® ® PCM-3386 Intel Celeron M PCI-104 CPU Module KB/Mouse LCD CF Socket PCI-104 SODIMM socket Features IDE ® ® ®  Intel Pentium M Processor 1.1 GHz/1.4 GHz/1.6 GHz or Celeron M 600 MHz USB ®  Intel 852 GM ICH4 Chipset  Supports 36-bit LVDS (48-bit LVDS optional)/ VGA COM 1/2  Supports six USB 2.0 ports  Supports Embedded Software API and Utility LPT Software APIs: LAN SMBus H/W Monitor Watchdog GPIO System Throttling Backlight On/Off Fan Utility: BIOS flash Monitoring Audio Connector CRT LVDS Power Specifications CPU Intel Celeron M 600 MHz Intel Celeron M 1 GHz Front Side Bus 400 MHz 400 MHz Processor System L2 Cache 512 KB - Chipset Intel 852GM + ICH4 852GM + ICH4 BIOS Award 4-Mbit Award 4-Mbit Technology DDR 200/266 MHz Memory Max. Capacity 1 GB Socket 1 x 200-pin SODIMM SSD CompactFlash Card Type I, Type II (option for Micro Drive) LPT 1 (share with FDD) FDD 1 (share with LPT) RS-232 2 RS-232/422/485 - I/O Interface K/B 1 Mouse 1 USB 6 x USB 2.0 Audio AC97, Line-in, Line-out, Mic-in Mode UDMA 33 EIDE Channel 1 Expansion Slot PCI-104 1 Speed 10/100 Mbps Ethernet Controller Intel 82562EM Interface 1 x RJ-45 by cable Controller Intel 852GM/GMCH VRAM Optimized Shared Memory Architecture up to 64 MB system memory Display LVDS LCD 1 x 36-bit LVDS (1 x 48-bit optional) LCD Panel 16:9 wide screen panel supported Dual Independent Display CRT + LVDS Operating Temperature 0 ~ 60° C (32 ~ 140° F) Environment Operating Humidity 0% ~ 90% relative humidity, non-condensing Power Type ATX Power Supply Voltage +5 V ± 5%, +12 V ± 5% Power Consumption: +5 V @ 2.06 A (Celeron M 600 MHz) Typical (WinXP Idle Mode) Power Power Consumption: +5 V @ 2.16 A (Celeron M 600 MHz) Max, Test in HCT Power Management APM, ACPI Battery Lithium 3 V / 210 mAH Output System reset Watchdog Timer Interval Programmable 1 ~ 255 sec Dimensions (L x W) 108 x 115 mm (4.3" x 4.5") Physical Characteristics Weight 0.279 kg (0.62 lb) (with heat-sink) Embedded Single Board Computers All product specifications are subject to change without notice Last updated : 09-Nov-2009 PCM-3386 Board Diagram Intel Celeron M CPU CRT Connector Intel DDR 852GM SODIMM Chipset LVDS Connector LAN IDE Intel ICH4 PCI-104 connector 6 USB Chipset 2.0 Audio LPC BUS Super BIOS I/O PS2 COM1 COM2 LPT KB/MS Ordering Information L2 PCI-104 Thermal Operating Part No. CPU Chipset CRT LVDS LAN USB2.0 RS-232 LPT CF KB/MS Cache connector Solution Temp. ULV Celeron M PCM-3386F-S0A2E 0 KB 852 GM Yes 36-bit 1 FE 6 2 Yes Yes Yes Yes Passive 0 ~ 60° C 1 GHz Celeron M PCM-3386F-M0A2E 512 KB 852 GM Yes 36-bit 1 FE 6 2 Yes Yes Yes Yes Passive 0 ~ 60° C 600 MHz Packing List Part No. Description Quantity PCM-3386 SBC 1 1703060053 Y -Cable external cable 1 1701440350 IDE 44P/44P/40P cable 35cm 1 1701440504 IDE cable(44pin to 40/44pin) 1 1703200380 Wire ATX power 1 1701100202 Ethernet RJ-45 Conn.conversion cable 1 1700060202 KB / mouse Y-cable 1 1701200220 COM port cable 1 1700000897 USB Cable 26cm 1 1700000898 VGA cable 1 1700000916 LPT port cable 1 1700000918 Audio cable (Line-in, Line-out, Mic-in) 1 Online Download www.advantech.com/products PCI Bus Value-Added Software Services Software API: An interface that defines the ways by which an application program may request services from libraries and/or operating systems. Provides not only the underlying drivers required but also a rich set of user-friendly, intelligent and integrated interfaces, which speeds development, enhances security and offers add-on value for Advantech platforms. It plays the role of catalyst between developer and solution, and makes Advantech embedded platforms easier and simpler to adopt and operate with customer applications. Software APIs Control Monitor General Purpose Input/Output is a flexible parallel interface A watchdog timer (WDT) is a device that performs a