BIOS

Award ROM-BIOS with Ampro enhancements (See Ampro Embedded-PC Enhancements section)

Bytewide Socket

Two 32-pin byte-wide memory sockets-usable with 32K-1M byte EPROMs, 32K-512K byte Flash EPROMs; 32K-512K byte SRAMs, or 32K-512K byte NOVRAMs; Onboard battery converts SRAM into NOVRAM; Usable with DiskOnChip2000™ read/write flash SSD device (only one socket usable with DiskOnChip)

CONFIG EEPROM

512 bits available for OEM use

Counter Timer

3 programmable counter/timers (8254 equivalent)

CPU

AMD 486DX4/DX5, 66 or 100/133 MHz

Data Rate

10Base2 (thin coax), via external MAU connected to AUI interface; 10M bits/sec

Dimensions

5.75 x 8.0 x 1.2 in. (146 x 203 x 30 mm)

Display Controller

Supports CRT, LCD, and EL displays; C&T 65545

DMA Internal

15 interrupt channels (8259 equivalent); 7 DMA channels (8237 equivalent)

Extended Operating Temperature

–40° to +85° C (available by special order); Note-additional airflow or heatsinking required to maintain 85° C maximum CPU case temperature.

Fast IDE

Supports 1 or 2 drives; Supports “fast” IDE data transfer modes, up to PIO mode 4

Flat Panel

Supports 24-bit “true color” (640 x 480); “GUI accelerator” for enhanced graphic function performance; Software programmable flat panel interface signal timing; Sequenced LCD power to protect display; Supports DPMS-compatible displays; Optional plug-in LCD bias supply - supplies ±15 to ±35 VDC @ 30 mA; voltage level adjusted via onboard or external potentiometer

Floppy Disk Drive

Supports 1 or 2 drives

Keyboard

Standard PC/AT keyboard port; Speaker port with 0.1 watt output

LAN Controller

Complies with IEEE-802.3 (ANSI 8802-3); SMC 9000 series

Media Interface Options

10Base-T (twisted pair), via onboard RJ45 connector; AUI, via onboard header connector; DB15F transition cable available

Memory

Supports up to 64 Mbytes, Fast Page or EDO DRAM; Supports two 72-pin SIMMs (1 bank) with or without parity; Shadow RAM support provides fast system/video BIOS execution

On-board Display RAM

512 K or 1 MByte (soldered)

Operating Temperature

0° to 70° C

Parallel Port

EPP/ECP compatible, bidirectional

Power Fail

Triggers when +5V power drops below +4.7V

Power Requirements

(Please refer to the Ampro Ordering Guide.)

Real Time Clock

Battery backed real-time clock and CMOS setup

Relative Humidity

5% to 95%, non-condensing

Remote Boot ROM

Can be installed in byte-wide SSD socket

SCSI II

Adaptec AIC-6360; Supports SCSI I/II, synchronous or asynchronous transfers

Serial POrt

Four FIFO-buffered serial ports with full handshaking (16550 equivalent); Each channel supports either RS232C (direct connection) or RS485 (via the Ampro RS485 Adapter)

Storage temperature

–55° C to +85° C

Watchdog Timer

Utilizes real time clock alarm function; Timeout triggers NMI or hardware reset

Weight

9.5 oz. (270 gm)