process yellow 116 1375 1797 375 3405 313 2985 240 Embedded Power for Business-Critical Continuity 242 2607 Rev.12.12.08_118 NFS40 Series 1 of 4 652 NFS40 Series SIngle and triple output Total Power: 40 - 50W Input Voltage: 85 - 264VAC 120 - 370VDC # of Outputs: Single, triple Electrical Specifications Input Special Features Voltage adjustability: +5 V output on triples ±5.0% • 5.0 x 3.0 x 1.2 inch package Vout on singles ±5.0% (1U applications) Line regulation: Main output ±0.2% • Industry standard package LL to HL, FL Auxiliary outputs ±1.0% • Overvoltage and Load regulation: Main output ±2.0% short circuit protection FL to NL Auxiliary outputs ±5.0% • 40 W with free air convection Transient response: +5 V (1.5 - 3 A) ± 120 mV max. dev. • 50 W with 20 CFM forced air 500 µs recovery • EN55022, EN55011 conducted noise level A Temperature coefficient: All outputs ±0.02%/°C • UL, VDE and CSA Overvoltage protection: +5 V output S3.15 A, 250 Vac In live and neutral safety approvals Output power limit: Primary power limited 90 W input power limit • Available RoHS compliant • 2 year warranty Short circuit protection: Single outputs Continuous Multiple outputs Short term Output Input voltage range: Universal input 85-264 Vac 120-370 Vdc Input frequency range: 47-440 Hz Max. input surge current: 132 Vac, cold start 12 A max. Safety 264 Vac, cold star 24 A max. • VDE0805/EN60950/ Safety ground leakage current: 110 Vac, 60 Hz 0.13 mA, max. • IEC950/IEC1010 230 Vac, 50 Hz 0.32 mA, max. • File No. 10401-3336-0044 • License No. 2559 • UL1950 File No. E136005 • CSA C22.2 No. 950 • File No. LR41062C process yellow 116 1375 1797 375 3405 313 2985 240 242 Embedded Power for Business-Critical Continuity 2607 Rev.12.12.08_118 NFS40 Series Specifications 2 of 4 652 All specifications are typical at nominal input, full load at 25 °C unless otherwise stated (11, 12) EMC Charateristics Conducted emissions: EN55022, FCC part 15 Level B Radiated emissions: EN55022 Level A ESD air: EN61000-4-2, level 3 Perf. criteria 1 ESD contact: EN61000-4-2, level 4 Perf. criteria 1 Surge: EN61000-4-2, level 3 Perf. criteria 1 Fast transients: EN61000-4-4, level 3 Perf. criteria 1 Radiated immunity: EN61000-4-3, level 3 Perf. criteria 2 Conducted immunity: EN61000-4-6, level 3 Perf. criteria 2 General Specifications Hold-up time: 110 Vac, 40 W 14 ms 230 Vac, 40 W 110 ms Efficiency: 70% typical Isolation voltage: Input/output 3000 Vac Input/chassis 1500 Vac Switching frequency: Variable Approvals and standards: (see VDE0805, EN60950, IEC950, IEC1010, Notes 9, 13) UL1950, CSA C22.2 No. 950 Weight: 280 g (9.88 oz) MTBF demonstrated: MIL-HDBK-217E 170,000 hours Environmental Specifications Thermal performance: Operating 0° C to +70 °C (See notes 8, 10) Non-operating -40 °C to +85 °C 50 °C ambient temp., 40 W convection cooled Forced air cooling 50 W @ 20 CFM +50 °C to +70 °C ambient Derate linearly to 50% load Peak (60 seconds) 60W Relative humidity: Non-condensing 5 to 80% RH Altitude: Operating 10,000 feet max. Non-operating 40,000 feet max. Vibration (See Note 11): 5-500 Hz 2.4 G rms peak process yellow 116 1375 1797 375 3405 313 2985 240 242 Embedded Power for Business-Critical Continuity 2607 Rev.12.12.08_118 Ordering Information NFS40 Series (4) (13, 14, F)  of 4 652 Output Output Currents Ripple Total Model Numbers (5) Voltage (1) (2) (3) Regulation Max Peak Fan (5,6) +5.1 V (A) 3 A 7 A 5 A 50 mV ±2.0% NFS40-7608J +12 V (B) 2 A 3 A 2 A 120 mV ±5.0% –12 V (C) 0.35 A 1 A 0.5 A 120 mV ±5.0% (12) +5.1 V (A) 4 A 7 A 5 A 50 mV ±2.0% NFS40-7628J +12 V (B) 0.35 A 1 A 0.5 A 120 mV ±5.0% -12 V (C) 0.35 A 1 A 0.5 A 120 mV +5.0% (5,6) +5.1 V (A) 3 A 7 A 5 A 50 mV ±2.0% NFS40-7607J +12 V (B) 2 A 3 A 2 A 120 mV ±5.0% -5.0 V (C) 0.35 A 1 A 0.5 A 50 mV ±5.0% (5,6) +5.1 V (A) 3 A 7 A 5 A 50 mV ±2.0% NFS40-7610J +15 V (B) 2 A 2.5 A 2 A 150 mV ±10.0%/-3.0% –15 V (C) 0.35 A 1 A 0.5 A 150 mV ±5.0% 3.3 V 6 A 12 A 8 A 100 mV ±2.0% NFS40-76S3J +5.1 V 6 A 12 A 8 A 100 mV ±2.0% NFS40-7605J +12.0 V 3.3 A 5 A 4 A 120 mV ±2.0% NFS40-7612J +15.0 V 2.6 A 4 A 3.3 A 150 mV ±2.0% NFS40-7615J +24.0 V 1.6 A 2.5 A 2 A 240 mV ±2.0% NFS40-7624J Notes Pin Connections 1 Natural convection cooled, 40 W maximum. 