specific that allows a variety of custom connections. It allows users operation after a certain period of time if something goes wrong to monitor the level of signal input or set the output status to and the system does not recover on its own. switch on/off a device. Our API also provides Programmable A watchdog timer can be programmed to perform a warm boot GPIO, which allows developers to dynamically set the GPIO (restarting the system) after a certain number of seconds. GPIO Watchdog input or output status. ® SMBus is the System Management Bus defined by Intel Corporation in 1995. It is used in personal computers and servers for low-speed system management communications. The Hardware Monitor (HWM) API is a system health The SMBus API allows a developer to interface a embedded supervision API that inspects certain condition indexes, such as system environment and transfer serial messages using the fan speed, temperature and voltage. Hardware SMBus protocols, allowing multiple simultaneous device SMBus Monitor control. 2 I C is a bi-directional two wire bus that was developed by Philips for use in their televisions in the 1980s. The Hardware Control API allows developers to set the PWM 2 The I C API allows a developer to interface with an embedded (Pulse Width Modulation) value to adjust fan speed or other 2 system environment and transfer serial messages using the I C devices; it can also be used to adjust the LCD brightness. Hardware 2 protocols, allowing multiple simultaneous device control. I C Control Display Power Saving Make use of Intel SpeedStep technology to reduce power power The Brightness Control API allows a developer to interface with consumption. The system will automatically adjust the CPU an embedded device to easily control brightness. Speed depending on system loading. Brightness CPU Speed Control Refers to a series of methods for reducing power consumption in The Backlight API allows a developer to control the backlight computers by lowering the clock frequency. These APIs allow the (screen) on/off in an embedded device. user to lower the clock from 87.5% to 12.5%. System Backlight Throttling Software Utilities The BIOS Flash utility allows customers to update the flash The eSOS is a small OS stored in BIOS ROM. It will boot up in ROM BIOS version, or use it to back up current BIOS by case of a main OS crash. It will diagnose the hardware status, copying it from the flash chip to a file on customers’ disk. The and then send an e-mail to a designated administrator. The BIOS Flash utility also provides a command line version and eSOS also provides remote connection: Telnet server and FTP API for fast implementation into customized applications. server, allowing the administrator to rescue the system. BIOS Flash eSOS The embedded application is the most important property of Flash Lock is a mechanism that binds the board and CF card a system integrator. It contains valuable intellectual property, (SQFlash) together. The user can “Lock” SQFlash via the Flash design knowledge and innovation, but it is easily copied! The Lock function and “Unlock” it via BIOS while booting. A locked Embedded Security ID utility provides reliable security functions SQFlash cannot be read by any card reader or boot from other for customers to secure their application data within embedded platforms without a BIOS with the “Unlock” feature. Embedded Flash Lock BIOS. Security ID The Monitoring utility allows the customer to monitor system health, including voltage, CPU and system temperature and fan speed. These items are important to a device; if critical errors happen and are not solved immediately, permanent damage may be caused. Monitoring Embedded Single Board Computers All product specifications are subject to change without notice Last updated : 09-Nov-2009