PCM-4825 486 SBC with VGA/LCD and Audio PCM-4825/4825L 486 SBC with VGA/LCD and Audio Startup Manual System memory: One 72-pin SIMM sockets Packing List Packing List Packing List Packing List Packing List (accepts 1/2/4/8/16/32 MB) and supports FPM or EDO DRAM 1 ~ 32 MB Before you begin installing your card, please make Enhanced IDE hard disk drive interface: Supports sure that the following materials have been shipped: up to two IDE (VL-bus) hard disks. BIOS auto- detect and PIO Mode 3 transfer protocol • 1 PCM-4825/4825L all-in-one single board computer Serial ports: One serial RS-232 port, one serial RS-1 start-up manual 232/422/485 port. Two 16550 serial UARTs 1 audio cable (PCM-4825 only) Parallel port: One parallel port, supports SPP/EPP/ 1 3.5" IDE flat cable ECP mode 1 keyboard/mouse cableInfrared port: Shared with COM2. Transfer rate up to 115 Kbps 1 secondary serial port cable (RS-232/422/485) Keyboard/mouse connector: Mini-DIN connector 1 parallel cable supports a standard PC/AT keyboard and a PS/2 mouse1 floppy cable Power management: Supports power saving modes CD-ROM or disks for utility, drivers, and manual (in including Normal/Standby/Suspend modes. APM 1.1 PDF format) compliant If any of these items are missing or damaged, contact your Local-bus Flat Panel/VGA Interface distributor or sales representative immediately. Chipset: C&T 65550 Note: For detailed information on theDisplay memory: 1 MB DRAM PCM-4825/4825L, please refer to the Display type: Supports CRT and flat panel (EL, enclosed CD-ROM or disk (in PDF format). LCD, and gas plasma flat panel) displays. Simultaneous display of CRT and flat panel possible Flat panel display mode: Up to 800 x 600 @ 256 Specifications Specifications Specifications Specifications Specifications colors CRT display mode: Non-interlaced CRT monitors resolutions up to 1280 x 1024 @16 colors Standard SBC Functions CPU: Embedded AMD 5x86-133 (DX5-133) Audio Function (PCM-4825 only) processor Chipset: ESS 1868/1869 BIOS: Award 128 KB Flash memory Audio controller: 16-bit Sound Blaster Pro Chipset: VIA VT82C496G compatible Stereo sound: Full-duplex, integrated 3D audio Audio interface: Mic in, Line in, CD audio in, Line out, Stereo speaker out For more information on this and other Advantech products, please visit our website at: Mechanical and Environmental http://www.advantech.com Dimension (L x W): 145 mm x 102 mm (5.9" x 4.2") http://www.advantech.com/epc Power supply voltage: +5 V (4.75 ~ 5.25 V) For technical support and service, please visit our support website at: Power requirements: +5 V @ 2 A (typical) http://support.advantech.com Operating temperature: 0 ~ 60° C (32° ~ 140° F) This manual is for the PCM-4825/4825L Rev. A1 orWeight: 0.65 kg (weight of total package) higher. Part No. 2006482501 1st edition Printed in Taiwan Aug. 1999 PCM-4825/4825L Startup Manual 1 Jumper Settings Jumpers and Connectors Jumpers and Connectors Jumpers and Connectors Jumpers and Connectors Jumpers and Connectors ® The board has a number of jumpers that allow you to J2: DOC 2000 address setting configure your system to suit your application. Pins Address 1-2 3-4 5-6 The table below lists the function of each of the board closed closed closed C800 jumpers and connectors: closed closed open CC00 *closed open closed D000 Jumpers closed open open D400 Label Function open closed closed D800 ® J2 DOC 2000 address setting open closed open DC00 J3 LCD power selector open open closed E000 J4 Clear CMOS open open open OFF J5 Audio AMP power selector J7 COM2 selector J3: LCD power Closed pins Voltage Connectors 1-2 3.3 V Label Function *2-3 5 V CN1 Power connector (-5 V, -12 V) CN2 Floppy disk connector J4: Clear CMOS CN3 PC/104 connector Closed pins Result CN4 Parallel port connector 1-2 Clear CMOS CN5 PC/104 connector *2-3 3.6 V battery CN6 Flat panel connector CN7 Hard disk connector J5: Audio AMP power CN8 IR connector (infrared) Closed pins Audio power CN9 COM2 connector CN10 CD audio in connector 1-2 From main power (5 V) CN11 Audio connector *2-3 From 7805CT (5 V) CN12 Power connector (+5 V, +12 V) CN13 COM1 connector J7: COM2 selector CN14 PS/2 keyboard & PS/2 mouse connector Closed pins Result CN15 CRT display connector *1-2 RS-232 J6 Reset switch 3-4 RS-422 5-6 RS-485 *default setting 2 PCM-4825/4825L Startup Manual Locating Jumpers Mechanical Drawing Mechanical Drawing Mechanical Drawing Mechanical Drawing Mechanical Drawing J3 J2 J5 J7 J4 Locating Connectors CN2 CN4 CN7 CN6 CN12 LED CN1 J6 CN15 CN8 CN14 SIMM1 CN11 CN10 CN9 CN13 CN5 CN3 PCM-4825/4825L Startup Manual 3