2 Peak output current lasting less than 30 seconds with duty cycle less than 10%. J1 -7608J, -7628J -7607J -7610J SINGLES During peak loading, outputs may go outside of total regulation limits. Peak total power must not exceed 60 W. Pin 1 AC Live AC Live AC Live AC Line 3 Forced air, 20 CFM at 1 atmosphere, 50 W maximum. 4 Figure is peak-to-peak. Output noise is measured across a 50 MHz bandwidth Pin 2 AC Neutral AC Neutral AC Neutral AC Neutral using a 12 inch twisted pair, terminated with a 47 µF capacitor. J2 5 Total regulation is defined as the static output regulation at 25 °C, including initial tolerance, line voltage within stated limits, load currents within stated Pin 1 +12 V +12 V +15 V +Vout limits, and output voltages adjusted to their factory settings. Also, 0.2550 °C, for o optimum reliability no part of the heatsink should exceed 110 C and no Pin 6 -12 V -5 V -15 V Return o semiconductor case temperature should exceed 115 C. (c) 9 A 4 W minimum load is recommended to achieve the design MTBF. P1 10 Caution: Allow a minimum of 1 second after disconnecting the power when making thermal measurements. Pin 1 Safety Ground 11 Three orthogonal axes, sweep at 1 octave/minute, 5 minute dwell at four major resonances. 12 The NFS40-7628J has separately linear regulated +12 V and -12 V outputs. The DERATING CURVE loading conditions in Notes 5 and 6 do not apply. Output Power (Watts) 13 This product is only for inclusion by professional installers within other 50W equipment and must not be operated as a stand alone product. 20 CFM FORCED AIR COOLING 14 The ‘J’ suffix indicates that these parts are Pb-free (RoHS 6/6) compliant. 15 NOTICE: Some models do not support all options. Please contact your local 40W Emerson Network Power representative or use the on-line model number search tool at http://www.powerconversion.com to find a suitable alternative. NATURAL 25W CONVECTION 20W COOLING 0C 10C 20C 30C 40C 50C 60C 70C process yellow 116 1375 1797 375 3405 313 2985 240 Embedded Power for Business-Critical Continuity 242 2607 Rev.12.12.08_118 NFS40 Series Mechanical Drawing 4 of 4 652 Americas 5.00 5810 Van Allen Way (127.00) 0.156 (3.96) Dia. Carlsbad, CA 92008 (4 Places) USA Telephone: +1 760 930 4600 MAXIMUM Facsimile: +1 760 930 0698 COMPONENT HEIGHT 1.2 inches NON-METALLIC C5 Europe (UK) STAND-OFF Waterfront Business Park (SEE NOTE A) Q1 Merry Hill, Dudley West Midlands, DY5 1LX United Kingdom 1 2.550 J1 Telephone: +44 (0) 1384 842 211 ~ (64.8) Facsimile: +44 (0) 1384 843 355 3.00 N T1 (76.2) ~ L J2 Asia (HK) F1 14/F, Lu Plaza 2 Wing Yip Street Kwun Tong, Kowloon F 3.15A, H 250VAC Hong Kong Telephone: +852 2176 3333 P1 (SEE NOTE C) 0.22 (5.59) Facsimile: +852 2176 3888 0.22 4.55 For global contact, visit: (5.59) (115.8) www.powerconversion.com techsupport.embeddedpower ALL DIMENSIONS IN INCHES (mm) @emerson.com Mechanical Notes A In order to meet safety requirements, a non-metallic stand-off is mandatory for one hole as specified in the mechanical While every precaution has been taken to ensure drawing above. accuracy and completeness in this literature, Emerson B The ground pad of the mounting hole near P1 allows system grounding through a metal stand-off. Network Power assumes no responsibility, and disclaims all liability for damages resulting from use of this C To improve conducted noise, the ground pad of the mounting hole near the output connector should be connected with information or for any errors or omissions. the ground pad of the mounting hole near P1. Use metal stand-offs attached to a common metal chassis. This connection also significantly attenuates common mode noise. D A standard L-bracket and cover is available for mounting which contains all screws, connectors and necessary mounting Emerson Network Power. hardware. Order part number ‘NFS40 COVER KIT’. The global leader in enabling business-critical continuity. AC Power Connectivity DC Power Embedded Computing Embedded Power Monitoring Outside Plant Power Switching & Controls Precision Cooling Racks & Integrated Cabinets Services Surge Protection EmersonNetworkPower.com Emerson Network Power and the Emerson Network Power logo are trademarks and service marks of Emerson Electric Co. ©2008 Emerson Electric Co.