Total Power: 50-165 Watts Input Voltage: 85-264 VAC 50-165 Watts # of Outputs: Quad NTQ160 Series Electrical Specs Input Input range 85-264 VAC Frequency 47-63 Hz Inrush current 38 A max., cold start @ 25°C Efficiency 65% typical at full load @ 115 VAC input EMI filter FCC Class B conducted and radiated, CISPR 22 Class B conducted and radiated, EN55022 Class B conducted and radiated, VDE 0878 PT3 Class B conducted and radiated. Power factor 0.99 typical Safety ground leakage current <1 mA @ 50/60 Hz, 264 VAC input Special Features Output Maximum power 50W convection, 165 W with 30 CFM forced air • Active power factor correction Adjustment range 1.8V - 3.5V; 3.0V - 5.5V on outputs • EN61000-3-2 compliance one and two • Remote sense on outputs Hold-up time 20 ms @ 165 W load one and two Overload protection Short circuit protection on all outputs. • Power fail and remote inhibit Case overload protected @ 110-145% • 5V Standby output above peak rating. Latching type • DC Power good recycle AC to reset. • Single wire current sharing on Overvoltage protection Tracks outputs 1 & 2: 20% to 35% outputs one and two above output setting • Wide range adjustable on outputs 1 & 2 Standby output 5V@ 2 A regulated ±5% • Built-in Class B EMI filter • Overvoltage protection Logic Control • Overload protection Power failure TTL logic signal goes high 100-500 • Thermal overload protection msec after V1 output; it goes low at • Outputs 3 & 4 are floating least 4 msec before loss of regulation Remote Inhibit Requires contact closure to inhibit outputs Environmental Remote sense Compensates for 0.5 V lead drop minimum, will operate without Operating temperature: 0° to 50°C ambient; derate remote sense connected. Reverse each output at 2.5% per degree from connection protection. 50° to 70°C DC O TTL logic signal goes high after main output is in regulation. It goes low Electromagnetic susceptibility: Designed to meet when there is a loss of regulation. EN61000-4, -2, -3, -4, -5, -6, -8, -11 Level 3 Humidity: Operating; non-condensing Safety 10% to 95% VDE 0805/EN60950 (IEC950) 21310-3336-0021 Vibration: Three orthogonal axes, sweep at (129066) 1 oct/min, 5 min. dwell at four major resonances 0.7 UL UL1950 E186249 G peak 5 Hz to 500 Hz, operational CSA CSA 22.2-234 Level 3 LR109492C Storage temperature: -40° to 85°C NEMKO EN 60950/EMKO-TUE P00100493 (74-sec) 203 Temperature coefficient: ± .04% per °C BABT EN60950/EN41003 650251, NC/00069 MTBF demonstrated: >1 million hours at full load and CB Certificate and report 9661, 9662, 8788 25°C ambient conditions CE Mark (LVD) rev 04.29.04 Support: (888) 41-ASTEC or (407) 241-2752 Americas: (760) 930-4600 Europe (UK) 44 (1384) 842-211 Asia (HK) 852-2437-9662 116 R32 D13 R79 NTQ160 Series IC2 C1 D27 D24 L15 IC8 IC7 R84 R67 B- + SK6 + + B+ C72 C22 6 1 D12 D22 D21 + 7 2 THR3 PRI_DB 8 3 9 4 IC6 10 5 C31 + L9 C63 + THR2 C37 C36 IC9 C77 C38 C28 DB1 L13 C4 C5 R95 D20 R94 R58 R57 R56 D18 R55 C67 C66 Q1 L7 HTSK-PRI1 ASIA EUROPE AMERICAS Units 2111-2116, Level 21 Astec House, Waterfront Business Park 5810 Van Allen Way Tower1, Metroplaza Merry Hill, Dudley Carlsbad, CA 92008 223, Hing Fong Road West Midlands, DY5 1LX, UK Telephone: 760-930-4600 Fwai Fong, New Territories Telephone: 44 (1384) 842-211 Facsimile: 760-930-0698 Hong Kong Facsimile: 44 (1384) 843-355 Telephone: 852-2437-9662 Facsimile: 852-2402-4426 Ordering Information Model Output Minimum Maximum Load with Maximum Load with Peak Regulation2 Ripple Number Voltage Load Convection Cooling 30 CFM Forced Air Load1 P/P (PARD)3 NTQ162 +3.3 V(1.8 - 3.5V) 2 A 15 A 30 A 38 A ±2% 50 mV +5 V (3 - 5.5V) 0 A 10 A 20 A 22 A ±2% 50 mV 12 V* 0 A 2 A 4.5 A 5 A ±3% 120 mV 12 V* 0 A 2 A 4.5 A 5 A ±3% 120 mV NTQ163 +5 V (3 - 5.5V) 2 A 15 A 30 A 32 A ±2% 50 mV +3.3 V (1.8 - 3.5V) 0 A 10 A 20 A 22 A ±2% 50 mV 12 V* 0 A 2 A 4.5 A 5 A ±3% 120 mV 12 V* 0 A 2 A 4.5 A 5 A ±3% 120 mV NTQ165 +3.3 V (3 - 5.5V) 2 A 15 A 30 A 32 A ±2% 50 mV +2.5 V (1.8 - 3.5V) 0 A 10 A 20 A 22 A ±2% 50 mV 5 V* 0 A 2 A 4 A 5 A ±3% 120 mV 12 V* 0 A 2 A 4 A 5 A ±3% 120 mV * outputs are floating 1. Peak current lasting <30 seconds with a maximum 10% duty cycle. 