202-3530 Series ASTEC ASIA ASTEC EUROPE ASTEC AMERICA 6F., China Dyeing Works Building Astec House, Waterfront Business Park 5810 Van Allen Way 382-392 Castle Peak Road Merry Hill, Dudley Carlsbad, CA 92008 Tsuen Wan, N.T., Hong Kong West Midlands, DY5 1LX, UK Telephone: 760-930-4600 Telephone: 852-2437-9662 Telephone: 01384-842211 Facsimile: 760-930-0698 Facsimile: 852-2402-4426 Facsimile: 01384-843355 SPECIFICATIONS FOR SA202-3530 Output Voltage Regulation Minimum Maximum Peak Ripple 5 1 Load Load Load P/P(PARD) 2 V1 +3.3 V +/-5% 0 A 14.0 A — 50 mV 2 V2 +5 V +5 / -4% 1.5 A 22.0 A — 50 mV 3 V3 +12 V +/-5% 0 A 8.0 A 11 A 120 mV 4 V4 -12 V +/-10% 0 A 0.8 A — 120 mV 4 V5 -5 V +/-10% 0 A 0.5 A — 50 mV V6 +5 VSB +/-10% 0 A 0.2 A — 100 mV 1. Peak-to-peak with 20 MHz bandwidth and 10 uF in parallel with a 0.1 uF capacitor. 2. Total combined current on +3.3 V and +5 V rails is 22 A max. 3. +12 V output peak current <15 sec. 4. Total combined current on -5 V and -12 V rails is 1.0 A max. 5. Minimum load requirement must comply to “Load Range” in the Product Specification - contact factory. DRAWINGS PIN ASSIGNMENTS Connector Pin Output Mating Connector P1 1 Power Good Molex 8619-0602 or 2 +5 V Landwin 5201 or 3 +12 V Alex 8612-06 4 -12 V 5 Common 6 Common P2 1 Common Molex 8619-0602 or 2 Common Landwin 5201 or 3 -5 V Alex 8612-06 4 +5 V 5 +5 V 6 +5 V P3 1 Common Molex 8619-0602 or 2 Common Landwin 5201 or 3 Common Alex 8612-06 4 +3.3 V 5 +3.3 V 6 +3.3 V P4, 5 1 +12 V Molex 8981-4 or 2 Common AMP 1480426-0 KEY #4 3 Common Pin 6 - COM 12 REF. Pin 5 - COM 4 +5 V Pin 4 - —12 Pin 3 - +12 Pin 2 - +5V Pin 1 - PWGD P6 1 +5 V AMP171825-4 Pin 6 - +5V 2 Common Vertical MT or Pin 5 - +5V Pin 4 - +5V Pin 3 - —5V 3 Common AMP 1701826-4 Pin 2 - COM Pin 1 - COM 4 +12 V Horizontal MT KEY #1 Pin 6 - +3.3V Pin 5 - +3.3V Pin 4 - +3.3V Pin 3 - COM P7 1 +5 VSB AMP171825-3 Pin 2 - COM Pin 1 - COM 2 PS-On Vertical MT or KEY #5 3 Common AMP 171826-3 Pin 1 - +12V Pin 2 - COM Horizontal MT Pin 3 - COM Pin 4 - +5V Pin 1 - +12V Pin 2 - COM Pin 3 - COM Pin 4 - +5V NOTES 300 –15 1. Specification subject to change without notice. Pin1 - +5V Pin2 - COM Pin 3 - COM Pin 4 - +12V 300 –15 2. All dimensions are in inches (mm). Pin1 - +5VSB Pin2 - PS ON 3. Warranty: 1 year Pin 3 - COM 4. Weight: 1.20 kg Power Fax: 760-930-0881 Doc No: 1130 • REV 12.30.98 69