2. At 25°C including initial tolerance, line voltage, load currents and output voltages adjusted to factory settings. 3. Peak-to-peak with 20 MHz bandwidth and 10 µF in parallel with a 0.1 µF capacitor at rated line voltage and load ranges. 4. Minimum loads are required. In parallel minimum loads are 2.5 A on the V1 output and 1 A on the V2 output for each power supply. 5. Total output current between V1 and V2 is 40A maximum. SK5 0.95 [24.0] 0.55 [14.0] Ordering Information SK2 SK3 SK4 SK6 Connector 4 32 1 a R46 + + + C85 R78 SK1 PIN 1 Ground C48 THR4 + PIN 3 Neutral + b + PIN 5 Live + SK2 V1 R77 SK3 Common C40 SK4 V2 R30 R66 R89 D23 L12 SK6 PIN 1 V4 Common SCR1 PIN 2 V4 PIN 3 V3 Common R35 PIN 4 V3 + 6.61 [168.0] 8.50 [216.0] + R48 SK5 PIN 1 V2 SWP R65 PIN 2 5V Standby 7.40 [188.0] PIN 3 +V2 Sense PIN 4 V1 SWP R39 D10 C18 T1-W1A C19 D17 R63 Z1 PIN 5 COMMON D11 C20 PIN 6 +V1 Sense C11 R31 PIN 7 Sense COMMON PIN 8 Remote Inhibit PIN 9 DC Power Good b PIN 10 Power Fail VDR1 Mating Connectors (SK1) AC Input: Molex: 09-50-8051 (USA) THR1 C71 a Molex: 09-91-0500 (UK) 53 1 PINS: 08-58-0111 SK1 SK2,3,4: Molex BB-124-08 0.75 [19.0] (SK6) ±12V Molex:09-50-8041 (USA) 4.25 [108.0] 1.50 [38.1] Molex: 09-91-0400 (UK) PINS: 08-58-0111 Notes: 1. Specifications subject to change without notice. (SK5) Control Signals: Molex: 90142-0010 2. All dimensions in inches (mm), tolerance ±.02”. PINS: 90119-2110 3. Remote inhibit requires an external contact closure to or activate Amp: 87977-3 4. Mounting maximum insertion depth is 0.12”. 5. Warranty: 1 year PINS: 87309-8 Astec Connector Kit #70-841-014, includes all of the above 6. Weight: 2.38 lb. /1.08 kg www.astecpower.com 117 D13 L4 HTSK-SEC1 Q3 1 12 D19 SK2 L6 L6 R27 C89 R73 C68 Q2 C33 C27 C91 R80 R24 SO1 R25 SK3 R26 67 C26 VR3 T2 C21 Q7 Q8 10 D9 SK4 T1-W1 TP1 HTSK-RECT Z4 R41 1 SEC_DB B- C 1999 ASTEC R64 Q5 CUSTOM POWER (PHIL.) C41 C42 C29 C24 C2 C3 Q4 C70 L5 F4A L2 L1 F1 250V B+ C9 T3 10 1 1 9 C47 C46 C43 R87 + SK1 SK1 C86 C84 5 4 C23 HTSK-SEC3 VR2 042-66102310D HTSK-SEC2 VR1 L3 HTSK-PRI2 C34 D1 R5 C10 D16 R6 Z2 R47 + C60 R34 C94 P401 R42 L8 THR5 R68 L10 + + + + + L11 SK5 C34 D1 R5 C10 D16 R6 Z2 R47 + C60 R34 C94 P401 R42 L8 THR5 R68 L10 + + + + + L11 SK5 R32 D13 R79 IC2 C1 D27 D24 L15 IC8 IC7 R84 R67 B- + SK6 + + B+ C72 C22 6 1 D12 + D22 D21 7 2 THR3 PRI_DB 8 3 9 4 IC6 10 5 C31 + + L9 C63 THR2 C37 C36 IC9 C38 C28 C77 DB1 L13 C4 C5 R95 D20 R94 R58 R57 R56 D18 R55 C67 C66 Q1 L7 HTSK-PRI1 SK5 0.95 [24.0] 0.55 [14.0] #6-32 (8 PLACES) 1.07 [27.3] 2.11 [53.5] SK2 SK3 SK4 SK6 4 32 1 M3 (8 PLACES) a a a R46 + + + C85 R78 C48 THR4 + + b b b + + R77 C40 R30 R89 R66 D23 L12 SCR1 R35 + 6.61 [168.0] 8.50 [216.0] + R48 R65 7.40 [188.0] R39 D10 C18 T1-W1A C19 D17 R63 Z1 D11 C20 C11 R31 b b b VDR1 THR1 C71 a a a 53 1 SK1 0.75 [19.0] 0.88 [22.3] 2.50 [63.5] 4.25 [108.0] 1.50 [38.1] NTQ160 S Series D13 HTSK-SEC1 L4 Q3 1 12 D19 L6 L6 SK2 R27 C89 R73 C68 C33 C27 Q2 C91 R80 R24 SO1 R25 SK3 R26 67 C26 VR3 T2 C21 Q7 Q8 10 D9 SK4 T1-W1 TP1 HTSK-RECT Z4 R41 1 SEC_DB B- C 1999 ASTEC Q5 R64 CUSTOM POWER (PHIL.) C42 C41 C29 C24 C2 C3 Q4 C70 L5 F4A L2 L1 F1 250V B+ C9 T3 10 1 1 9 C47 C46 C43 R87 + C86 C84 SK1 SK1 5 4 C23 HTSK-SEC3 VR2 042-66102310D HTSK-SEC2 L3 VR1 HTSK-PRI2